Having problems with your iRobot 530 Roomba Vacuuming Robot, White Vacuum ?

It will only go backwards

\015 530 model will only go backwards. Have tapped the visor many times as advised but its not worked this time. Help\015

Answers :

Disassemble and clean the switches located behind the wheels.
Repair Help & Product Troubleshooting for iRobot 530 Roomba Vacuuming Robot, White Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My irobot goes backwards a short way, stops, turn, goes backwards some more, repeats the process over and over until it gets stuck. No beeps, no talking.

Your problem is the circle dance problem or 9 beeps errorsearch the site and you find solutions ... iRobot Roomba 530 Robotic Vacuum

Runs but doesn't vacuum/****. Sidebrush works fine. Cleaned the roller brushes, and that seemed to confuse the robot and now it keeps going backward a few inches, turning, and then starts going backward again.

Sounds like a sensor problem. pull and clean the front black/white caster assembly and the revealed movement sensor and the 4 cliff sensors along the bottom of the front. Make sure the front caster wheel turns freely. You may have to remove the rolle ... iRobot Roomba 560 Robotic Vacuum

I have a self propelled Royal Dirt Devil vacuum model number 087900 and it goes backward fine but forward has to be pushed so hard it's impossible. Is this a switch? Do you know about how much the part would cost and can it be done by a beginner. We fix a lot of things ourselves but we aren't mechanics by no means. We put a brand new belt on it. I don't think it can be put on backwards and brush turns fine. Where is the switch? Use layman's terms.

You might try a new belt and/or brush roll. The brush roll is what helps pull a vacuum forward, the power drive helps, but if the brush isn't turning like it should, then it will hinder forward motion. The belt may look ok, but they stretch to the ... Vacuums

I have a Dirt Devil Vision self-propelled vacuum cleaner. Recently, the self-propelled feature is stuck in the backward mode, so it only goes backwards! I can get it to go forward if I push really hard (i guess it is good for a workout!). I try to turn off the propel feature completely, but it will not turn off. please help!

Hi, the problem you are having is going to be with the switch that controls the forwards and backwards settings so with this stuck in backwards their is no way you can get this turned off, the other problem is your not going to be able to replace thi ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Roomba 580 Bagless Vacuum: Roomba moves backwards slightly, then turns, and t...

... iRobot Roomba 580 Bagless Vacuum

Hoover Elite motor runs when moving backwards but not forward

Are you sure its not just your belt on the beater of head slipping and needs to be replaced? ... Hoover Elite Rewind Bagless Upright VacuumVacuum

Roomba going backwards

I had the same kind of problem with my model 400 today...after starting it and having it go in a circle for 30 seconds or so it would finally run into something and then back up a few inches, turn, then go forward a few inches, then back up a few inc ... iRobot Roomba 4210 Bagless Robotic Vacuum

Upright hoover keeps falling backwards

... Dyson Vacuums

My Dyson falls backward & won't stand up - what's wrong?

Hi Kay,I'm sorry to hear you're having difficulty with your DC18. If the stabiliser doesn't seem to be locking the machine upright, I'd encourage you to get in touch with us directly, as we'd appreciate the opportunity to provide further assi ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

My scooba when switched on starts to spray water then spins round faster than normal then starts to go backwards quite quickly then stops then continues to reverse more then stops & with the nor

... iRobot 5800 Scooba Vacuum

Kirby Generation 3 Drive spinning backward.

Just take it into kirby. ... Kirby Generation 3 Bagged Upright Vacuum

Hoover model U6425-920 falls backward

It sounds like the handle release lever is bad if the unit will not stand up. It's common when those units get a little older. It is unlikely you'll need the rear handle assembly (the part with the filter housing) but it does happen. Inspect the latc ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

My vacuum goes backwards easily, but forward with GREAT effort..

... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

Series 400 (Sage) acting erratically...in circles, backwards.

... Roomba Robotic Floor Bagless Vacuum

Backward spinning roomba

Easy fix. This is the Roomba Circle Dance. Here's the Roomba Circle Dance Repair Manual. ... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

It will only go backwards

Disassemble and clean the switches located behind the wheels. ... iRobot 530 Roomba Vacuuming Robot, White Vacuum

Irobot scooba 5800 spins quickly then sets off backwards

Remove and clean all of the wheels, and make sure the cliff sensors under the bumper are clean. Tap the bumper with your hand-- really smack it a couple of times. It sounds like the Scooba believes it's stuck against an obstacle. ... iRobot 5800 Scooba Vacuum

My roomba starts going backwards

I had the same kind of problem with my model 400 today...after starting it and having it go in a circle for 30 seconds or so it would finally run into something and then back up a few inches, turn, then go forward a few inches, then back up a few inc ... iRobot Roomba 4210 Bagless Robotic Vacuum

Scooba circles and only goes backwards.

Try cleaning the cliff sensors under bumper ... iRobot 5800 Scooba Vacuum

Hoover Savvy Brush only runs when the vacuum is moved backwards

Replacing the entire upper handle assembly with OEM Part #48663238 will solve your issues, for a cost of about $35 plus shipping. ... Hoover U8185-900 Upright Vacuum

G5 runs backwards

... Kirby G5 Bagged Upright Vacuum

It runs mostly backwards, and in circles and will push itself up

Make sure you have the battery in correctly plus to plus and minus to minus ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

I had to replace the switch in my Kirby G6. It took some doing but I got in out and the new one in. I must have miss labeled the wires because when I pull backwards the clutch pushes forward. Ther

Go to kirbvacuums.com and look up your model number ,they might even have a toll free number you can call ... Kirby G6 Bagged Upright Vacuum

Running backwards in circles.

If your Roomba's speaker isn't working, you need a new Roomba regardless. Give a call to customer support (877-855-8593) and they'll help you out. ... iRobot 4150 Roomba Vacuum

The extension wand is on backward

... Panasonic Mc-ul915 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0178 seconds