Having problems with your Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum ?

Hoover wind tunnel 12 amps motor 30.0

\015 Hi i would like some help with my hoover wind tunnel vacuum it doesn't run very long seems like it gets hot or something can you please give me some ideas what it could be thank you . is a wind tunnel ultra upright /model u6432-900\015

Answers :

Repair Help & Product Troubleshooting for Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover wind tunnel 12 amps motor 30.0

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

HI, my motorized brush barely turns.It makes a hot rubber smell. I took apart and noticed the spindle the belt turns on discolored from heat. Cleaned it, but still no turning of the brush.The vac is a hoover wind tunnel. As it moved accidentally touched the belt/ spindle and burned my hand a little. Very hot in area. Bright spark from motor noted. Was careful not to touch that part!

That means that the belt is stretched and it is slipping on the motor shaft, that is why it is hot and smells like burning rubber. You need to replace the belt. Here is the correct belt you need: ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Need manual for hoover bagless wind tunnel

... Hoover Vacuums

No suction My Hoover Wind Tunnel vacuum runs but there is no suction. The last two or three times I used it, it shut itself off after having a burning smell. When I unplug it for the suggested 30 minutes, the motor will run again but no suction. What is wrong?? Should I just buy a nve one? This one is 8 years old.

Sounds like your motor bearings are going bad. This is generally indicated by the motor overheating, and the heat transferring out through the motor pulley, which is where the belt attaches. So, your machine is overheating, melting the belt, and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

How to replace motor on a hoover wind tunnel bag type vacuum?

Hi,\015\012 \015\0121. Unplug The vacuum.\015\0122. Put the vacuum on an easily cleaned surface n ... Vacuums

My hoover Wind Tunnel vacuum cleaner's motor spindle keeps overheating. Because of the high temperature, it keeps burning through belts (the big, wide ones). I have taken it in to the vacuum repair shop about three times now, and the problem has never been fixed. Does anyone have any advice on how to fix this or should I just buy a new vacuum?

... Vacuums

My Hoover Wind Tunnel Bagless Pro Pet is making a very loud thudding noise when the belt rotates, belt seems to be intact and in place, what am I missing? Vacuum is less than 6 months old, belt is not worn and motor seems to be fine.

... Vacuums

My Hoover wind tunnel keeps overheating and the red I dictator is on. I have cleaned all filters and checked for clogs....could the motor have dust in it? How do I check?

Okay. I read these posts and decided to take the advice of checking the hose.I had cleaned all filters, checked all hose (as-is) and did belt checks, etc.The indicator was always showing red and it would shut down after about 5 minutes. ... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

Hoover wind tunnel cyclonic with hepa filter just stop working. Model No U5781900. Had this item close to 2 years. Has the motor burnt out? My e-mail address is [email protected]

... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

How to remove and replace the motor on Hoover Wind tunnel?

... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

How do i remove the motor from m hoover wind tunnel uprightvacuum cleaner

... Hoover U8147-900 WindTunnel V2 Bagless Upright Cyclonic Vacuum

Hoover Wind Tunnel does not turn on

That is a pretty good lifespan for a hoover, but its probably the power switch that's bad. Hoover uses a very poor quality switch. It shouldn't cost to much to have it replaced ... Kenmore 33721 Upright Vacuum

Height Adjustment on Hoover Wind Tunnel doesn't seem to do the job.

... Vacuums

Hoover Wind Tunnel U5720-950

Be sure it has a new bag and fillter, or try running it on a clean surface with the door off. if it still has a burn smell and only runs a few seconds the motor is probably bad. expensive and difficult to access. kitty litter has moisture in it and t ... Vacuums

Wind Tunnel vacuum motor won't turn on

The fact that you wiggled the cord and it came on would seem to indicate a defective cord, either at the plug end or at the machine itself. Look again at where the cord enters the vac and at the wall. twist it slightly if you see a thin or collapsed ... Vacuums

Repplacing power cord on Hoover Wind tunnel (not self propelled)

I am thinking that the cord goes in on the back, just below the handle. Remove the handle, then from the front, remove the tool holder(#8), then you can get to where the cord comes in and hooks up.\015\012\015\012 ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Hoover Vacuum Elite (Allergen Filtration) 12 Amp Motor

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=646648\015\012Generic problem for all Vacuums\015\012Hoover Vacuum Elite (Allergen Filtration) 12 Amps...\015\012 ... Vacuums

Hoover Wind Tunnel U6433-900

The problem i see the most is that people have the setting on the front of the vacuumfor "floors" not carpet, switch it over and it will start as soon as the handle is released , if not try belts and finally motor burnt out. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover wind tunnel vacuum cleaner shuts off during use

Check the inlet down by the brush roll to make sure it isn't clogged. If not and the hose isn't clogged, then probably the thermo protector (part #28382093) maybe bad. It is mounted near the motor. Could be motor Part #43576188. But I would suspe ... Hoover U5444-900 5100 Wind Tunnel 15 Inch Wide Hepa Filter Bagged Black VacuumVacuum

Hoover wind tunnel 2 bagless vacuum not working

Place handle in low position and turn cleaner over so bottom side is up.\015\012Remove the 4 screws in bottom plate and lift off.\015\012Look on the left side of the agitator brush. You should see the belt there. Remove agi ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

I have a Hoover u6446-900 wind tunnel. The carpet...

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Repplacing power cord on Hoover Wind tunnel (not self propelled)

HiThis is HARD and you NEED electrical knowledge and IF NOT UP TO IT YOU COULD CAUSE PROBLEMS TO YOUR SELF AND OTHERS.You do not say what the problem is with the cord.If is it damaged then it needs to be replaced with a new one.and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

How do you change the Hoover wind tunnel belts?

If you turn the vacuum over there will be (4) screws that hold on the base cover for the roller brush. Remove the screws and the cover and you can get to the belt(s). You can get replacement belts here: ... Hoover Company Wind Tunnel U53019 Upright Vacuum

Hoover Wind Tunnel bagless- issue with turning on

Have you tried to plug the vaccuum in another outlet that is on another breaker? It could be the vaccuum tripped the breaker. Turn the breaker back on. The manual mentions the thermal protector could have been activated. If this happened it reset ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Hoover Wind tunnel cyclonic is dead. Will not

... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0532 seconds