Having problems with your Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum ?

Freezer not freezing!

\015 Over the past few months the freezer part of my fridge/freezer has reduced its freezing ability. Parts of some drawers freeze, but it is not consistent. I have reset the cooling settings and this has not made a difference. On top of that, parts of the fridge are now so cold they freeze things. Again, not consistent. \015\012I have checked and it doesn't need defrosting.\015\012Any ideas?\015

Answers :

I am sorry, your question is posted in the Vacuum Cleaner section.
Repair Help & Product Troubleshooting for Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a hoover hcf 5176A FRIDGE FREEZER the freezer is not freezing this has happened before and I switched off the power for 24 hrs then the freezer worked but this does not solve the problem now


... Vacuums

Freezer not freezing!


I am sorry, your question is posted in the Vacuum Cleaner section. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Handle of Bosch inteligence Deep Freeze


... Bosch Turbo Jet Bagged Upright Vacuum

After turning on power , brush roller freezes and indicator light turns red


Try turning the roller by hand UNPLUG VACUUM FIRSTit should turn very easy, otherwise it is bindingall uprights have this problem eventuallyhair and fibers get in roller bushing and seizeluckily disassembling is relatively easy, same ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

We have a Krups Vacupack Plus 380 and require freezer bags for it


From the store that sells them or on line. ... Vacuums

I have a lawn sprinkler system that has a main inlet valve that opens when the sprinkler is run. This inlet valve failed after a recent long freeze when water retained in the valve became ice and then expanded. Questions: 1. Can I replace just the plastic parts that broke or do I have to replace the total valve? The valve is made by FEBCO,CA and the following is written on the valve: 4010387; 765-PUB; B 6412 and 150 MWWP. 2. Where can I get the valve or the parts? My zip code is 77479 and I ca


Yes you can, take the piece into home depot they can help with it. usually you can replace the total valve as awhole , its easier to do it this way, and still cost effective :) \015\012\015\012press add a comment in upper right corner if ... Vacuums

Hi Fixya team -- Here's hoping that your refrigerator gurus are as super duper as your TV champs. I have a Genair fridge-freezer with zero power except to its internal light. Otherwise, no fans working, no noise, no nuttin'. It's a JSD2789GES. Please aim me at the 3 likeliest suspect parts fast because I must visit the owner and fix tonight if possible. Many Thanks, Gramps. PW: renthelp BDCD928E


Hello,These are the parts that might be faulty.\015\012\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015 ... Vacuums

I'm looking for instructions for. The Kenmore Seal-n-Save Deluxe. It is model 69019. The machine is in excellent (looks never used condition and I have boxes of the bags.) I just can't find the instruction book and my attempts to use it don't work. So my question is simply where can I find the instructions or instruction book. I have food I'd like to freeze. Thanks in advance.


... Kenmore Vacuums

Recently our Vitapur water cooler has not been dispensing water. The problem is the water is freezing in the upper reservoir. We have tried unplugging the unit overnight & turning it back on at the minimum cold setting several times which has not worked. We have also used the Vitapur cleaning kit to clean the unit, which also did not help.


The problem is a comon one and simple. You just need to replace the themostat.\015\012Good luck ... Vacuums

I am looking for a specific part for a Nostalgia Electrics RIC-100 portable ice maker and I am finding it very hard to find what I am looking for if I could get some help that would be great. The part I am looking for is the the tray that the ice maker puts the water into and holds to freeze the water to make the ice before it is dumped into the holding tray for the rest of the ice


... Vacuums

Mr. Freeze Portable Ice maker manual - Vacuums


... Vacuums

Mr. Freeze Ice maker Model MIM-88 - Vacuums


I TOO AM LOOKING FOR THE SYNCHRONOUS MOTOR #50TYZ-E-1. i DECIDED TO DRILL OUT OLD PIN & USE SS COTTER PIN. ... Vacuums

I have a proline pl105db freezer,it is on but the red light is on it as defrosted on its own


... Vacuums

I have a 5 yr old Ariens snowblower ( model # 924124). I am having a problem with the deflector cable freezing. I had the deflector cable replaced a yr or 2 ago. I took the cable off and brought it in the house to thaw. When I reinstalled the cable, it worked ine except the shute does not operate in its full range of motion. I have the cable EXACTLY in its original position and routing. The shute only closes about half way. I cannot get the shute to close any lower. Any suggestions?


... Vacuums

My Janome Harmony 8100 will occasionally stop and give me a System Error #1 - I cannot find anything about this error. It is a computerized machine with 70 stiches and attachable embroidery hoop. I first started getting this error with the hoop and now get it when I am just sewing. As soon as the needle goes down to the bobbin, I get the error. The machine freezes and the only way to get rid of the error is to turn the machine off. Sometimes I can get the machine going again, but now it wil


... Vacuums

My TDK Clock Radio for iPhone & iPod (ADS-6P) freezes when I use the power button for the radio feature or try to set the alarm using the radio. Also using the ipod or iphone dock doesn't work. I have no idea what has caused the issue. Turning it off and on again doesn't help - it is still completely frozen and unresponsive to buttons pushed on the applicance one it has frozen. Can you help? I was given this item as a gift so I do not have the reciept.


... Vacuums

Philips FC9222 Vacuum Cleaner freezes when plugged in


... Vacuums

Electrolux Manuals ena38938x freezer alarm going off


... Vacuums

Agitator 'freezes', thus burning through the belt by the belt turning rod.


It will be the bearings at end of brushbar seized up and need replaceing ... Fantom Vacums FM740 Twister 300SE Bagless Upright Vacuum

HOW DO I GET TO THE MOTOR TO CLEAN AND LUB IT SO IT WONT FREEZE UP


First clean it up with some WD-40 and then lub it with some light weight motor or sewing machine oil...\012\012heatman101 ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

The nut on the seperator on my e series is frozen on , how do I get it off and can I use the e2 series seperator on an e series. Aparently the e series nut and seperator had to be take off more often or it freezes on...I bought a used one that's stuck and It works but I can get the seperator off to clean.


Do you have a friend who is a car or motorcycle mechanic? The acorn nut you refer to can be removed with the use of a small air impact wrench. Make sure the wrench is set to REMOVE (anti clockwise) the nut and give it a short burst. Never fails. ... Rainbow E series Canister Wet/Dry Vacuum

Do the roller brushes freeze up? - Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum


Bissell rollerbrushes do tend to freeze up. They usually create so much friction to the endcaps and bearings that the ends melt and the brushroll freezes. you should always look for a vacuum which has a metal roller brush they will last alot longer, ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Our C713 machines are freezing up. They are brand new. We have already cleaned, sanitized and brushed the machines. How do we adjust the thermostat?


Wwwwwwwwwwwwwwwwwwwwwwww ... Vacuums

Power Consumption Refridgerators


I have a 10KW stik welder/generator. I have no problem running a large freezer and 2 fridges except for the startup current draw. I have a $300 transfer switch connected to a 60amp sub panel with current meters on each leg. I have to watch the curre ... Vacuums

Need powerheads for sportland GV1/2Z expantion valve


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0164 seconds