Having problems with your Hoover U5753-900 WindTunnel Bagless Upright Vacuum ?

Doesn't seem to pick up little articles anymore

\015 Worked fine for the first little bit, I've cleaned it out regularly, is the wind tunnel filter supposed to be spinning ? If so, it's not anymore! Could this be the problem?\015

Answers :

You have to turn the filter, there is a knob on the tank lid that you turn to help clean the filter. If the filter looks pretty clogged, then it needs to be replaced, or cleaned if it is one of the washable ones. You could have a clog in the hose, or down below where the brush roll is the inlet where the dirt first comes in. Is the brush turning? You may need to replace the belt and/or brushroll. Down in the noozle asm, there also is a vale that will open and close depending on the handle position, it may not be working so it seems like no suction when you do the floor.
Repair Help & Product Troubleshooting for Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Doesn't seem to pick up little articles anymore

You have to turn the filter, there is a knob on the tank lid that you turn to help clean the filter. If the filter looks pretty clogged, then it needs to be replaced, or cleaned if it is one of the washable ones. You could have a clog in the hose, ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

My dyson seems to have lost its suction therefore is not picking up anything yet i have found that when my dyson is standing upright it has a little more suction but nothing like how it use to work. This has only happend in the last 2 weeks. I sanded a floor & though the sander picked up majority of the dust i did use the dyson to pick up the excess and it is since then that my dyson has not been working to its full potential.

Hi there,\015\012\015\012Sorry to hear you're having a problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a DC17 animal vacuum and it is not picking up as well as it used to. It misses small particles on the floor. The hand held piece seems to work ok, but otherwise, it seems to not have as much suction. What should I do. It is only a little over a year old.

It could be that you need a new belt. Over time the belt stretches and wears and then it doesn't pick up well. Here is a link to the belt you need.Dyson DC1 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Fantom 500 DX and it seems that it doesn't pick up anything anymore. It looks like machine is working well, but it doen't pick up. I would like to take to the repair guy, but I don't know where to find one. Machine is good, it might need jsu some maintenance. Please advise. I live on Long Island, NY. PLease advise. I changed the belt about 6 months ago, but all other parts are original.

The type of bagless that has sharp turns in the hose and plastic parts are easy to become stopped up. You have to follow the path of the air flow to find the blockage. ... Fantom Vacums FM760 Twister 500DX Bagless Upright Cyclonic Vacuum

It doesnt seem to be picking anything up

Hi,Check the hose...they plug up and then everything stops...Here is a tip that I wrote after having the same issues with my Bissell...Bissell Bagless Upright ... Dirt Devil Featherlite Deluxe Bagged Upright Vacuum

My kirby shampooer doesnt seem to be placing foam on the floor like it should and it's not picking up any at all

Mine did that once and we were missing the filter part on the end of the shampoo hose attachment.fits on the end of the hose. Bought a new one at the Kirby store for cheap. It looks like a filter screen and without it just seems to soak the carpet wi ... Kirby Ultimate G Bagged Upright Vacuum

No dirt is collecting in chamber and doesnt seem to be picking up

The hose is clogged. try sucking the dirt out with another vacuum (backward) If this doesnt work, you will have to disconnedt one or the other or both ends of the hose to remove the clog. this is a simple process.\015\012\015\012thank ... Bissell 6594 PowerForce Bagless Upright Vacuum

When using hose with attachments little or now suction; also is making a funny sound when machine is on and left idle; seems to be working fine when using on carpeting (picking up the cat hair and dust well ---- had to empty it twice in 20 minutes of vacuuming.

Try this link.http://www.youtube.com/watch?v=mwcLnjpn9Tg&feature=related ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My power head doesnt seem to spin the beater brush anymore model 319121903

... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

My Bissell bagless vacuum does not seem to work anymore. It will start to with a suction and then instead of picking up the dirt, it appears to blow the dirt out almost in a cloud of dust and debris from the front.

This is caused by a dirty air filter and/or a blocked vacume hose ( most of the time the blockage is at the bend where the hose enters the floor sweeper area ) ---\015\012remove and tap out and brush the filter ( or use a air compressor to blow ... Bissell 6595 Lift Off Bagless Upright Vacuum

My dyson 07 doesnt **** up when im doing the carpet but the hose works fine? when im vacuming it sucks up very little and the hose part seems to be sucking up air when im doing the carpet? would this mean something is plug??? thanks randy

There is a block in the hose take lower hose of and clean ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Our dyson upright doesn't seem to **** up an particles anymore (still picks up some dust) about 9 years old.

