Having problems with your Hoover U5753-900 WindTunnel Bagless Upright Vacuum ?

My hoover upright has no suction, the brushes move but it doesn't pick anything up at all


Answers :

Hi there...\015\012
\015\012I had the same problem. Checked for obstructions, cleaned the filters, etc. \015\012
\015\012 I took out the rubber belt and noticed that it was much more stretched than the newer black belt.  \015\012I replaced it, and it made a 100 percent improvement on the suction.  \015\012
\015\012Your vaccuum should have come with a postcard that allows you to mail in belts for new ones. You'll get two new ones in the mail, and they are free for life.  Just keep mailing in the old broken or stretched out ones.  \015\012
\015\012Hope that works!\015\012
Repair Help & Product Troubleshooting for Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My hoover upright has no suction, the brushes move but it doesn't pick anything up at all


Hi there...\015\012\015\012I had the same problem. Checked for obstructions, cleaned the filters, etc. \015\012\015\012 I took out the rubber belt and noticed that it was&n ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

I HAVE NO SUCTION COMMING FROM THE BOTTOM OF THE CLEANER AND THE BRUSHES DONT TURN DOES NOT PICK UP ANYTHING WHEN ITS UPRIGHT. BUT I DO HAVE SUCTION THROUGH THE HOSE. THANK YOU


Hi there,\015\012\015\012Sorry to hear you're having difficulties with your DC07. If it doesn't seem to be picking up as well as usual, it's possible that there's a blockage in the system, and you may need to give the filter a wash. The easiest way t ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson seems to have lost its suction therefore is not picking up anything yet i have found that when my dyson is standing upright it has a little more suction but nothing like how it use to work. This has only happend in the last 2 weeks. I sanded a floor & though the sander picked up majority of the dust i did use the dyson to pick up the excess and it is since then that my dyson has not been working to its full potential.


Hi there,\015\012\015\012Sorry to hear you're having a problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction I have new belts. Everything is clean. No clogs. When I turn it on it smells like rubber , the brush doesnt spin. Everything seems to be free flowing.. Roller brush isnt stuck on the ends. Took off hose to make sure no clogs anywhere. There is not even suction thru the hose with the handle in upright position.


Generally, the problem is that the belt is not running the brushes.  This is caused by one of the following:\015\012\015\012\015\012beater brush is jammed.  This is either an object stuck in the brush or im ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Have eureka 9734 replaced belt, put back together,brush rotates well but vacuum is not picking up anything, no suction.


It sounds like the machine is clogged. Check the port behind the belt and any and all hoses for obstructions and remove. ... Vacuums

I have a dyson - bought it 3 yrs. ago and the roller brush stoped working - doesnt pick up anything. Can you help? The brush doesn't roll or spin. Where can we take it to be fixed and is it under warrenty? THis


Don't worry it's probably just that the belt has broken or stretched. Your actually supposed to change them yearly. So if its been three years thats probably the case. Here is a link to the belt you need and a manual with instrutions: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Poor suction The actual sweeper seems to work ok, but the hose attachment has some suction but not enough to pick up things I think it should and not enough to make the power brush spin. I've checked everywhere I can for clogs, but I can't see anything. And there doesn't seem to be any way to check to hose itself for clogs. I've cleaned out the container and the filters, but there's still a problem.


Check the inlet down by the brush roll, make sure it is open, if it is then the hose itself must have a clog. If the hose comes off, drop something like a marble in one end and see it it comes out the other end, if it doesn't then you have a clog. ... Dirt Devil M1100009 Reaction Soft Touch Cyclonic Upright Vacuum Cleaner Vacuum

I have an Electrolux LITE upright carpet cleaner - about 15 years old. Suddenly last night when using it, from the normal motor (whooshing) sound, the motor suddenly went very slow and with a slight grinding sound. The brushes are now just turning round very slowly and areobviously not picking up anything. Has the motor gone or is this repairable, or should I just get a new cleaner? I have tried to open the machine from the bottom to see if anything is obviously wrong, but it looks complicated a


... Electrolux Vacuums

I have full suction with the hose and when the brush is off of the vacuum. However, in the vacuuming position, there isn't enough suction to pick anything up. I checked for clogs and cleaned all the filters.


