Having problems with your Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum ?

On/off switch not working - Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum


Answers :

Please make sure the mounting screws that attach the upper handle to the lower handle are tight. This sets the proper spacing of the switch rod to the switch. If this does not help, you could remove the upper handle and cycle the switch with your finger. If it still does not cycle On/Off, the unit will need serviced.
Repair Help & Product Troubleshooting for Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

On/off switch not working - Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum


Please make sure the mounting screws that attach the upper handle to the lower handle are tight. This sets the proper spacing of the switch rod to the switch. If this does not help, you could remove the upper handle and cycle the switch with your f ... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Wind tunnel supreme will not start - Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum


... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Bare floor switch do not light up are work - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Brush motor does not turn on - Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum


You could check Sears.com and click on parts then type in Model # or Part # this will get you a parts list you can choose from. ... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Vacuum dead I have oreck XLx2 bagged upright - the belt ,plug and cord have been replaced - has been working great - now went to plug it in and it does not work - the light goes on in the on/off switch so power is working but vacuum is dead - any suggestions


If the cord coming from the bottom up to the handle is loose, and is a plug, push it in. If that doesn't help. then could be a problem with the motor. One other thing to check is inside the handle, maybe a wire came loose. ... Oreck XL2200 Bagged Upright Vacuum

I have a hoover windtunnel upright vacuum, It will not shut off and I have to unplug it to do so. If I take apart the upper handle and manually flip the internal switch it works just fine, only when using the external switch on the handle, wont shut off.


This is a common problem with this machine. The switch has too much resistance to be turned on and off with the switch button and rod. If you put in a new switch, ( # 28161075 ), your problem should be fixed. ... Vacuums

Hoover u6425 switch replacement - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Shuts down after a few minutes of work - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Make sure all filters are cleaned sounds like motor overheating... ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Switch on/off not working - Kirby G5 Bagged Upright Vacuum


Need to take it too a kirby service centre to get switch replaced ... Kirby G5 Bagged Upright Vacuum

Does the vaccum have a reset buttin - Hoover U5450-900 Windtunnel Supreme Bagged Upright Vacuum


... Hoover U5450-900 Windtunnel Supreme Bagged Upright Vacuum

Self propel doesn't work - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


The flat belt under the bottom is the most likely cause. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The power button quit working - Hoover U6446-900 WindTunnel Bagged Upright Vacuum


Please click here to see the part diagram for the Hoover Windtunnel Self Propelled model U6446-900\01 ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

Can't expose switch to test it - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Greetings,This is a relatively easy fix for you. What I've done for you is take pictures of this repair on your type of vacuum to make it ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Now that I just fixed my Lux Legacy canister vacuum, I need help on my other Electrolux Regency Series upright! The vacuum works fine but the rotating brush does not work and the brush motor does not turn on. Tried cleaning the brush and hitting hte reset button to no avail. This upright has a triple setting switch and I checked the each of the wires seem to be attached. Tried rotating the brush by hand and it would not budge. Was going to "encourage" the brush to turn with a set of articula


There are a couple rectangular holes on the bottom of the power nozzle, beside the wheels. These have tabs in them that need released with a standard screwdriver. \015\012 ... Vacuums

I have Hoover WindTunnel Air Upright Vacuum - UH70400 just used couple of times. While vacuuming the carpet carpet fringes were rolled up in to brushroll and brushrol stopped working. It means vacuum is not working effectively now. Brushroll indicator is flickering.


... Hoover Vacuums

I have a Eureka Upright vacuum (4800 Series). When I try to start it by turning the switch on, it wont. For few days, I was able to get around this problem by repeatedly turning the switch on and off until it turned on but that does not work any more. Could it be something related to the switch it self or the power cable. My wife mentioned that one of my kids might have pulled the power cable too hard (at the back of the vacuum). Any help to solve this problem will be very much appreciated. Tha


... Eureka Smartvac 4870 Bagged Upright Vacuum

I have an older Hoover Elite Supreme vacuum. When we switched out the bags (using a Type A replacement) the bag inflates and pops the front cover of the vacuum off.


... Hoover Vacuums

Replace motor hoover windtunnel - Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum


... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Hoover windtunnel red light stays on - Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum


... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Windtunnel vacuum brush won't turn - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My lux 7000 has a new bag but when i start to use it with the power unit or without the unit shut's it self off i can reset the lites or the motor if you will by clicking the on off switch 4or 5 times and i'm ready to go again untill you start to work and off it goes you can repeat the switch thing as long as u want, it just won't let u vacuum ,it turn's it self off .I blew it all out but found nothing in it. if u don't try to vacuum it will run as long as u want to listen to it. Can you


Have you replace the afterfilter? It may also cause this if rather dirty. It's located under the tool caddy/air diffuser on the back half of the machine.\015\012Try this: Disconnect hose, turn on vacuum. Does it continue running? If so, pl ... Electrolux Lux 7000 Bagged Canister Vacuum

I have a bissell healthy home vacuum and the roller bar on the base of it is not working. I have checked it for obstructions and it is clear. I have also tried reseating the canister and just about everything I can think of. It's almost like the switch that deterrmines whether or not the vacuum is in the upright position is broken and always says it is upright... any way to fix that? Thanks, Scott Hammersley


... Bissell Vacuums

The switch on our Hoover Windtunnel vacuum cleaner is not working. I have located the replacement part on your website...part#Ho-28161067, I've removed the wires from the switch. Is there any trick to actually removing and replacing the switch itself? It seems to be in there rather tight.


No, follow the directions to replacing the switch and you should be good. if you got the kit then splice the wires and replace them with the wires profied and the wire nuts, you should be good. ... Vacuums

Why does my Dyson Animal Upright Vacuum power light turn red when I tilt it back to vacuum? It will work if I switch it to bare floors and don't need the beater brush.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Drive cable broken on Hoover Windtunnel - Hoover U6446-900 WindTunnel Bagged Upright Vacuum


... Hoover U6446-900 WindTunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1242 seconds