Having problems with your iRobot 4150 Roomba Vacuum ?

My irobot (Roomba)is only working for 10 mins then

\015 My irobot is only working for 10 mins then stopping. It is only 17 months old and is used approx. once per week.\015

Answers :

It should take about 6 hrs to charge. I had the same problem and reset the charging circuit. 1) Charge it until the green light comes on. 2) Unplug and pull battery out. 3) hold down the power on button 15-30 seconds. 4.) Put the battery back in, plug in the charger (direct - not through the dock) and charge for 72 hrs. Then, run at Max clean until the "I'm dead" tune plays.
Repair Help & Product Troubleshooting for iRobot 4150 Roomba Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My irobot (Roomba)is only working for 10 mins then


It should take about 6 hrs to charge. I had the same problem and reset the charging circuit. 1) Charge it until the green light comes on. 2) Unplug and pull battery out. 3) hold down the power on button 15-30 seconds. 4.) Put the battery back in, pl ... iRobot 4150 Roomba Vacuum

I have a DC04 and when i switch it on it works for 10-15 mins thens stops working for about 20 mins then starts working again.


Your vacuum is overheating - that's why it cuts out. You need to check everywhere possible for blockages and also make sure the washable filter is clean and dry. If the machine has been run without the washable filter in place, then the exhaust filte ... Vacuums

My dyson dc07 works fine for about 5 to 10 min then turns itself off leave it for 10 min or so then it will work again for a bit then does it all over again. help please thanks


Your machine is overheating. This is usually caused by the dust bin being too full, your filter is long overdue for a cleaning, or there is a clog in the machine. Usually a cheap fix regardless... Wash your filter, check the removeable parts for bloc ... Vacuums

Hoover Vacuum works, then stops in 3-5 mins. Works again in a couple of hours


More than likely there is an inline over current breaker that is bad or weak and needs to be replaced. This is for overcurent protection of the motor. It is fairly common for the protection circuit to go bad ... Vacuums

Brushes only work when Dust Bin is removed!! I have cleaned & cleaned this thing! It runs for about 2 mins & stops, says "Clean Brushes"! and now it's very noticeable it's not picking up well... but is picking up a bit. I take the dust bin out, and the brushes spin.... and it has much more power.... and is very clear it is working! But it's useless without the dust bin! LOL It's only 9 months old.... called customer service, but it was the one time it worked just fine! Of course, I thought I'


HI, If the brushes work , without the bin, the problem , the problem could be caused , due the failure at the bin lock mechanism. There is a sensor that checks if the BIN is connected properly or not. This problem is best resolved by getting ... iRobot Roomba 560 Robotic Vacuum

My handheld dyson is not working - initially it was cutting out after only a few mins then seconds now it won't work at all despite showing green light ??


Hi there, it's Jack at Dyson.I'm sorry to hear your DC31 Animal is only working intermittently. When fully charged, this machine should have a maximum runtime of 10 minutes, or 6 minutes on the maximum power setting.There are several ... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Turned Hoover on and worked as normal for 10 mins then for a split second went off and then on again a coupe of seconds later went off completely. Tries different socket and changed the fuse. Still not working.


Internal short most likely to a feed wire to the motor ... Vacuums

Irobot roomb will not work. I've discharged the battery and recharged for 16 hours. Acts like it is going to come on but sort od revs up and then gives a series of 6 or 7 or 8 beeps.. Goes so fast I cant count them. I've cleaned everything. Aftertyring a couple to Times, it seems that the battery discharges... Clean light goes red. Please help... i need this thing to work!,,


... iRobot Roomba 550 Vacuum

I have a Uro-Pro vapor steam cleaner Model EP95 Have used it only a few times and worked well Today it worked for about 5 mins and then nothing from the wand but steam started coming out from under the canister. What can cause th is problem and is it fixable


... Euro-Pro Steam Cleaner EP95 Canister Vacuum

My robot will not charge. Tried multiple resets and new battery from irobot.com (both suggested by Irobot customer service) but got nowhere. The vacuum did work for a short time (until the new partially charged battery ran out). If I bypass the internal charging circuits and charge directly from the charger (with jumpers) the robot seems to work fine. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.


Replace the battery charger ... iRobot Roomba 4210 Bagless Robotic Vacuum

Irobot Scooba model 33501 the check brush light immediately goes on and irobot does not work. I replaced the brush and it still will not run and the brush light remains on.