Hi there SmartAlec from NelsonVacuums.com.au here. There are a couple of likely causes first check your washable filter once you remove the inner foam part and hold the whi ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Not picking up all the dirt and hair. The brushes are rotating and it doesnt seem to have a clog

Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

When using dyson in upright possition does not pick up very well. roller is going round. when you press front to begin hoovering carpets the front doesnt seem to drop onto floor low enough. dont think suction pipe is engaging properly !!!!!!.

Hi Peter, I'm sorry to hear you're having difficulties with your DC07. It sounds as if the internal hose may have become twisted - you should be able to resolve this by removing and replacing it as shown in the video below. Please make sure t ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have an old hoover turbopower approx 1986 i think its a U1102, the prob is it doesnt pick up anymore and i wondered if it had some sort of filter on it, ive cleaned all the tubes put new bag on but its still got weak suction, could you make any suggestions, thanks

Theres a tube that come up and emty's into the bag that tube is clogged.take the bag out and get a coat hanger and put a bend in it so the end is round then work it down the tube to push out the clog ... Vacuums

Su2914: loss of suction even when cylinder is empty!! doesnt work correctly when pet attachment is added either, only seemed to work ok for first 4 months then loss of suction, will pick up eventually but quite poorly! Should I take it for a service? Thanks

... Samsung Vacuums

My floormate does not pick up liquid anymore, there seems to be no suction. I took it apart a bit to look inside and the short hose which goes from the intake area to the collecting bin is ripped and open. can this piece be replaced?

Hello,\015\012\015\012yes, the ripped part/piece can be replaced.\015\012\015\012Remove the ripped part from the device, take it to the market and use it as a sample to buy a new one. Fix it back into the device and that's all ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My Bissell BS3920F upright (similar to the 10N6F) has been working wonderfully for the past 3 years but suddenly seems to not pick up dog hair as well as it used to. It has been pulled apart by my husband to ensure nothing is blocking the hoses etc and when running the suction seems to be there. It seems to grab the dog hair and leave it in a straight line directly under the unit without picking it up. I then disconnect the hose and use to hose to pick up the dog hair. This works well but obviou

Check to see if your brush is not worn down, they do wear with age - compare the length of the bristles with a new one. Replace the brush ir there is a significant difference in bristle lengths. Also check the flexible ben ... Bissell Vacuums

I have a Eureka Altima vacuum cleaner that doesn't pick up very well. The suction seems fine but the brush roller doesn't seem to pick up from the top of the carpet. When you lower the height of the vacuum the belt rubs and smells horribly. How can I get the vacuum to pick up better?

That means that you need to replace the belt. Here is the belt you need to replace and the manual which has instructions:Eureka Altima ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I have a Napoleon Pellet stove insert Model NPI40. When the fire burn rate is extremely low it seems to operate normally. However, when I turn the heat up even a little I eventually get a high pitched noise that seems to be coming from the convection blower. Changing the speed of the blower has no effect on the noise level. I cleaned the blower but did not remove it. There was very little dust on it. Cleaning had no effect on the volum or pitch of the noise.

My theory is based upon 1st hand knowledge with a newer EPA compliant freestanding wood burner, with the air-tight and high efficiency ratings.its possible that its just the high rate of air moving through the air chambers , similar to a o ... Kenmore Whispertone 23312 Bagged Canister Vacuum

Vacuum doesnt pick up very well any more

Larry Kessler: Unplug the vacuum and lay it down on the floor upside down on some newspaper. Remove the vacuum head foot plate with a Phillips head screwdriver. Remove the beater bar and belt by pulling straight up on the beater bar. Pull ... Vacuums

The vacumn doesnt very little suction

... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

HI my mothers dyson, doesn't seem to be sucking up fluff that i could pick up, it does seem to pick up but not a lot.

Try cleaning all .............. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have the yellow altima vac. for a while now I can not get the darn thing to pick up properly. Or should i say keep it up.. The vac does seem to be getting everything picked up but as soon as you turn it off, you have a mess under the vac.. I have checked for clogks and can't seem to find any.. I have removed the hose, Nothing there.. And yep have removed the yellow thing inside the trash cup.. Is there anything else you could suggest??

If it smells hot, then there's a strain on the motor no doubt about it. Check the suction channel behind the sole plate and remove all of the hoses to check for a clog. It could well be that there is a clog inside the machine after the dust channel f ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

No Problems with suction on hoses, however brush area it seems to lose powe, and has little suction r

We had a similar problem with ours and had to finally take it to the repair shop. They informed us that we needed to replace our clutch and that you needed to do that every 2-3 years. It cost less than $100 and has been well worth it. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0437 seconds