Having problems with your Hoover UH70210 Bagless Upright Vacuum ?

Hoover UH70210 is overheating and has poor suction

\015 We ran the vacuum for a little while with some clogs in the hose. All clogs should be gone, though there may be a small amount remaining between the entrance behind the brush and the hose coupler. I cleaned all the clogs I could find, washed the rinsible filter. I'm not sure what else I can do. Any advice would be welcome.\015

Answers :

Repair Help & Product Troubleshooting for Hoover UH70210 Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover UH70210 is overheating and has poor suction


... Hoover UH70210 Bagless Upright Vacuum

Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?


This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums

Hoover Portapower hose won't stay on, when it does poor suction.


In reply to the problem you have about the hose not staying attached very well, we had this problem years ago with one of our old cylinder vacs. Sometimes after several years of the hose connector being rotated to attach/remove it from the machine, t ... Hoover Portapower C2094 Bagged Canister Vacuum

Hi the suction on my dyson hoover has gone very poor. I have cleaned all filters but suction is still pretty poor.Is there anything else i can do?


Yes there is; \015\012Remove the base plate that surrounds your beater bar. There are three large flathead screws on the bottom. Turn these, and rotate the base plate up and towards the fromt (it hinges at the front). Remove the beater bar ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Hoover Tempo Widepath 12 AMP, poor pick-up and suction. Fantastic suction at the attachment hose though.


Could be blockage in hose,, try straightening out the hose,,and shove a broom handle down there,,,,if there is no bend!! and clear the blockage out. ... Vacuums

Hoover agility--poor suction, still!


When you remove the dirty water tank, on the machine, there is a screen that gets clogged and will prevent good suction, is this one clean? If it is, do you feel suction at that screen, if so then there is a problem with the tank. If no suction the ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Hoover U5468-900 WindTunnel Supreme suction is suddenly poor


The other possibility is there is a blockage in the foot. these models have dual channel air flow (windtunnel) and become blocked when not cleaned depending on use. under the roller there is a cavity that can be removed for cleaning. a hot motor can ... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Poor suction - Hoover Elite Rewind Pet Bagless Upright, UH71003


... Hoover Elite Rewind Pet Bagless Upright, UH71003

Hoover has poor suction - Vacuums


Do you have a clog in the hose or where the hose meets the internal parts of the Hoover? Also, have you bothered to change the bag. My husband doesn't think of changing bags or filters. Hoover is a good product. ... Vacuums

Poor suction-need to know how to remove & clean filter under canister of Hoover Wind Tunnel Mach 4.7 Twin Chamber System.


I assume this is a Hoover Bagless, if poor suction, the hose or dirt inlet by the brush roll may have a clog. The filter inside the dirt container may need replacement. Some had a screw to take out to remove the cover for the filter, the one under ... Vacuums

Well the hoover seems to be sucking in very poorly and nothing off the floor is being sucked up. how can i make it stronger suction?


U need to make sure that the dust collector is empty and any filters fitted are clean and check the hoover belt if fitted is working ... Vacuums

My Hoover is picking dust , very poorly


The Telios has a bad design on the handle and it sounds like something has definately got stuck. Unfortunately the nature of the cheap European design means the handle can only be removed by someone who owns a vice in their garage without breaking th ... Hoover S3330 / S3332 Straight Suction Telios Bagged Canister Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

No Suction I have a dc18 dyson and it had lost suction from the main hoover and the hose part. If you remove the dust collection part there is suction from the hole behind that part. I have cleaned all part to this hoover but the problem is still there. Any help would be apprieciated. Thanks


Filter removal step 1Turn power off and unplug the machine.\015\012\015\012To remove the washable filter: Rem ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Hoover Deluxe Elite Rewind Losing Suction


... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Hoover uh70210 very loud - Hoover UH70210 Bagless Upright Vacuum


... Hoover UH70210 Bagless Upright Vacuum

Poor suction (new bag, clean filter, clear hose)


Check the impeller on the moter it may be missing a fin or two (question does it make any unusual noise or vibration ?) ... Vacuums

Poor suction orange lights come on indicating container is full when it's not and vacuum has very poor suction


... Bissell 66T61 Opticlean Cyclonic Bagless Canister Vacuum

Low suction hoover guv L2310


... Hoover L2310 GUV Central System Vacuum

Hoover suction The suction on my cat and dog hoover is not as good as it should be. Any ideas?


I had a fur ball stuck in the pipe.  I took the end off and used a broom stick to clear it out. ... Miele Cat & Dog 326i Bagged Canister Vacuum

Overheating Hoover My Hoover cyclonic 1800w keeps overheating and turning itself off, not sure if it's the filter, I've cleaned it but it didn't look very dirty.


Most likely caused by a lack of airflow. Check to see if you have airflow at the end of the hose. If not, Remove all of the hoses and ensure that they are not clogged. If there is airflow through the hose; check the air inlet immediately aft of the b ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Recently purchase SC-N500 vacuum cleaner. Worked well only the first 2 times I used it to clean up plaster dust from floor after sanding. Since then it has not worked at all well wiht very poor suction. Fluff gets stuck in the hose and has to be manually removed. Suction power is very poor. I have washed the filter to remove the dust with no difference. Who do I contact in Brisbane to service or assess the problem further.


... Sanyo Vacuums

Poor suction...continued Wow, thanks for answering so quickly! To answer your question, yes, there is suction at the screen, but it is very weak. I keep that screen clean. As a side note, I noticed that when I remove the top clear plastic cover (that would be part # 37 on the diagram, as far as I can tell) there is decent suction coming from the intake there--part 36? 30? it's hard to tell. But with the cover on, I feel no suction (from where it sucks up the water directly from the carpet),


Wish I had it in my shop, it is hard to figure your problem. I do know that you must have something out of place and you may have to take it apart to find it. You may feel some suction there at the top of the clear nozzle, but maybe it isn't strong ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

My Miele vacuum cleaner has the red triangle light on and keeps switching on and off. Is it broken? have been hoovering upstairs and I noticed the hoover had the red triangle light on. I changed the hoover bag but it still kept going on and off. Is this an overheating problem or is the hoover on the way out?


... Miele Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0699 seconds