Having problems with your Infinuvo QQ1 CleanMate 365 Robotic Vacuum ?

My Cleanmate 365 goes backwards for 3s when switched on and then the error light appears and it stops.

\015 It was fully charged beforehand and almost clean. It was working, then I walked away for 5 min and when I returned it had stopped, in the open. I have a new carpet, so maybe fluff is stuck inside?\015

Answers :

Clean it
Repair Help & Product Troubleshooting for Infinuvo QQ1 CleanMate 365 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Cleanmate 365 goes backwards for 3s when switched on and then the error light appears and it stops.


Clean it ... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

I have a clarke bench grinder model 1002. I have a light that I would like to attach into the wiring though the grinder wiring in it's base. The light has two wires, and the grinder has a ground that is grounded to the base, a black that goes to a switch then to the motor. The white goes directly to the motor. where would I have to splice in the two wires from the light? I have a switch that I would like to put in for the light on off also.


Attach the white wire on your lamp to the white wire on the grinder.\012Attache the black wire on your lamp to the black wire on the motor side of the switch.\012This will give the lamp power any time the grinder is turned on.\012Yo ... Vacuums

I was changing a light bulb with one of those metal extension rods that unscrew and screw back in the replacement bulbs. It evidently didn't seat correctly and pulled off the bulb and created a quick "poof" type electrical short. I have switched out that bad bulb with a new one and can't get either the fan or lights to work. There doesn't appear to be a reset switch. I also swirched out the wall switch to see if that would make a difference and it does not. Any thoughts or ideas would be appreci


If you have not already done so, I would check at the fuse or circuit breaker panel to see if you have blown a fuse or tripped a breaker. ... Vacuums

I have a ge light switch receiver rf1023, with incandescent bulbs, and when I try to switch it on it just blinks once and goes out. if I hold the switch on the battery-operated wall remote, the lights keep blinking until I let go. It used to work fine, and now it doesn't. I've lost the intallation instructions, so I don't know if there was a trouble-shooting section that covered the problem.


... GE Vacuums

My scooba when switched on starts to spray water then spins round faster than normal then starts to go backwards quite quickly then stops then continues to reverse more then stops & with the nor


... iRobot 5800 Scooba Vacuum

My irobot goes backwards a short way, stops, turn, goes backwards some more, repeats the process over and over until it gets stuck. No beeps, no talking.


Your problem is the circle dance problem or 9 beeps errorsearch the site and you find solutions ... iRobot Roomba 530 Robotic Vacuum

Red light is on my bissell spot lifter when it is pluged in and switch is in the off position. When I switch it to the on possition red light goes out and the machine does nothing. What am I doing wrong?


... Bissell 1719 Spot Lifter 2X® Handheld Vacuum

I have a DC 21 Dysonstowaway. Lately it cuts out a LOT, when vacumning . I press the start switch on the head, goes for 5 sec. Stops, goes, stops etc. How frustrating !! What can I do ?


Sounds like a loose power connection someplace on the machine.\015\012Probably needs to be looked at by an experienced repairperson.\015\012 ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a Hampton Bay Midili fan which I just installed about a month ago and it was working fine. A few days ago when I flipped the switch on the light flickered on and off consistently until I turned the switch off. The remote also stopped working to control the fan and light. Since this model only can be controlled by the remote I am worried I will have to replace the remote already after only 1 month!


In many of these remote controlled lamps you cant use the new spiral light bulbs .. you can only use standard incandescent lights .. if thats not the trouble then you may indeed have a bad controller (in the fan) .. there is probably at least a 90 d ... Vacuums

When the power head is turned on it goes from green light to red light and stops. The belt is fine and there is no obstructions in the brush to stop it from turning.


This will happen only when the brush or motor does not turn the right speed \015\012make sure to pull the end caps off the brush and clean any hairs or fibers from it\015\012the motor you can try and turn it by hand with out the belt on a ... Fantom Vacums Lighting Canister Vacuum

I have a self propelled Royal Dirt Devil vacuum model number 087900 and it goes backward fine but forward has to be pushed so hard it's impossible. Is this a switch? Do you know about how much the part would cost and can it be done by a beginner. We fix a lot of things ourselves but we aren't mechanics by no means. We put a brand new belt on it. I don't think it can be put on backwards and brush turns fine. Where is the switch? Use layman's terms.


