Having problems with your hover max 60 ?
hover max 60 smells like rubber burning then stop working
my hover max 60 when I plug it in started smelling like rubber burning when I cut it on and will not work
Repair Help & Product Troubleshooting for hover max 60
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Stopped working Was working fine then it smelled like burning rubber, not the belt I checked. It sounds like the motor wants to run then it just stopped but the light is on. What do you think, go by a new one?? This has been a great vacuum cleaner and I can not seem to find a Sharp anywere. Thanks for your time.
Well it could be the motor, if it is it would cost around $80 or so for a motor. May be better to buy new, thre are a number of good brands out there. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum
I just bought the LG200R vacuum. It is working wonderfully but i have only had it a week. I have already had to clean the agitator but this is due to my extremely long hair and apparently i shed a lot. I was wondering if i should be alarmed by the funny smell it leaves in the air. Its not like a burning rubber smell but more like a fresh plastic smell or sorta chemical like smell (hard to describe) and it doesn't need to be on to make this smell it seems to be permeating off the vacuum itself
... LG LUV200R Bagless Upright Vacuum
The brush roller stops turning and I can smell the belt burning, then it will catch and start working normal. I looked under the plate to check the belts and they looked okay and no hang ups of string or anything. The only thing that seemed weird was that the smaller belt that actually attaches and turns the roller is a bit loose. The larger belt is tight but looks like its the one that is burning and causing the smell.
Better to replace both belts the smaller one is stretched out thats whyits slipping ,be sure to clean the old rubber off the motor shaft before replacing the belts.it will cause the new belts to run unevevly and go bad before their time ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Kenmore progressive model 38812790 smelled like rubber burning then the brushes stopped turning. Does it have a belt, if so, how do I get to broken belt to replace?
... Kenmore Vacuums
I have the Kenmore Model 116.36722600 Vacuum; while cleaning the carpets the vacuum all of the sudden stop working; I didn't smell anything burning; it was almost like someone unplugged it. I checked the rollers and I can move it forward and backwards with no problem. Do you think the motor just burned out? Does this vacuum have a fuse that I can reuse? I love this vacuum and would hate to toss it. thank you
Same here... I have a DC-15 Animal, it was making a clogged type noise and before I had time to react, it stopped working and I smelled burning rubber. I also noticed that the ball was really hot. It's too late to call support, but I intend on doing so in the morning. I've only had my Dyson for a year, so I'm sure it's covered, however, I have no idea where my receipt is. Did they take care of your issue?
You sucked up something that stopped the brush from turning. This made the belt slip causing a burning smell. ... Dyson DC14 Bagless Upright Cyclonic Vacuum
I have an Oreck XL Platnium. It smells like burning rubber and the brush roller binds and stops as you pull it back and forth, even on a hard floor. I have changed the belt 2 times. I have taken the brush roller out and checked it. It seems to be spinning freely. What could be wrong??
... Oreck XL Ultra Bagged Upright Vacuum
Vitamix 5000 stopped working. It stops working each time I use it; while blending I first smell a burning smell and then blender stops and will not start again. After sitting overnight it works again next morning and repeat same process. Any ideas how to repair?
It has an internal thermal shutdown. Let it sit for a while and it will reset itself. You can expedite by putting the motor base in the freezer for a few minutes, or by blowing a hair dryer into the base of the motor. ... Vacuums
Motor is sparking and smells like burning rubber. When it first happened I thought the vacuum had something jamming the beater bar. That was the smell it had, like when the belt gets burned. But when we turned it over, it wasn't jamming. Took off the base plate and turned it on. The motor area is sparking and it makes a weird noise (I assume that is because the motor fails and restarts). I looked for loose wires, can't find any. I believe I need some sort of part replaced, maybe even a n
From sound and description most possible is motor is burnt up sparks usually mean metal on metal either bearing or bushings went on motor if u can jiggle the shaft thats bearing if u rotate the shaft by hand and feel and or hear rough grinding the br ... Oreck Vacuums
WHEN I TURN ON UNIT IT SMELLS LIKE WHEN THE RUBBER BELT STOPS TURNING ON A SWEEPER. HOW DO GET TO THE MOTOR AREA?
