Having problems with your Hoover Vacuums ?

Hoover HCV 280 multi cyclonic filter block

\015 HEPA filter seems blocked\015

Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover HCV 280 multi cyclonic filter block


... Hoover Vacuums

My vax power 8, 2200 watts 300 air watts 4L capacity upright Hoover is brand new, I emptied out the dust/dirt collecter and cleaned the motor filter yesterday for the first time, i switched it on and all fine, the brush is spinning and the hose is sucking, put the Hoover to work it's fine for about 30 seconds then then suction stops and its dead it won't collect no more, so switched off taken apart again and the motor filter is blocked and full of dust, so I unblocked it, do the same process aga


I had the same problem. It looks like the seal on the lid on the bottom of the cylinder has fallen out when it was emptied. There is no longer a proper vacuum being created so you don't get the cyclone effect and the dirt doesn't collect where its su ... Vacuums

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

Disassemble hoover sh40060 multi cyclonic - Hoover SH40060 Bagless Canister Vacuum


... Hoover SH40060 Bagless Canister Vacuum

Hoover remedy overheating - Hoover Remedy Multi-Cyclonic Upright Vacuum, UH70604


... Hoover Remedy Multi-Cyclonic Upright Vacuum, UH70604

My Hoover vac, cyclone u5180-910w, has dog smell in the filter assy. Hoover does not have a manual nor solution nor do they offer a replacement part. Is this faulty design/negligence or do they really


... Vacuums

Overheating Hoover My Hoover cyclonic 1800w keeps overheating and turning itself off, not sure if it's the filter, I've cleaned it but it didn't look very dirty.


Most likely caused by a lack of airflow. Check to see if you have airflow at the end of the hose. If not, Remove all of the hoses and ensure that they are not clogged. If there is airflow through the hose; check the air inlet immediately aft of the b ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

I have bought a HOOvER freespace 2000W cyclonic vacuum cleaner but it runs VERY HOT and I am wondering if this is the usual running temperature. I have cleaned the air intake filter and removeed the e


... Vacuums

Hoover cylinder dust manager cyclonic cleaner, replacing dust filters


... Vacuums

I want to order replacement parts for a hoover core 5 multi-chamber cyclonic vac


... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

HOW TO EMPTY FILTER - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


Here is the manual > http://hoover.com/file/445/ enjoy ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

I vacummed some sheetrock duct up with my hoover elite cyclonic.. i dumped the canister to empty the dirt and dust, but now theres not as much suction... is there any other area I should be cleaning... or can i submerse the plastic filter part in water?


Do not put the filter in water, it will ruin it. if banging out the filter did not work than you should probably replace it, sheet rock dust is very fine and will easily clog most filters. ... Vacuums

Where can I get a filter canister door - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Hoover UH70600 Windtunnel Max Multi-Cyclonic Bagless Upright Vacuum Brush won't turn after cleaning out debris, belt is fine.


... Hoover UH70600 Windtunnel Max Multi-Cyclonic Bagless Upright Vacuum, 7 Floor Settings, 15 Inch Cleaning Path, 28 Foot Cord Rewind, On Board Tools

I am trying to find out a part number for a rubber gasket that goes on the inside of a Hoover Windtunnel Cyclonic Platinum BAgless upright. It is a very thin, light-weight gasket made of rubber that helps seal the filtering tubes. If you know where I can find a parts break down, please advise,,, JON [email protected]


Hi There,\015\012\015\012I'm not sure exactly which part you are asking about, so I went ahead and uploaded the parts schematic of your vacuum cleaner, that will diagram all the parts, and part numbers.\015\012\015\012If you n ... Hoover UH70015 Bagless Upright Cyclonic Vacuum

How do I replace the v-belt in my Hoover Multi Chamber Cyclonic vacuum


Its not the v-belt its the idler pully, ours did the same thing, need to get it warrentied ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have a hoover mach 5 multi-chamber cyclonic vacum cleaner and it keeps getting hot and quitting.it's got a strong smell like something is burned when it gets hot also.


If its giving off that strong smell then the motor is bad. probably caused by not keeping the filters clean. on any bagless machine one has to clean the entire vacuum after almost every use to keep the unit operating correctly ... Vacuums

My Hoover Whisper is flashing the red light that says that the suction is blocked. I have cleaned the sponge filter but it is still flashing red. What should I do now?


Hello. The clog is in the hose or the wand. use a flash light to look in to these parts and you will see a blockage. Use a straightened out wire coat hanger to remove the blockage and you will be up and running once again. ... Vacuums

Hello,We have an Hoover Mach 5 Cyclonic vacuum that has no suction. We have cleaned and checked all hoses, belts & filters. Please help us.


With this model, remove the dust tank, and turn it on, check for suction at the lower intake. If you have suction, install the tank and remove hose, and check for suction there. keep following until youn lose it. Then you problem will be between thos ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

How do i open the top of the filter on a hoover windtunnel cyclonic


Just put in the right access code and go. ... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum

My hoover mach 6 bagless overheats, shuts off for about an 1 hr will run again, all filters are clean, no blocks in hoses, how can i fix this problem


This is telling you that there is poor air flow or a blockage somewhere. To simply check for proper suction, remove the accessory hose to see if there is normal suction, if not then your problem is further in the unit. Troubleshooting from there will ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have the same problem as discussed above. My Hoover Pet Cyclonic upright stops working while using it. The bottom feels hot when this happens. When it first occurred, I emptied the canister and even tried a different plug. It did not turn back on for over an hour. When it did turn back on, it would die again after about 3-5 minutes of use. I don't know what else to try. I have washed the secondary filters, let them air dry and replaced them and this did not help the problem. My friend,


... Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

I don't have a manual. How do I clean/change the hepa filter? I have Hoover windtunnel cyclone model U5780 900l


Greetings,\015\012\015\012Please see the below Instruction manual that has instructions on how to maintain your filter. This should help you;\015\012\015\012 ... Vacuums

Dyson dc05 takes the dirt up the cyclone cone instead of spinning it in the clear cannister and blocks the top filter within a few minutes??


Hi its Darran at Dyson. From your description of the problem, it sounds as though the bin inner is missing. If you remove the bin and cyclone assembly from the machine and then seaprate the two pieces as if you were going to empty it, yo ... Dyson DC05 Bagless Canister Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0590 seconds