Having problems with your Hoover Vacuums ?

My henry hoover has just stoped working its not the fuse do you have any ideas


Answers :

I had exactly the same problem.there were no burning smells coming from it so nothing seemd obvious.I then took it apart and checked that all wires were connected,which they were.Then decided to check the plug.After replacing the fuse I chopped the cable of (as it is a seald plug) and connected up a new one.Hey Presto,Henry was alive again.Hope this helps.
Same here. Took mine apart and found the electrical contacts which carry power from the outside to the reel (which spins when you pull out the cable), had broken.
You can buy new ones on ebay for £5
However the tracks which they touch are a bit burnt on mine so this will need cleaning up too.
I'll know more about this when I fit them.
Good luck!

Graham
Repair Help & Product Troubleshooting for Hoover Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My henry hoover has just stoped working its not the fuse do you have any ideas


I had exactly the same problem.there were no burning smells coming from it so nothing seemd obvious.I then took it apart and checked that all wires were connected,which they were.Then decided to check the plug.After replacing the fuse I chopped the c ... Hoover Vacuums

My Henry the Hoover just stopped working. I have changed the fuse but still no luck, any ideas? thanks


... Numatic Henry Bagged Canister Vacuum

Nilfisk hoover stopped working , checked the fuse and its ok...any idea's


... Nilfisk Vacuums

Hi The band snapped the other day on my Vax Swift Turbo upright hoover and i got a new band from a Hoover repair centre. (Im assuming the bloke sold me the correct band). Was tight to go on. And it seemed ok. However, after switching on the band snapped immediately. Kinda burnt as well (at the point it snapped). Any ideas as to what the problem is here? The hoover is roughly 2 years old and used around 3 times per week. thanks Mike


Sounds like the brush roll is bad. Did you check the ends to make sure they turn freely? If not, replace it. ... Vacuums

I was using my Henry Hoover as usual. When i sucked up quite a fair sized puddle of water. The hoover instantly cut out and a strange burning smell was coming from it. Would this be the fuse, motor etc ? Or would it be worth my while just replacing the entire hoover ?


Hi. I have to wonder why anyone would **** up a puddle of water with a dry vacuum cleaner (with no earth lead). I realise that your question may simply be a joke, but if you are serious, I think it is probably fair to assume that it is now dead and p ... Vacuums

Hoover Alyx Pets 2000w Hoover Model TC1208 001 Virtually no suction, have checked for blockages but cant seem to see any, however i can't remove the hose to check it. Any ideas?


Did you check the HEPA filter? I have the same problem with mine if I don't clean the filter after using it. It's a dirty job but helps for a while. ... Vacuums

Hoover windtunnel bagless canister fuse - Hoover S3755 WindTunnel Bagless Canister Vacuum


... Hoover S3755 WindTunnel Bagless Canister Vacuum

Henry hoover my hoover has stopped working i have changed the bag and fuse and it still is not working i dont know what to do


... Numatics Numatic Hetty 200a Hetty Hepa Canister Vacuum Cleaner with Autosafe

Using hoover, stopped working. Bag very full so changed. Hoover seems very hot. Will not work. Checked fuse


Give the vacuum time to coold\\ down, then try again. If it still doesn't work, take it to a repair shop to be checked.\015\012When a vacuum is used for long after the bag is full, the motor can overheat to the extent that the motor burns out. ... Miele Cat & Dog 326i Bagged Canister Vacuum

Hello, I have a Hoover quadraflex Powermatic central vacuum system Model # s8099-031 that requires a new replacement 35 ft hose...I have contacted Hoover and they do not know where to buy a replacement hose for this model. I live in Canada. Any idea where I can get a replacement hose for this system? Thanks kindly, Tammy


Tammy, no info re your location, so I''l try this.Your Hoover hose is shot because it was made of rubber.There are new swivel handled, tangle proof lighter hoses made of vinyl which will last much longer and can be adapted to the old Hoover hea ... Vacuums