Mosture has gotten into the motor. Take the bottom tank off and let the unit run for 30 seconds. It will dry out the compartment ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
Stopped working The cleaner stopped working when my wife was using it there was a noise like a 'phut' and it stopped. There is evidence of some smoke damage inside but I can't find any evidence of burning. Any ideas please?
This is a problem with your carbon brushes, remove old brushes, and check they have not become jammed in there brass sleaves, they are spring loaded.If they are not jammed but less than 20mm new brushes are required, available from most good vacu ... Numatics Numatic Harry Canister Vacuum
Smells like burning rubber when I turn on my G6 Kirby vacuum.
You must take of the plastic ends from the wood beater bar and make sure the metal axels are not wound up with hair. I did this monthly with 4daughters ... Kirby G4 Bagged Upright Vacuum
Hello, I have a problem with my Eureka Powerline bagged upright vacuum. It has a 12 amp motor and is model #4352, Type D. It was probably bought new in 1998. My problem is, while vacuuming today the motor seemed to slow down all of the sudden and then began smelling like burning rubber. I shut the vacuum off to check for blockages but could not find anything blocked. When I then turned it on again it runs but seems to only be running at 1/2 the motor speed and still has the rubber buring smell.
It sounds like a rubber sealing in the motor has come loose and is being constantly rubbed against the walls of the motor with would cause the smell and loss of motor speed caused by the fricton of rubber against the rod so if you can get to the moto ... Vacuums
My oreck upright smells like rubber burning when i vacuum. i just put a new belt on but it smelled like that before i even put the belt on
... Oreck XL Ultra Bagged Upright Vacuum
I checked the belt and it has not broken, but when I start to vaccum the spinning head stops, and I start to smell a rubber smell...Do you think I need to replace the belt, I did get some string caught in it the last time I vaccummed, and it did stink like rubber then also...
Yes you do need to replace the belt they stretch out. Think of a belt like a big rubber band if you were to stretch it out and hold a lighter to it the rubber band would stay stretched out. That is the same thing that happen ... Bissell Vacuums
Stopped working, burning smell
... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
My hoover 2000w pets cyclonic stopped working, there is a burn smell coming out off it
... Hoover Vacuums
Our vacuum smells like burning rubber. Does it
Burning rubber smell means the brush belt need attention. Make sure the brush is turning freely and replace the belt ... Eureka Vacuums
Bissell proheat carpet cleaner beater bar is not spinning and smells like burning rubber
... Bissell Vacuums
Hoover spinscrub 50 smells like rubber burning
... Hoover Vacuums
Smells like rubber burning, top of vacuum hot
... Eureka 4700A Maxima Bagless Upright Vacuum
I've got a Kenmore canister vacuum, Progressive 236123, and there's a burning smell from the belt side of the head--smells a lot like hot rubber. I've cleaned the agitator and changed the belt, but I still get the smell. It's stronger when I'm using "carpet" mode than when I'm using "bare floor" mode. Any ideas what the problem is?
... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum
There has been a burning smell for some time, but we continued to use it as everything was in working order. Sometimes the smell was not even noticeable. Today, however, the smell was intense and the motor kicked off. As it did, it was draining electricity like crazy. The lights dimmed drastically.
It sounds to me like the brushes in the motor are worn out or the motor has gotten water in it (if you have been using it for wet pick-up). The way you described the situation, I am really surprized if it did not trip the circuit breaker for the cir ... Rainbow E series Canister Wet/Dry Vacuum
Not working bissell power pro carpet cleaner not working. was working fine, then I smelled rubber like a belt had broken. does it have a belt that can break.
The bissell shampooers use belts t run the pump and the beater bar. if the master beltbroke which is the one that controls the pump and beater bar then yes the machine will not dispense water or turn the beater bar. it will have to be replaced *the ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum
Hoover U5344-950 My Hoover vacuum is a nightmare! I have had nothing but problems with it since day 1. The powerhead stops working if you try to lower the handle to vacuum. I took it in to be serviced and was told it sat on the shelf for too long in the store and it warped the belt...so it was replaced. Got it home, it worked the first time I tried it, then went right back to no powerhead working and as a bonus it is giving off a nasty smell like it is going to blow up! It now gets really hot to
... Hoover U5344-900 WidePath Vacuum