... iRobot 5900 Scooba Robotic Wet/Dry Vacuum

THE VACUUM CLEANER WORKS FOR 6-7 MINS THEN CUTS OUT, THEN AFTER A WHILE STARTS AGAIN FOR A FURTHER 6-7 MINS THEN KEEPS REPEATING THIS PROBLEM


What you describe is typical of a machine that's overheating. This is almost always caused by a blockage. Check the machine thoroughly for any blockages, including any filters, and my bet is that you will find something that shouldn't be there that n ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!


The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

Wertheim XL180 vacuum cleaner not working The past month our XL180 would stop working after 20-40mins therefore we'd wait 1-2 hours to resume cleaning. Now it doesn't turn on at all. Would this mean its good for nothing? Tips on maintenance would be much appreciated, i consider myself a handyman always willing to give something a go.


Thanks for using FixYa and welcome to the site. Sorry you had to wait to long. First, try checking the cord. Try moving the cord in certain areas to see if the cord has a break in current. If it does, it will need replaced. You have prob ... Vacuums

I got one and it wouldn't steam, took it back and got another one and it steams for 5 min. then stops. If I unplug and cool down it will steam again for 5 min. and stop. very frustrating. I hear very good things from friends and theirs works fine.


Hi,Yeah some work great and other are a POS...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a new scoba (irobot) the battery is charged the tanks were fillied and every time i hit the power button and then clean the machines "check the tank" light came on. i have done all the proper instruction checks an i have done all the trouble shooting section. the machine will only work (and that is for 5 minutes drying its head) when i hit power and the clean button twice. so obviously the machine is somewhat working


We had to prime the sensor. irobot suggested a turkey baster, but we didn't have oneso we used an empty visine bottle with the end snipped off and rinsed completely. this worked after the first try. thank you for your interest ... iRobot 5800 Scooba Vacuum

No water I have had a bissell proheat for 3 months. Now, the water won't come out in either the floor cleaner, or the tools. I have checked all the stoppers, they all seem to be in working order. It started to work for about 5 min, then stopped again. Is this a fixable, quick problem, or should I return it as being defective?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have cleaned & cleaned this thing! It runs for about 2 mins & stops, says "Clean Brushes"! and now it's very noticeable it's not picking up well... but is picking up a bit. I take the dust bin out, and the brushes spin.... and it has much more power.... and is very clear it is working! But it's useless without the dust bin! LOL It's only 9 months old.... called customer service, but it was the one time it worked just fine! Of course, I thought I'd stop here first before calling again! Than


Ok, this is a "Brush Height Adjustment" issue. It will probably work great on a hard surface but on carpet the brushes bog. If you've taken the unit apart already...Sorry....do it again. When you do, you'll see a String which allows the brushes to " ... iRobot Roomba 560 Robotic Vacuum

I changed the motor in my Dyson Animal hoover and works fine but after 15 minutes it stops as if it was turned off, if i leave it for a period (2 hrs)it will start up again and work for a further 15 mins before shutting down.


Hi thereAll Dyson vacuum cleaners are fitted with a thermal cutout, which will switch off the motor if it becomes too hot. This is normally caused by a lack of airflow to the motor, i.e caused by a blockage or a dirty filter. ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I have a Kenmore Elegance Vacuum with Dirt Sensor, Model # 116.30750400C, Serial number M41901532. When vacuuming the carpet the power head will work for 3-6 mins then automatically shut off, power is still there and lights work but the power head motor turns off and the suction stops. I will turn it off and on, check the outlet, flick the on off buttons...nothing. I will turn it off for a couple minutes and it turns back on and runs like normal. I've check the bags, filters, cleaned the hos


It is an electrical problem in the handle, if you can or know somebody that has any fix it ability it can be fixed in about ten minutes. Oh, and Sears SUCKS!! ... Kenmore 34612 Bagged Upright Vacuum

Brand new bissell #6583 upright vacuum worked for 15 min


The belt may be broken. The following link is to the User's Guide which explains how to check and replace the belt if needed.\012 ... Bissell 6594 PowerForce Bagless Upright Vacuum

IROBOT - CLEANED USING WATER - NOW DOESNT WORK AT ALL


You probably got the switches wet ,make sure all the water is out,then take a blow dryer to dry out the electronics ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

IRobot Roomba 550 vacuum not working.


... iRobot Roomba 550 Vacuum

How well does irobot work on smartstrand carpet


I don't think you'll have a problem ... Vacuums

POOL VACUUM WORKS ONLY FOR A FEW MIN THEN STOPS CAN ANYONE TELL ME WHY?


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0549 seconds