Having problems with your Hoover Vacuums ?

Hoover Vac UH70015 power button flashes and the vac will rev up and immediately shut down. I had washed the HEPA Filter (with soap and water). Would that cause the vac not to stop? there are NO Obstructions.


Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Vac UH70015 power button flashes and the vac will rev up and immediately shut down. I had washed the HEPA Filter (with soap and water). Would that cause the vac not to stop? there are NO Obstructions.


... Hoover Vacuums

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

HEPA Filter My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash? Filter F27 Dirt Devil Purpose Cleaner for Pets Upright Bagless Vacuum Model #1LY2108-000


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618630&thid=730623\015\012HEPA Filter\015\012Posted by jenski66 on Jul 02, 2008\015\012My vacuum came with a spon ... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

HEPA post-filter on Dyson DC25 doesn't stay secure causing the ball not to roll smoothly. the red button keeps popping causing the filter to pop up enough to cause the ball not to spin freely.


... Dyson Ball HEPA Upright Bagless Vacuum - Iron/Satin Yellow

My Electrolux guardian C135 vac has lost suction. replacing the bag does nothing. removing the HEPA filter has no effect - what do you suggest? Will a replacement HEPA filter make any significant difference?


No you have a clog in the hose, wand or at the power head. Remove the hose wand and power head from the the vacuum. Turn on the vacuum, put the palm of your hand over the hole in front, you should feel plunty of suction. Then replace just the hose an ... Electrolux Guardian Bagged Canister Vacuum

My kenmore cannister vac (model 116.27514) has a slight burning odor after operating for a few minutes. We have removed the hepa filter and it looks like there is a strip of foam curled up behind the hepa filter compartment. Could that be the problem? How do we access that area? Thank you.


... Kenmore 22822 Canister Vacuum

How do I clean the style 8 hepa filter? - Bissell Style 8 Vac Hepa Filter Bagless Upright Vacuum


That filter is not cleanable. needs to be replaced ... Bissell Style 8 Vac Hepa Filter Bagless Upright Vacuum

Our problem with our Rainbow E Series is that it has sucked water up and blown it out through the lower part of the hepa filter, making the filter wet and dirty. This had happened before and the repair shop did not see any problems with the machine, so we replaced the filter and were very carful not to overfill the tank and to change the water often. Now it has happened again and ruined another filter. Do you know what could be causing this issue? Can the filter be cleaned or will a new one be


Thank you for allowing\012us to help, please respond with further questions and concerns\012\012Spanish speaking\012available for all problems\012\012 ... Rainbow E series Canister Wet/Dry Vacuum

How to wash filters for handheld vac


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr


Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I guess i washed the filter - Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum


... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

Shark Navigator Pro Hepa filter exhaust door & filter keeps blowing off when I turn vac on. Was fine before I cleaned it. I've inserted the door multiple times as per manual & won't stay on.


... Vacuums

HEPA Filter has melted on our Dyson DC05 turbo filter? I'm trying to investigate the cause any suggestions as to how to get into the unit?


Throw it away, any time a plastic vacuum gets melted or warped in any way they usually never work the same again, and tend to get worse over time. ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK.


Sounds like a bad motor bearing. If it is, then you would have to replace it. Could be the brush roll, did you check the ends to make sure they turn easily? ... Vacuums

I have a Miele Capricorn canister vac. I have replaced all the filters (hepa as well) and the vac keeps shutting off while in use.


Have the cord reel checked. There could be a short in the cord ... Vacuums

We have two of these vacuums and both of them have experienced the same problems. First the floor heighth adjustment doesn't work and now neither one will pick up on either carpet or floor when in the brush/floor mode. They both seem to work with the suction hose function. We have removed the back panel to see if there was an obstruction but it was clear. We have changed the bag and the small filter (not the HEPA filter) all to no avail. What else can we do? We are desperate to use our vacu


Did you check the powerhead for obstructions? With a bend in the tube just below where the hose connects, this is a common spot for clogs. To check, detach hose and drop a coin in the hole. If it doesn't drop through, a blockage is present. Use t ... Electrolux Oxygen 3 Upright Vacuum Cleaner - EL5035 Vacuum

There is a rubber valve on the top of Dyson DC14 all floors. When the vacum is locked in its upright position or the hand wand is used there is a whistling sound coming out of the valve. When the vac is used as a floor vac, it does not make the sound. Is this something that I can fix? Is there an obstruction somewhere that would be causing this sound? thank you.


The Fixya user in this repair is giving out personal contact information rather then helping the customer out on the Fixya board. This defeats the whole purpose of Fixya if the "TheDysonTeam" just gives out his phone number and helps the customer o ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Replacement filters for Durabrand Canister Vac with HEPA Model# DB9191


The Durabrand filter can be found at http://www.totalvac.com/accessory/parts/H19030.html ... Vacuums

Hover Elite Rewind I've only had this vacuum a few months and I really liked it until now. There is almost no suction from anywhere in the vacuum, and I've cleaned all the filters and rollers with my shop vac and made sure that everything was assembled correctly. It used to be really quiet now it is quite loud and it keeps over heating, and shutting off. At this point I have no idea what could cause this problem, the machine is nearly brand new and I can't afford a new one at this point.


You have to clean out the hose under the bottom of the vacuum cleaner. To do this you have to remove the bottom plate the covers the brush it has about 6 screws. Also remove the brush and belt in order to thourhly clean it. I had the same issue you h ... Vacuums

My vacuum is blowing out instead of sucking in. It's blowing the cover of the hepa filter right off! What is causing this problem and how can it be fixed?


HelloPossible clogged hose.Run a broomstick or long pole through the hose to unclog it.Then check your prefilter should be down by the front light,should be washable.Last... be sure the hepa filter is clean an in the rig ... Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum

Our central vac has no suction. I think the filter may have been damp when I reinstalled it after washing! Have I ruined the motor?


I don't think that you have "ruined" the motor. however, you should go to the unit and take the bucket off of the machine and let the motor underside dry out when your not using the unit. Just keep an ear out for the machine next time you start it up ... Electrolux Central Vacuum

Would a clogged hepa filter cause the vacuum to stop picking up dirt? There's suction on the hose when I checked it.


Generally the Hepa filter is a bypass filter in which there is another filter on the unit. Check to ensure that the belt is allowing the rollers to turn the brush. Just suction on the line won't pick up deep dirt unless you allow to sit in place. ... GE 106585 Upright Vacuum

Shop Vac shuts off after a few seconds of work. Filter is clean and hose not plugged.Seems like a high vacuum causes the unit to shut down. Needs to be turned on again and does the same thing.


... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

My Shop Vac (Brand) Mdl#934-16-11 keeps shutting off while I'm dry vacuuming. I can turn it back on then it will shut off again. The filter is spotless, so that's not the issue. There isn't any reset buttons. The only thing I can think of is that the float for wet vacuuming is somehow being sucked up causing the the motor to be tripped off. The vacuum is only about a year and a half old and used only sparingly. Help!


... Vacuums

Rureka Boss 5857 AZ model. There is no vacuum from the hose, butstrong vac right at the bottom motor. Is the HEPA filter blocked or somewhere else is leaking vacuum?


... Eureka Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0503 seconds