Having problems with your Hoover Vacuums ?

I can not find a filter # 43613-026 for a Hoover Windtunnel model # U5361-950 Series #M 12.0


Answers :

That filter number may also come up as a "package number."
\015\012
\015\012Try looking for package number 40110008.
\015\012
\015\012This is a commonly stocked item at most vacuum stores.
\015\012
\015\012-R
Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I can not find a filter # 43613-026 for a Hoover Windtunnel model # U5361-950 Series #M 12.0


That filter number may also come up as a "package number."\015\012\015\012Try looking for package number 40110008.\015\012\015\012This is a commonly stocked item at most vacuum stores.\015\012\015\012-R ... Hoover Vacuums

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

Filter I bought this Hoover a few years ago-- just now about to use it first time. I cannot find my user's manual and don't know how to change the filter-- or to clean it or whatever I am supposed to do with it. Also, there is a handle on one side of the unit that seems to be attached to an empty chamber or canister kind of thing. It looks like it should pull out, but it does not budge. I really would like to have a manual, but can't seem to find one. Is there a similar model that is still


This is not for the exact same model, but should help you out:\015\012http://edge.maytag.com/epipubs/56511B47.PDF ... Hoover U8143-900 Upright Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and


The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hoover windtunnel 2. The filter was filthy so I dismantled the whole thing to try and clean the filter. Now I can't put it together again. Also, where can I find a new filter to buy in Orlando, Florida? Has there been a recall on these vacuums? The filter definately is NOT self cleaning?


... Hoover WindTunnel Cyclonic HEPA Bagless Upright Vacuum - Plum

I purchased a hoover windtunnel 2 model#u8361900 in Dec 2007.I am very disappointed because the self cleaning filter is not turning and particles keep clogging in that area. I have manually removed the particles but the filter will not turn.I also haven't been able to use the pet brush for some time.The cleaner has not been used hard about once a week since it was purchased.I am not happy that this product has stopped working effiently since purchased 6 months ago. Thank you Marcia Long Pottstow


The filter stands up right.the bottom goes in first then snap in the top.turn it by hand and you should hear it click if you have it in right ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

Hoover Windtunnel T-Series UH20700 9 mos old. Keeps clogging in hose just above the beater brush assembly. I think it clogs because the suction is too weak to pull much through. Primary filter is clean and HEPA filter is replaced. Even when everything is unclogged, suction is weak compared to another unit (same model) that a friend has. Any ideas?


... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

I am trying to find out a part number for a rubber gasket that goes on the inside of a Hoover Windtunnel Cyclonic Platinum BAgless upright. It is a very thin, light-weight gasket made of rubber that helps seal the filtering tubes. If you know where I can find a parts break down, please advise,,, JON [email protected]


Hi There,\015\012\015\012I'm not sure exactly which part you are asking about, so I went ahead and uploaded the parts schematic of your vacuum cleaner, that will diagram all the parts, and part numbers.\015\012\015\012If you n ... Hoover UH70015 Bagless Upright Cyclonic Vacuum

Hepa filter stopped on Hoover Windtunnel 2 Model #U8361-900


This has a simple solution IF you have a air compressor with a high pressure nozzle. Outside the house, first remove the Dust bin completely and lay the unit down with the dust bin area up. now start blowing the nozzle at the hepa filter, Alot of ... Vacuums

I don't have a manual. How do I clean/change the hepa filter? I have Hoover windtunnel cyclone model U5780 900l


Greetings,\015\012\015\012Please see the below Instruction manual that has instructions on how to maintain your filter. This should help you;\015\012\015\012 ... Vacuums

I have a Hoover Windtunnel Model U573-960, the belt turns the bar still has alot of life on it. I have very little to no suction at the end of attachment hose. I replaced filters and looked for blockagaes with no luck.


... Hoover Vacuums

I have a Hoover windtunnel T series. Model #UH70105. The system check indicator was almost red so I cleaned the filter. There are no clogs and it vacuums fine without the hose, but when I go to use the hose there is very little suction and all the vacuum dust flys out of the end the hose piece fits into when not in use. Can you please tell me what is wrong?


... Hoover Vacuums

Final Filter-Hoover U5399-900 WindTunnel Lite Upright Vacuum


Hi you could try these people who deal with hoover parts their number is 0845 230 6 230\015\012\015\012they are called www.espares.co.uk\015\012\015\012hope this helps if they dont have your part they should be able to get one or direct y ... Hoover U5399-900 WindTunnel Lite Upright Vacuum

Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless


Get over it and buy a new one!!! ... Vacuums

Euro-pro model ep621 Where do I find a replacement filter for this model???? Have tried several places and no luck! Help! Can not use the machine without filter????


I don't know if you tried or if they are for your model. Put in search euro-pro. I saw a bunch on ebay burdfrenzy ... Euro-Pro S3325 Handheld Steam Vacuum

I have a hoover spinscrub carpet cleaner model F7221-900 I need to download a user manual for.But hoover website tells me they can,t find this model number. I have checked # several times and it is correct. whats up?


I just needed to clean the brushes I finally just found the clips on each side of the brush roller and pressed in towards center and was able to pull brushes out. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover Windtunnel model 6626 900 no suction - Hoover U6630-900 WindTunnel Bagless Upright Vacuum


... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

We are unable to find a replacement part that the filter attaches to in the dirt cup on our Eureka Boss Pro Model 411. This part seals the top of the dirt cup and holds the filter in place. What is the part name or model number for the replacement?


I just called Eureka (1-800-282-2886) and asked for the dust cover lid. It was part number 61538-1. They said they could ship it to me or I could call one of the authorized service centers nearby to see if they had one. I wasn't in a hurry and the ... Eureka 411A Upright Vacuum

Hoover dual windtunnel model U8149-900 series Y 12.0


This model has 4 brushes to replace. they are connected by gears\015\012they have a bad habit of stripping so get all 4\015\012after you pull off the bottom plate there will be retainers on the outside ends ... Vacuums

I have an old silver king cannister vaccum (R2-D2 star wars) Im looking for filters. When you take machine apart there is a donut looking filter under motor(top of vaccum) that protects motor. I cant find them anywhere. I found the other filter the model uses (disc filters) HELP!!!


I'LL DO A SEARCH ON LONE BUT THE MODEL NUMBER WOULD HELP ... Vacuums

I need to replace the hepa filter on my Typhoon vacuum cleaner model T4505, however I cannot find a supplier of spare filters. Vacuum no longer picks up efficiently


... Typhoon Vacuums

Belt Stretched on my Hoover Windtunnel Farrington upright model U6431-900


Hi, In order to to replace the V belt the one that turns the brush, One must take off the bigger belt " drive belt" that goes over that hugh wheel towards the back. When a belt gets stretched they will not turn the brush very well. If you have bought ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0795 seconds