So I have exactly the opposite problem, it sucks in floor mode but the hand held has zero suction. My daughter and i just spent the last hour disassembling and diagnosing and found this: The way the suction tube is configured, you have two places to ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My Kirby vacuum is a G100 upright. It has no suction. It has been cleaned and the bag is empty (new bag). My mother-in-law bought the same kind and hers is doing the same thing. It has no suction and won't pick up anything. Thank you, Rachel Souza - [email protected]


... Kirby Vacuums

Hoover 6446 900 WindTunnel Bagged Upright has little suction at the floor brush but plenty at hose if disconnected. It does not seem that there is anything blocking the inlet at the floor brush.


Check for a clog in the brush hose ... Hoover Tempo Widepath Upright Vacuum - Blue

Hard too push and brush doesnt always move - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


How old is it? Could be the belt is worn and not grabbing. There's an access panel to the belt on one side or the other. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Brushes move but won't pick up anything


Hi there,I'm sorry to hear you're having difficulties with your DC25. If the machine doesn't seem to be picking up as well as usual, and debris seems to be coming back out of the cleaner head, this is likely to be due to a blockage. The filte ... Dyson DC25 Animal Bagless Upright Vacuum

I have an Eureka Enviro Vac, I have replaced the filter, cleaned the hose and it still won't pick anything up. The brush is turning and there is suction in the hose. What else can I check?


... Eureka Vacuums

Motor is running, belt is on and brush is turing fast, however it does not seem to pick-up anything or have any suction ? bag is not full and does not inflate when it's on


... Dirt Devil M086365 Bagged Upright Vacuum

Sucked up a sock now the brush doesnt move - Dyson Ball DC24 Bagless Upright Vacuum


... Dyson Ball DC24 Bagless Upright Vacuum

Hi i have a dyson dc07 it doesn't work in the upright mode. It works with the tools only .... think the brush isn't turning. it's not making any nasty noises just not picking anything up!


Has the belt snapped? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Have a kenmore cannister vaccum, brush is working but it is not picking up anything the suction is not working ?


Remove the hose and clear any obstruction from inside of it. If that does not work check the bag and filter if one is installed ... Vacuums

Brush does not turn. suction with the handheld unit it fine but when used as a floor sweeper it hardly picks up anything


These stick mmachines do not have a tremendous amout of suction at the best of times but if it has a full bag, or full dirt container, or dirty exhaust fiters it will take away from the air flow as well. take a flashlight and look up in to the tube o ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

We have the Eureka EZ Kleen upright. We have suction through the hoses but not the main vacuum. The brush turns fine but the vacume does not **** anything up.


THE HOSE BETWEEN THE DETACHABLE WAND AND THE BRUSH ROLLER AREA MUST BE CLOGGED WITH CARPET FIBERS. CLEAN IT OUT AND IT SHOULD WORK.\015\012\015\012SFC ANDERSON, RICHARD T US ARMY ... Eureka Vacuums

I accidentally sucked up a sock, now the brush doesnt roll, or pick up anything


... Dyson Ball DC24 Bagless Upright Vacuum

Kenmore InteliClean 116.35923502 Two, I believe unrelated, problems. 1) The InteliClean sensor lights stay amber and red even when the machine is in the upright position and the suction line is disconnected from the cleaner head. 2) There is a lot of vibration and noise in the agitator roller housing. I picked a little hair out of the roller brushes but other than that they were clean. Thank you for any suggestion you might offer.


I had the same problem with the amber inteliclean light continually on. I found the problem to be in the plastic housing that connects the suction hose to the back of the upright section. You have to remove three screws and gently pull ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Dyson DC07 bagless upright will not pick up....suction is there when you move the top slider just not coming through anyway else ! have checked filter and all pipes...all clear...what can I do?


... Dyson DC07 Bagless Upright Cyclonic Vacuum

When using dyson in upright possition does not pick up very well. roller is going round. when you press front to begin hoovering carpets the front doesnt seem to drop onto floor low enough. dont think suction pipe is engaging properly !!!!!!.


Hi Peter, I'm sorry to hear you're having difficulties with your DC07. It sounds as if the internal hose may have become twisted - you should be able to resolve this by removing and replacing it as shown in the video below. Please make sure t ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1057 seconds