Having problems with your Hoover Vacuums ?

Dust canister stuck

\015 Cannot remove bagless dust canister, seems to be stuck.\015

Answers :

Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dust canister stuck

... Hoover Vacuums

Eureka optima the dust and lint do not fall into the canister it just styas stuck to the filter makes suction not aas good as it should be

The filter probably needs a darn good clean. If it is clean, wipe the inside of the canister with a clean cloth to get rid of static. ... Eureka 431A Optima Bagless Upright Vacuum

Dust collects on outside of canister on Hoover twin chamber bagless cleaner . I have replaced the filter & rubber gasket at bottom of the canister ,checked for blockage.

... Hoover Vacuums

My wand on my canister began to spark and snap and smoke. The element was melting. and now I am stuck with only a working canister. the elememt or electrical hook up is burned up...and I guess I am gonna have to BUY ANOTHER wand or connection??? I don't know what to do... but this is a HUGE dissapointment. The canister still works... but no vacume head.

How's the hose?\015\012If it's only one wand, yes, you'll need to buy a new one. It depends on where it burnt out. If it was at a connection to the hose, the other wand, or the power nozzle, you need to check the connections thoroughly for di ... Electrolux Lux 5500 Canister Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis

Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

My Kenmore canister vacuum cleaner model 116.27514700 has unacceptably low suction.It is much less than my older GE Walmart canister vacuum. the 2 filters are very clean and there is no blockage in the hose and the dust collection bag is empty. Is poor suction a characteristic of this model or if not is there a way to fix this problem?

... Panasonic Kenmore Canister Vacuum Vacuum

Recently purchase SC-N500 vacuum cleaner. Worked well only the first 2 times I used it to clean up plaster dust from floor after sanding. Since then it has not worked at all well wiht very poor suction. Fluff gets stuck in the hose and has to be manually removed. Suction power is very poor. I have washed the filter to remove the dust with no difference. Who do I contact in Brisbane to service or assess the problem further.

... Sanyo Vacuums

How do I remove top of dirt canister on my Dirt Devil Model UD70010 Bagless Vacuum? Dirt is stuck inside canister and I cannot get it out.

... Dirt Devil Vacuums

We just purchased a house with the Easy Flo central vacuum system. When we opened the canister to empty it we discovered a bag or something hanging down into the canister. It is covered with dust, dirt, hair and who knows what. Do we change it or clean it?

Hi Trudi,Yes, you can wash it in warm water with a mild \015\012detergent. Be sure that the bag is completely dry before putting it back on.Should you ever decide you want to replace it, just do a google search for your vacuum ... Easy Flo EF1500 Vacuum

Dirt canister lid is stuck on

Push it back in till you hear it click.pres the button and hold and pull the dirt cup at the same time.please leave feedback ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Miele Red Star S3011 - Hose SES105 is stuck to canister. Any suggestions on how to release it?

... Miele Vacuums

Lid to kenmore canister 360 hepa vacuum cleaner, lid to change vacuum bag stuck in open position

GoVaacuum2,\012\012I have the same problem and that didn't work.. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Latch on my dirt devil total pet canister to empty is stuck. how do I make it open

I bet I have the same problem as you. My vacuums canister was put back together backwards and now will not move far enough to click unlocked. I am not sure how to fix this and I cant find anyone on any forums who do :( If you figure it out post it! S ... Dirt Devil Breeze Bagless VacuumVacuum

Kenmore central vacuum has great suction however dust and dirt bypassing the canister and ending up all over the garage

Change the caister seal ... Vacuums

How do I get the cover off my Kenmore PowerMate canister vacuum? The roller is stuck.

Remove the top that covers your light bulb, remove the two screws, unscrew light bulb, flip unit over and find the two clips on the right and left side, gently press each clip and the hood comes off ... Vacuums

Removal of stuck object in hose - Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Depending where the object is stuck a wire coat hanger might be of some help, otherwise try a borrowing a shop vac from someone and connect from the handle side of the hose, good luck ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Ive changed the filter and checked the hoses but vacuum doesnt pick up ...when its on the dust is being blown out the bottom of the vacuum....i took the canister off to test the suction its fine...also cleaned the filter ...help!

Have you check the roller brush and drive belt? It may be your belt has broke or is slipping and therefore not turning the brush.\015\012Turn on machine and power head see if brush is turning if it is put a small amount of pressure on the rol ... Kenmore Vacuums

My canister kenmore progressive is not sucking and is sptitting carpet powder dust all over the place. could it be it needs a new hpa filter? if so where on the vacuum would it be located?

Remove the hose from the canister, and turn on the vacuum. Does it produce good air flow into the hose port?. If ok, remove the hose from the sweeper unit and plug the end into the canister. If ok, check the bottom of the sweeper head for plugging of ... Kenmore 25512/ 25513 Progressive Canister Vacuum

The brush is stuck & does not spin - Bosch BSG71310UC Bagged Canister Vacuum

... Bosch BSG71310UC Bagged Canister Vacuum

Hi, The dirt does not **** into the canister. It looks like the cyclone system is not working. I think something is stuck inside. How do you recommend to fix it? Thank you for all your advice. Fiona

There is no vacuum action on your set. So as you mentiioned there is little or no suction available which means that the pump is not working correct. The two possibilities are either a large block of an object inside or the failure of the vacuuum pu ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a sock stuck in the hose of my vacuum cleaner. Rennaisance canister model. Because of the design of the handle I can't utilize the reverse blower. Please advise. Thanks

LolTry taping a fishing hook or some such onto the end of a straightened out coat hanger. See if you can push it up the hose and hook the sock.Or, remove the hose entirely, and push a broom handle down the hose.Tha ... Vacuums

Suction is not good. It is more hassle to empty. You have to take apart top filter & pull out everything stuck uptop. I end up with more dust on the outside when I change. I miss my bags. No dirt to deal with.

Yeah i agree with you...Sometimes you have to disconnect the primary vacuum hose at both ends and clear the debris in it..Then take the plastic top off the motor houseing and clean it out aswell...Its a pain rest assured :) ... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Stuff gets stuck in the hose and never makes it to the canister

You must have a clog in the hose, take the hose off if you can, drop something down one end to see if it comes out the other side, if not then it is clogged. If it does, the inlet down by the brush roll may be clogged. ... Eureka 431A Optima Bagless Upright Vacuum

I vacummed some sheetrock duct up with my hoover elite cyclonic.. i dumped the canister to empty the dirt and dust, but now theres not as much suction... is there any other area I should be cleaning... or can i submerse the plastic filter part in water?

Do not put the filter in water, it will ruin it. if banging out the filter did not work than you should probably replace it, sheet rock dust is very fine and will easily clog most filters. ... Vacuums

My vacuum's cyclonic action is not spinning and creating very little vacuum pressure through hose or floor brush area. I already checked, brushes are spinning, there is no apparent blockage in the canister, I took it completely apart and removed excess dust from the filter. Still no good vacuum. Any suggestions?

The following filter in your in your dump cup needs to be replaced. \015\012F24 Dirt Devil "I" Bagless Upright Vacuum Replacement Filter Style F24 ... Dirt Devil M130005 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0504 seconds