Having problems with your Hoover V1 SteamVac SpinScrub Vacuum ?

Hoover Steamvac Spinscrub won't pick up water - is it filter

\015 Won't pick up water - can feel suction with bottom unscrewed - is it an internal filter - bottom of unit says squeeze sides and pull and clean filter - where???\015

Answers :

Repair Help & Product Troubleshooting for Hoover V1 SteamVac SpinScrub Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Steamvac Spinscrub won't pick up water - is it filter


... Hoover V1 SteamVac SpinScrub Vacuum

My hoover steamvac spinscrub wont **** up water


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT BEN ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Hoover steamvac that will not spray or pick up water. Earlier it worked fine, but stopped.... I ensured it was assembled correctly and checked the filter in the lid to ensure there was no debris....what more can I do??


I re-checked all my steps, the lid looked like it was on securely, but wasn't. I re-attached the lid correctly and had no further problems. ... Vacuums

Won't pick up the water while cleaning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Please check two three things:\015\012(1) Is the lid on the recovery tank aligned to the tank at rope seal of lid?\015\012(2) Is the rectangular panel in place in the front of the recovery tank, that connects the clear nozzle to the tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It doesn't seem to be picking up the water? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Its not sucking any of the water up ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

IT WILL NOT PICK UP WATER - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common reason for this is that the lid is not fully seated on the dirty water tank. Be sure to hook the lid in front, and then snap it in place at the rear. Another problem could be that the duct is missing from the front of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

My steamvac wont pick up the water. it is spinning and blowing out the water, but it wont **** it back in


The most common reason for lack of pick-up is that the lid is not seated firmly on the recovery tank. Lack of pick up is always caused by an air leak. A less common possibility is that the large round rubber seal that the recovery tank sits on has fa ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover spinscrub The used water tank on my Hoover steamvac spinscrub is empty but the ball keeps popping up as soon as I begin to try to use it. What's the problem?


... Vacuums

My hoover steamvac wont **** up dirty water float


This will also happen if the recovery tank lid is not securely latched or the lid gasket is bad and is leaking air. No vacuum, and the tank overflow ball snaps into place. I had a tank lid latch fail, and the symptoms you report were identical. ... Hoover F7431-900 SteamVac Vacuum

HOOVER SPINSCRUB WONT SUCK UP WATER...BLOWING AIR OUT


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. \015\0121. TAKE LID OFF OF DWT\015\0122. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS PO ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit......it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can't get the basic unit to work, I


Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has be ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover maxextract 77 wont suck up the water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes wont turn and wont spray water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover spin scrub not giving water out - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam cleaner trigger wont work - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover carpet cleaner not picking up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Spinscrub F 7412-900 brushes wont turn - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Steamvac Widepath will NOT pickup the water after dispensing. I checked the hose inside the cleaner, there was a cut in the hose so I put electrical tape and completely sealed the cut. Still will NOT pick up water. I can't find any other problems with the hose. Any suggestions?


HelloHere are some suggestions you might want to follow to solve this problemFirst double check if there are other cuts in the hose or any sort of blockage or clogging in the hose and be sure to remove any form of debris ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

Hoover steamvac not picking up water


You don't have the recovery tank lid on correctly. ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

My hoover steam vac spinscrub f5915100 wont despence water


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover steamvac maxextract 60 wont spray clean water


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

My Hoover SteamVac F5915-900 will not pick up water. I've taken the resavor off several times trying to make sure nothing is under it's lid and replaced it as instructed. I don't know wh


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT BEN ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Agitator brushes wont turn - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0749 seconds