Having problems with your Hoover Vacuums ?

Lack of suction to tunnel, bad seal?

\015 Windtunnel PAWS; after emptying canister and replacing, no suction ...model used just twice before problem.\015

Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lack of suction to tunnel, bad seal?

YOU NEED NEW FILLTERS ... Hoover Vacuums

Does not pick up, no vaccum, motor runs, no blockage, should feel suction on hose outlet without hose hook up. Paper filter missing over cloth filter. float overload ball free, seal on section good no leakage. Maybe bad motor but runs.

Here\015\012 is a Link to one of my Tips:www.fixya.com/support/r6311178-vacuum_brush_bar_not_spinningThis\015\012 should solve the problem. ... Minuteman C82906-01 HEPA Vacuum Vacuum

Low suction Have a Powr-Flite PF 18, suction is good at motor, but low at where hose comes out of top of vacuum. Could new lid seals help the problem? Where can I get new seals for this model. Also my zip is 98801 and my shop is not listed, could you add it please? Sew Creative 1139 N. Princeton Wenatchee, Wa 98801 509-663-5516 Thanks, Lauren-Sew Creative

Replacing the motor cover solved the problem, it must have been warped and was letting suction out thru it. ... Vacuums

No suction My Hoover Wind Tunnel vacuum runs but there is no suction. The last two or three times I used it, it shut itself off after having a burning smell. When I unplug it for the suggested 30 minutes, the motor will run again but no suction. What is wrong?? Should I just buy a nve one? This one is 8 years old.

Sounds like your motor bearings are going bad. This is generally indicated by the motor overheating, and the heat transferring out through the motor pulley, which is where the belt attaches. So, your machine is overheating, melting the belt, and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Low suction My old rainbow seized up. I purchased another one on e-bay. It works but it has a broken latch on the side and it has low suction. Even when I press down so it is sealed to the water can it doesn't inprove the suction.

\015\012\015\012\015\012With years of use, you will collect a layer of "micro dust" on the impeller (the fan part) which reduces the efficiency. A toothbrush and some mild cleaner with gently scrubbing will restore it's power. \015\012 ... Rainbow E series Canister Wet/Dry Vacuum

I have a Hoover Wind Tunnel Self propelled 12amp. There seems to be very little suction. I have cleaned the hoses and filters but still not much suction. any ideas? thanks.

I have the same problem , and Like the the person who asked the Question ,, there is no Blockage ,, Im thinking maybe these filters have a very short life span ,, and even cleaning theses filters with a brush, etc , may not be enough, and could have ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

No suction to seal bag - FoodSaver Vac 800 Vacuum-Sealing Kit, White

Is a hose unplugged? Unplug the devise and see if you can find anything that looks like it's not connected OR it has a hole in the hose. ... FoodSaver Vac 800 Vacuum-Sealing Kit, White

My magic blue vacuum has no suction. The lid seems loose and the lack of suction seems to be related to the loose lid. I cannot find a way to tighten the lid.

Have u tightened the dirt cup lid. ... Vacuums

My new vac master pro200/260 does not vacuum, the fan is on but there is no suction, and the machine stops at 2 without suction or seal and then shows error.

... ARY Vacmaster Vacuums

Dyson left slightly, bad suction going forward, strong suction backwards

Check and clean all filters. Check drive belt too. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Why does my dyson dc07 vacuum smell so bad when i use it? I have washed the filter so it is not that problem. The smell is of a dusty variety the suction is fine but I would like to eradicate the bad odour.

... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction the vacuum runs, but there is no suction. I've checked the hose and the foot, there are no clogs there. The canister was pretty badly clogged, but I've unclogged as much of it as I can get to. it doesn't seem to come apart any more. I've cleaned the filter as well

The hose can clog up insid where you cant see it my husband takes it off and runs water thru it to flush stuff out lets it dry then reconnects it ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!

I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover 27.0 wind tunnel. The lever to tighten the tunnel. There is a gap of about 1/2 inch after I move the lever over to close. There is no suction on the vacuum as well as the accesserary nozzle.

... Vacuums

Lost Suction This is my second hoover steamvac and i am having the same problem with my new one as i did with the old one that i tossed out. I have used it about 12 times and it worked great the first 6 times... Now i'll empty a full tank of water and only half will get sucked back up. I have tried taking it apart and cleaning and also the rubber seal had some gaps so i sealed those thinking that it was leaking air from there...can anyone help? I am so close to chucking this one and buying somet

Usually when there is no suction, one cause is the lid to the recovery tank is not on all of the way in the back. Also if you have that foam filter on the underneath side of the recovery tank lid, it needs to have a 1/4 in or so gap from the top of ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My new Kenmoore Powermate 116 canister has poor suction. I have no pets and light dust. Its not picking up small particles on the wood floor with the floor attachment. When I put my hand to the suction it feels weak. Cleared hose and changed bag. Using again, same issues. This should not be happening with a new vacuum. Is it a bad design in the elbow joint of the hose? I want to return this!!!!

First of all disassemble the handle and hose as much as possible and examine the inside. Make sure there is not any significant debris lodged in the hose somewhere like a plastic bag or something.\015\012\015\012Also check at the top of t ... Kenmore 23912 Progressive PowerMate Bagged Canister Vacuum

My DC05 Dyson suction has stopped...there are no blockages, the seals are good, there seems to be more suction coming from a yellow box which is situated at the top of the removable cannister. There is nothing obvious'

My Dyson had exactly the same problem. I found the problem was caused by a blockage in the hose. Take the hose out where it joins the cleaner (it will come out if you pull it downwards gently) and take the hose out of the handle by squeezing the ye ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I cleaned out the hose and removed brush to clean and checked belt. Everything seems to work but will not pick up or suction on carpet. The hose is totally clear from clogs. I can see the floor from one end to the other. What am I missing that might be causing lack of suction?

Hi troupdavid,I see that your Vacuum is having issues with it suction, you mentioned that you took it a part to clean it, see steps below.\015\012\015\012Check if everything is inserted prope ... Hoover Tempo Widepath Upright Vacuum - Blue

No suction on Hoover Wind Tunnel.

Greetings from GoVacuum.com,First this is a common problem on ALL bagless vacuum cleaners. Usually it takes longer then 1 day however. Is there no suction in the suction hose, or is it not suctioning from the floor? ... Vacuums

Lack of suction with panasonic vacuum mc-e3001

... Panasonic Vacuums

Suction weak, vacuum seal spring is releases

I would recommend checking the dyson vacuum brushroll first. If there is any hair or thread wrapped around it you are going to want to cut all of that free ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Noisey DC07 Bagless Upright Cyclonic Vacuum; lack of suction...

The washable filters very seldom wear out, they are sponge, but the prefilter on the housing CERTAINLY wears out. You can fix it here:\015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bad suction on bissell powerforce bagless vacuum

I took the bottom apart and it needed a new belt and that was the problem so it's fixed. ... Bissell 6594 PowerForce Bagless Upright Vacuum

Lack of suction

Do not think its motor .......Yoy need to see thats its not Cloged if so clean....... ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0594 seconds