You might try a new belt and/or brush roll. The brush roll is what helps pull a vacuum forward, the power drive helps, but if the brush isn't turning like it should, then it will hinder forward motion. The belt may look ok, but they stretch to the ... Vacuums

My Janome Harmony 8100 will occasionally stop and give me a System Error #1 - I cannot find anything about this error. It is a computerized machine with 70 stiches and attachable embroidery hoop. I first started getting this error with the hoop and now get it when I am just sewing. As soon as the needle goes down to the bobbin, I get the error. The machine freezes and the only way to get rid of the error is to turn the machine off. Sometimes I can get the machine going again, but now it wil


... Vacuums

I have a Hoover Elite Rewind model #uh71009. We moved recently and it was jostled around and the red power switch popped out. I put it back in but it's stuck; it stays either left or right, it doesnt move back and forth. It appears there may be another piece missing from the power switch...all I have is the red switch and a tiny cylindrical metal tube with a spring on one end. This piece fits into the hole on the red switch. Inside the vacuum itself where this goes, there is quite a large cavity


... Vacuums

My roomba goes round in circles. sometimes it stops and moves a centimeter backwards and then again it goes round in circles. if you press the ,,dock'' button it goes back to the station. if you press the ,,clean'' button, again, it goes round in circles.... the machine is cleaned, the sensors aren't covered with dirt, the weels and brushes can rotate freely.... can anybody help me??? thanks in advance franz


Here's the link. IR Bump Sensor Fix ... iRobot Roomba 560 Robotic Vacuum

Vacum cleaner flashes lights and goes dead.


This one is quite an old question, but answering in case anyone else finds this by googling.When the machine stops and both lights flash, it means that it has overheated. This usually happens on the z8220 to z8280 range when the cone in the dust ... Electrolux Vacuums

Hoover power drive u6311 - How do u change switch? Does anyone have any idea how to remove the on and off switch, when I tap on the housing the motot and light goes on and off. Also does somebody have a exploded view of this model. also does anyone know the part number of the switch.


The swrtch is located in the bottom section of the motor. When the swtcih goes out it time to repalce the unit. The swtich is part of the motor. The switch rod run all the way down the body to the swtich located in the motor. ... Hoover U6311-930 Power Drive Bagged Upright Vacuum

My ez1 Monster Floor Steamer - green light goes off when I lower the handle and stops steaming


It could be calcium deposits in the tank. Clean it with white vinegar. Good luck! ... Euroflex Ez1 Monster Floor Steamer - Cleans & Sanitizes

My vacuum does not start after switching bag, if the little switch is pressed in the light goes on to signal full bag even though it is empty


Check your pipes.. if the can be removed clean what you can with cold water little bit of washing up liquid. ONLY. it really sound like to me its your pipes. ... Electrolux Epic 6500 Vacuum

Cleanmate only goes backwards - Infinuvo QQ1 CleanMate 365 Robotic Vacuum


... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.


... Roomba Robotic Floor Bagless Vacuum

I have an IS222 Bernina Steam Iron that quit steaming today---the iron heats up but the steam switch doesn't light or heat. It appears that we needs a new steam switch. Can you furnish this?


... Vacuums

Hi, my roomba560 goes one foot straight ahead, then turns right for halv a foot. stops, beeps four times, and the light goes red. I charged it up, measured the voltage to 16.6 on the battery.. same thing every time. Is it battery? i have cleaned it, gearbox, everything..


... iRobot Roomba 560 Robotic Vacuum

Haier 65 pt Dehumidifier. I purchased a new Haier Dehumidifier 2 years ago. I believe this is the third season and it had been working great. Very quite and on humid day's, I have to empty it every 10-12 hrs. Two day's ago it just stopped working, no indicator lights. I plugged it into another outlet to be sure with the same result. I believe it is either the bucket switch or main switch. What do you think and where can I get parts. I live in MA.


HI, this unit has a 12 amp 125v glass tube fuse on the control board. Chances are you blew this fuse. This can happen if the unit is starved for air and ices up. you must take the front of this unit off to access the fuse of this control board. ... Vacuums

I have an Epic 6500 SR..it turned on, then it suddenly stopped. The lights indicate it is getting power, but the on/off switch will not operate it. Is there a reset button somewhere on it?


Hi,\015\012\015\012First thing is to push the circuit breaker button(reset button).\015\012Reset button is a red button present in the unit,used for resetting the Unit...\015\012\015\012If you have the Electrlx 2100 mode ... Electrolux Guardian Bagged Canister Vacuum

The CV750 stopped working. It will come on sometimes but most of time it will not work. I installed new bag and cleaned filter. Green light on side of unit is on. Switch on side of unit will not make it come on either.


My CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and cleaned filter. Green light on side of unit is on. Switch on side ... Broan-NuTone CV750 Central Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0811 seconds