Hoover S3765 I have a Hoover S3765 (serial # 040600024465) and the unit stops working for no apparent reason. The light on top of the unit goes off when it shuts down, so I don't believe it's a problem between the hose, the tube and the floor unit. Sometimes I have to let it sit for over one hour before it will come back on. I've tried different electrical plugs too. Still won't turn on. Any ideas or suggestions? Thanks


If you light and nozzle motor both go off at the same time, you might have a bad power cord. Mine had this problem which I could verify by jiggling/twisting the cord near the strain relief on the nozzle. It would go on and off as I did this. ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Hoover suction The suction on my cat and dog hoover is not as good as it should be. Any ideas?


I had a fur ball stuck in the pipe.  I took the end off and used a broom stick to clear it out. ... Miele Cat & Dog 326i Bagged Canister Vacuum

My vax essentials hoover, model number vec-01 keeps blowing fuse as soon as it is plugged in and turned on. Cleaned the filters and have changed the fuse 5 times


... Vacuums

No power going to hoover have hoover turbo power 3. Plug is sealed but have changed fuse. Have had builders in house using it to renovate bathroom. Do you think it is now passed its sell by date was working until they got it. It dosent even switch on. Am ready to do them an injury as my upstairs is a mess


A Neighbour fixed it ... Hoover Vacuums

I have a Hoover U3330 001 upright vacuum, while using it today the power suddenly cut out and it stopped working. I have replaced the fuse with a new and tested fuse, but the machine will still not power up. please can you help?


... Hoover Vacuums

My Hoover sprint 1700w has stopped working. I thimnk it could be the fuse. How do i get the plug apart to get the fuse out? Can you give me other possible reasons it could have stopped working?


... Vacuums

Hoover upright has stopped working and tripped the circuit breaker. Where is the fuse located on the hoover ?


Most Hoover uprights do not have fuse. Some canisters doe but it is a thermal shutoff. When the vac overheats and cools down it restarts on its own. You very likly have motor damage, but if lucky you could have an obstruction in the fan causing ... Vacuums

My vacuum died. It won't turn on. It is not the outlet. Is it a blown fuse? How do I replace the fuse? Where does it go? This vacuum is a little over 2 years old. My older Hoover WindTunnel STILL works and has never had this problem.


It's probably the power switch. My switch was dicey for a couple years, finally gave out. Easy to replace.\015\012\015\012Remove the two screws just above the WARNING on the rear of the upper handle assembly, then slide the whole assemb ... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Hoover Windtunnel My Hoover is about a year old and now it's not as easy to push, when I first bought it, it would almost glide over the carpet, now it can be a bit of a struggle to push it around. Any ideas why?


The gears inside might be worn down. ... Hoover U8147-900 WindTunnel V2 Bagless Upright Cyclonic Vacuum

On our Hoover U6445-900 (Mach 6.9) we replaced the small belt that goes to beater brushes in front of unit. Upon starting, the Hoover quickly got hot and smoky. We shut it off and looked things over carefully, but the second try also resulted in friction heat on the belt. Now it appears the belt may have stretched due to heat and the brushes won't spin. Any ideas?


Are you sure you purchased the right size belt..the friction you speak of is usually caused by a belt not being the right tightness or a jammed beater brush ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

Have had to change the plug on morphy richards 1900 watt hoover model 71067. What is the fuse type/size for this hoover?


... Vacuums

Hoover RepairGood Day. I have a hoover HWD 020. It seems that the on/off switch broke, but I don't know how to open the space ship looking lid to get to the switch. Any idea?


... Vacuums

My Hoover steam vac spin scrub model 4060-900 brushes are not spinning and I have lost the manual. Any ideas. Thanks. [email protected]


The problem I found with one a neighbor was tossing out is the bearings in the part that drives the brushes were stuck. Lubing them up solved the problem, but took a bit of work to get into. This also provides a good chance to clean the crud out of ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How to replace a fuse on a Hoover Turbo Cyclonic vacuum


... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0389 seconds