Having problems with your Hoover U5753-900 WindTunnel Bagless Upright Vacuum ?

Wind tunnel 2 suction

\015 The vacuum is cleaned out, belt is fine, but has bad suction, especially with the hand wand\015

Answers :

Repair Help & Product Troubleshooting for Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No suction My Hoover Wind Tunnel vacuum runs but there is no suction. The last two or three times I used it, it shut itself off after having a burning smell. When I unplug it for the suggested 30 minutes, the motor will run again but no suction. What is wrong?? Should I just buy a nve one? This one is 8 years old.


Sounds like your motor bearings are going bad. This is generally indicated by the motor overheating, and the heat transferring out through the motor pulley, which is where the belt attaches. So, your machine is overheating, melting the belt, and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover 27.0 wind tunnel. The lever to tighten the tunnel. There is a gap of about 1/2 inch after I move the lever over to close. There is no suction on the vacuum as well as the accesserary nozzle.


... Vacuums

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!


I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a Hoover Wind Tunnel Self propelled 12amp. There seems to be very little suction. I have cleaned the hoses and filters but still not much suction. any ideas? thanks.


I have the same problem , and Like the the person who asked the Question ,, there is no Blockage ,, Im thinking maybe these filters have a very short life span ,, and even cleaning theses filters with a brush, etc , may not be enough, and could have ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

No suction on Hoover Wind Tunnel.


Greetings from GoVacuum.com,First this is a common problem on ALL bagless vacuum cleaners. Usually it takes longer then 1 day however. Is there no suction in the suction hose, or is it not suctioning from the floor? ... Vacuums

Lost suction - Hoover Wind Tunnel S3630


You have a clog. The "bag full" indicator is nothing but a vacuum gauge, and impeding the airflow will cause a false indication of a full bag.\015\012Clear your hoses and the air pathways behind the brushroll, and you will be back in business. ... Vacuums

Hoover Wind tunnel supreme, loss of suction


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=40600&thid=562967\015\012Hoover Wind tunnel supreme, loss of suction\015\012posted by bazballfan on May 01, 2008 ... Hoover U5450-900 Windtunnel Supreme Bagged Upright Vacuum

No suction on wind tunnel vaccum cleaner


Your brush might be clogged with hair. while uplugged, flip over the vacum and check to see if there is any hair or string wrapped around the brush... ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

My Hoover Wind Tunnel has no suction, unless I use the hose and wands. It is less than a year old. Where do I take it to get repaired?


Before you take it anywhere, please check the following:\015\012\015\0121- Make sure the belt that runs the beater brush on the bottom has not broken.\015\0122- Be sure the beater brush has not frozen up due to debris. You should be able to mo ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My hoover wind tunnel vaccum has a hepa filter that is supposed to be self cleaning but continues to plug up. it is not easy to get to and takes forever to clean it out so the suction is strong again.


Do you have the SELF-CLEANING, rotating HEPA filter? \015\012\015\012I just fixed my HEPA filter not rotating!! \015\012\015\012It involves taking apart the vacuum HEPA area. All screws are the same size. There are a LOT of ... Hoover U5444-900 5100 Wind Tunnel 15 Inch Wide Hepa Filter Bagged Black VacuumVacuum

Hoover wind tunnel isn't suctioning but seems to be blowing out


Belt brocken. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

On our new carpet (which is not that thick but thicker than the old) I can't set the carpet thickness high enough. The suction really grabs the carpet and bogs down my self-propelled wind-tunnel Hoover. I then have to push down on the handle to tilt the front up. The thickness setting is as high as it will go. Is there some way that I can further adjust this. The machine is about eight years old.


I can help you out only if you will let me know the front width of the machine. Alongwith the height which you wan't to give raise. KIndly give the width and elevation in cms. ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Low suction on hover bagless wind tunnel - Vacuums


Hi there it's SmartAlec from NelsonVacuums.com.au here. 9 times out of 10 the loss of suction on this machine will be due to worn or blocked filters. It is most likely to b ... Vacuums

Hi. I have a Hoover Wind Tunnel Deluxe vacuum, and the rotating brush does not spin any longer, but still has air suction. Cause ? Sincereley, Teresa T. [email protected]


Could use the model number. Most use a belt, if yours does, then you may need to relace the belt, also check the brush roll. ... Vacuums

LOSING SUCTION IT APPEARS WHEN IN UPRIGHT POSITION, ALTHOUGH SUCKING (TO SOME DEGREE) IT THROWS BACK SMALL PIECES TO THE BACK OF THE VACUUM OPNTO THE CARPET BEHIND, AND THE CONTAINER HOLDING THE STUFF ISNT WHIRLING AROUND THE CONTAINER. I WONDER IF THE PASSAGE TO THE WIND TUNNEL IS BLOCKED, AND OF COURSE THAT IS THE PART I CANNOT GET TO, AS IT NEEDS A SPECIAL TOOL TO UNSCREW THE BACK OF THE VACUUM.


Is brushes moving, if so it is clogged , usually takes a star bit to take apart to clean ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Poor suction-need to know how to remove & clean filter under canister of Hoover Wind Tunnel Mach 4.7 Twin Chamber System.


I assume this is a Hoover Bagless, if poor suction, the hose or dirt inlet by the brush roll may have a clog. The filter inside the dirt container may need replacement. Some had a screw to take out to remove the cover for the filter, the one under ... Vacuums

Hoover bagless twin chamber wind tunnel vacuum has lost suction


... Hoover Vacuums

Hoover Wind Tunnel U6433-900


The problem i see the most is that people have the setting on the front of the vacuumfor "floors" not carpet, switch it over and it will start as soon as the handle is released , if not try belts and finally motor burnt out. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover wind tunnel self propelled U6617-960


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=40485&thid=557365\015\012Hoover Windtunnel self propelled U6617-960\015\012Posted by srkelly on Apr 29, 2008\015\01 ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover Wind Tunnel Upright Self-Propelled


Thanks to reddevil6. Sure enough it was the belt. What I did was take off the belt and flipped it over, worked like a charm. Since it was stretched on one side the other side was still ok. Still need a new, but s aved me a trip to the store! ... Vacuums

I installed the Hoover Wind Tunnel Central Vac in my new home. After connecting the wall outlets and successfully turning on the system from the hose control, I discovered there is lots of air flow t


I would recommend checking your wall outlets where the hose plugs in for any type of clog in the tubing. If the vacuum itself ... Vacuums

Wind tunnel hoover


Do you have suction at the hose end, if you do then it may be clogged at the inlet by the brush roll. Is the filter cartridge clean? If it is clogged and air can't pass thru it, then you will have no or low suction. Might also check the belt to ma ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Hoover wind tunnel


Check the hose to make sure it isn't clogged. But if the model number is different then the one above your post, U6437-900, then let me know. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover wind tunnel 12 amps motor 30.0


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0297 seconds