Having problems with your Hoover Vacuums ?

Hoover f6211-900 suction problems, tank is not filling up. bottom of vaccum is blowing air out and not sucking are up.


Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover f6211-900 suction problems, tank is not filling up. bottom of vaccum is blowing air out and not sucking are up.


... Hoover Vacuums

Suction Problem I took my unit to my work and used it, when I returned home it wouldn't suck up anything. I took the recovery take out and it has inward suction. Shouldn't that be outward, so it goes into the tank? It also blows out of the bottom by the brushes. I check the filter in the bottom and that is fine. Is it possible that it is somehow reversed the direction of the air flow (rotor running backwards)? I am perplexed. What am I missing?


There is a stand pipe seal where the bucket sits on, and if it isn't there or out of place could cause a suction problem like you said yours is doing. In the picture it is #10. The motor seal may have gone bad and is leaking # 15.\015\012 ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a Dirt Devil Vision and when I put a clean canister back in place the suction at the bottom of the filter clogs up and very rarely go into the canister. Also where the air blows out of the motor, I will get particals that will blow out. I have checked where the belt is and also the suction tube. Do you have any ideas how to fix this problem?


Yes your intake hose is clogged thats the clear hose you can see it on the bottom from the back.disconnect the upper hose from your intake hose and try to push a coat hanger through with the end of the coat hangers end bent till its rounded so you do ... Dirt Devil M086700 Vision Bagless Upright Vacuum

Suction stopped. Roller and belt working-in fine order. Checked hoses have not found any blockage. Blowing out air or sucking so little can't feel it with hand on hose end. Help!


Either a blockage or the main air filter is blocked , some it can be washed and others it must be replaced I would check the owner manual and look at the filter, foam ones can and usually have instructions where they install to wash them. ... Hoover Tempo Widepath Upright Vacuum - Blue

I have a dirt devil ultra vision turbo, it lost suction. took it apart blew it out with the air hose, I think we put the bottom plate on wrong but can't figure out how it goes, it is blowing dirt out but the suction hose works.


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

We have a Wertheim 3180 vaccum that the suction is no longer working. The air is blowing out but no suction coming in.


... Vacuums

I cleaned out my brush in the bottom front, cleaned out the small tubing going into the canister, and the canister itself. I also changed the filter.I snapped everything back into place, but Since then, it doesn't seem to have any suction and there seems to be a space between the canister and the bottom of the vacumm where the canister sits. At that area, you can feel air coming out when trying to vacumm and it just doesn't pick up, it seems to be just blowing stuff around.


You need to really look at it some thing is out of line you shooed not have\015\012any spaces in the top or bottom\015\012pull the canister back out and look at the pins that you lined up with the\015\012to ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My central vaccum cleaner has no suction at all outlets even at the canister. The motor is still working and blowing air out the air release tube. What could be the problem


Check the filter in the tank. If this is dirty, the motor will still run, but there will be little to no suction. Rinse thoroughly under warm water, then allow to thoroughly air dry before replacing into vacuum. \015\012I recommend having tw ... Electrolux Central Vacuum

My dyson dc25 has no suction on the bottom or the wand. It is blowing out hot air from the ball part. Both filters have been cleaned, I have put the bottom part on correctly, any suggestions???


... Dyson DC25 All Floors Bagless Upright Vacuum

HOOVER SPINSCRUB WONT SUCK UP WATER...BLOWING AIR OUT


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. \015\0121. TAKE LID OFF OF DWT\015\0122. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS PO ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The cleaner blows air out of the bottom rather than sucking up the water


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

The vaccum won't pick up the water and there is large amount of air blowing out the bottom like it is bypassing


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My bissell is not sucking,its blowing air out the bottom


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My vaccum is not sucking blowing air out buy the holding tank


... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Hoover steam vac won't suction water. It will with the hand tool, but not the main part. I feel hot air blowing out of the bottom.


... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Its not sucking up the water off the carpet , no suction , it's spraying , the scrubbing brushes are spinning , I can feel air blowing out of the side, I don't know if i usually feel that are not


Hello. Take out your recovery tank, remove the lid, and re-attach lid rolling it from the front to the back, there are two tabs on the tank that the lid has to be aligned with, you will hear it "click" when it is tight. I think this might be the tri ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

MY HOOVER UPRIGHT U4581-910 HAS GOOD SUCTION THROUGH THE ATTACHMENTS BUT LACKS THROUGH THE BOTTOM. THE BAG FILLS WITH AIR, THE BELTS AND BRUSH TURN FINE. WHAT SHOUL I LOOK FOR?


... Hoover Vacuums

Hoover steam vac has no suction, blowing air from middle of bottom


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The vacuum does not **** in dirt. It is blowing air instead. Yet when I disconnect the vacuum from the cannister, the suction seems very strong. I took it to a vacuum repairman, and he said that Kenmore sucks and I might as well get rid of it. (He wanted to sell me another one) It is 10 years old, but if I can fix it I would like to try.


... Kenmore 22613 Bagged Canister Vacuum

My shop vac is blowing air out and not sucking. How do I get it to suction?


Make sure top is sealed up properly also check to see if hose is not plugged in hose or inside vaccum ... Shop Vac Shop-Vac& Mini Hang Up Wet/Dry Vac Vacuum

Hoover steam vac has no suction blowing air from middle of bottom


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Air blows out bottom ,no suction - Bissell 6594 PowerForce Bagless Upright Vacuum


Almost certainly one of the pipes on the machine is blocked. I don't have that model but typically all the parts will come off with embedded plastic clips (like the battery back on the remote control). Take these off and clear them out, also check ... Bissell 6594 PowerForce Bagless Upright Vacuum

I accidentally vac'd over my phone charger...it sucked the cord in only which called the belt to break. Now the vac suction is low and it blows out hot air....Whats wrong?


... Vacuums

Bissell proheat blowing out air instead of sucking in air


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Vaccum has no suction


Here is what we did to fix the problem of our vacuum having no suction.\015\012\015\012We unscrewed the three screws on the back and took the hose off of the vacuum.  Then we took the hose outside and put the water hose through the vacuum ... Kenmore 34923 / 34925 Progressive Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0763 seconds