Having problems with your Hoover Vacuums ?

Brush roll won't turn dirt devil 85845

\015 Strong smell of burnt rubber\015

Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dirt devil plat.force brush roller wont roll on carpet

... Dirt Devil M091200 Platinum Force Upright Vacuum

M1300 i dirt devil brushes wont roll

The brush roller itself has crud jammed in it. it is not the belt. the smell however - is the belt being burnt as the small metal axle tries to turn the who unit - but the belt wont move - so the small axle spins and burns into the belt. this can bur ... Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

My Dirt Devil Model 088520 has a brush assembly that wont spin. How can I either change the bearing or free it up somehow? I have been searching for a new brush assembly part number 2860145000 but it

Try this link > http://dirtdevil.com/parts/category/brushrolls-uprights/ ... Dirt Devil Vacuums

I need a new brush bar, The end (plastic) brokeand the brush wont roll!

You can try your local vacuum shop or look online at either eBay or amazon.com. There are also websites like govacuum.com or vacpartswarehouse.com Here is a link: ... Dyson Ball DC24 Bagless Upright Vacuum

Disassemble dirt devil brush roll - Dirt Devil UD40285 Breeze Bagless Upright Vacuum Cleaner, 12 Amp Motor, Stretch Hose,Bright Headlight,Microfresh Filtration,13" Cleaning Path,25 Cord

... Dirt Devil UD40285 Breeze Bagless Upright Vacuum Cleaner, 12 Amp Motor, Stretch Hose,Bright Headlight,Microfresh Filtration,13" Cleaning Path,25 Cord

The beater brush wont spin because the brush roll is always in the off position. Moving the carpet/hard switch doesn't turn it on.

Hello : \015\012\015\012Try this please : \015\012\015\012 Switch the carpet/bare floor dial back & forth 5 times, ending on carpet. Tilt the handle back as if to vacuum upright & lay the vacuum on its side so it is resting ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My dyson wont turn the brush roll back on

Hi there,I'm sorry to hear you're having difficulty with your DC18. You may need to reset the brush bar motor - this is simple to do, so please follow the steps shown in our online Support guide: ... Dyson Vacuums

Brush roll wont turn

Might be that the the idler wheel is stuck and not engaging the V belt. If you look down just past the V belt you will see a black roller, it needs to be against the belt. It is either stuck or the asm. is broken. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Brush roll won't turn dirt devil 85845

... Hoover Vacuums


Hi There, Ok so I have made a few videos about what to check when you have issues like this. THere are 3 possible causes. 1. THe bearings in the brush roller are worn so even though you can turn it by hand the belt cannot.2. The clutc ... Dyson DC07 Bagless Upright Cyclonic Vacuum


... Dirt Devil Featherlight Bagless Upright Vacuum

My brush roll is not moving - Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Check your belt or bearings. ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Vacuum brush roller wont turn - Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

You dont say if you checked if the belt is still whole so my guess is the belt broke(it could've fallen off and not be there at all but you definately need a belt) check that and let us know ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Brush wont roll - Eureka Smartvac 4870 Bagged Upright Vacuum

Check the belt it may have come off or broke this link is for the manualhttp://ec1.images-amazon.com/media/i3d/01/A/man-migrate/MANUAL000072931.p ... Eureka Smartvac 4870 Bagged Upright Vacuum

Hoover windtunnel U6425-900 the brush roll is not turning. Both belts are in good shape, I cleaned the brush roll and it is free of debris, the setting is on carpet and the brush roll still will not turn. There is a "burning rubber" smell when you attempt to push the vaacum forward a few times. The small belt does not seem to be pulling properly but appears to be in good shape.

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Brush rolls of my Euro-Pro Shark vacuum (model-UV 210CN) are stuck; the brush is unable to roll. Does that mean I have to the roll on one end or the whole brush unit? I live in Canada and if possible let me know where I can find a store. Thank you.

... Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum

Hoover windtunnel u6476-910. Brush does not roll. Flat belt and other belt are good. The other thicker belt (called V belt?) does not have tension with the brush roll. How do I make sure it is engaged? Is there a fix? Settings are in "Carpet", "Roll-on", etc. Cleand all hair and bags/filters already.

These machines had a defective switch and a bulletin was sent out to all service depots. If you contact any Hoover Warranty Depot, they will replace the switch, wiring harness and tool receiver under a no-charge warranty. It doesn't matter how old it ... Vacuums

Hoover Bagless Hello,      My Hoover bag less (Model U5280-900) is not picking up dirt like it should.  The brush roll is spinning fine, but the bristles on it are only about one quarter inch long.  I am wondering how long they should be.  The vacuum is quite a few years old.  Do you think it is time to replace the brush roll.  Could you email me at [email protected] about this topic.  The product bar below did not contain my model no.  The correct model no. is above in my message.  Thanks

If the belt is more than six months old then change it even if it is not broken. then replace your filters if that doesnt work than check the hoses for a clog drop a marble down them and make sure it comes out. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Brushes aren't rolling

Yes it does have a belt, easy fix ... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

How is the V-belt tension adjusted (Hoover Model U6439-900)or how do I know if the tension is correct? There seems to be a lot of "play" in the belt and I'm wondering if that is the reason the brush roll only turns as the wheels turn, regardless of the carpet height setting. And yes, the brush roll is set for carpet, not hard floor. Or is the cause of the problem something other than the V-belt? A new flat belt was installed when the machine was professionally serviced so I assume (?) that was a

The V-Belt is not adjustable. There are two ways the belt has no tension: (1) when the handle is upright, a mechanical lever takes the drive tension off the belt, and (2) the brush roll lever setting you described. The upper handle would have to be ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

We have the Bissell Lift off Revolution vacuum. The brush roll and belt are broken. The brush roll has seized up and no longer spins which caused the belt to burn out. How much is a replacement part cost? Debie [email protected]

You can get the belts for that model here: http://vacbelts.xps.convina.com/bissell-style-8-belt.htmThey are only 4.99 for a 2 pack. Plus they ... Vacuums

Brushes stop rolling when against carpet, yes it is out of the upright position and when I left the base off the carpet the brushes start to roll again. What is wrong?

Your belt is stretched out so it just stops when the carpet resists it. Get a new belt made for your particular machine and you should be back up and running ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Brush roll belt stops turning when in position to vacuum. Does turn when vacuum is turned onto side. Belt is in tact, brush roll is fine. What's going on?

I think I know what the problem is with your machine. It's a rather lengthy repair, and I'll be happy to photograph it for you (like I do on most of my Fixya answers), but I'd like to know before doing all of that if you still need help, or if you' ... Eureka Smartvac 4870 Bagged Upright Vacuum

Brush roll i am trying to find and purchase a new brush roll for my ge vacuum. The number on it says that it is 106585 and from what I can tell that is the same as 5550 parts. Is that correct?Thank you

I have the same vacuum for the last 5 years.  I dont know if its the same as 5550 (I assume it isn't) but I can give you the part number 61445-1.  It costs around $16 and you can call 1-877-207-0923 b/w 7 am and 8 pm Mon-Fri central time, o ... GE 106585 Upright Vacuum

Brush roll won't turn on for the shark NV22L vacuum. the light on the brush roll is dark, not red or green

Atthe bottom of the vacuuam are screws to take off...two of them are near the rear wheel assembly....two of them are behind the front mini wheels (just pry the front mini wheels so that they pop out...they pop back in)Remove all of the screws. Re ... Shark Helmet NV22L Shark Navigator Upright Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0472 seconds