Having problems with your iRobot 5800 Scooba Vacuum ?

Scooba problem there is no water left in the dirty tank after the scooba runs


Answers :

Does it put down clean water onto the floor? If so, rinse the four ports on the underside of the tank really thoroughly. You might have a clog; it's not difficult to dislodge it if you use enough warm water. Also make sure that the squeegees on the cleaning head cartridge (which holds the brush) are straight and in good condition.
\015\012
\015\012If it doesn't put down water at all, try the tank rinse anyway, as it can help with that issue, too.
Repair Help & Product Troubleshooting for iRobot 5800 Scooba Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Scooba problem there is no water left in the dirty tank after the scooba runs


Does it put down clean water onto the floor? If so, rinse the four ports on the underside of the tank really thoroughly. You might have a clog; it's not difficult to dislodge it if you use enough warm water. Also make sure that the squeegees on the c ... iRobot 5800 Scooba Vacuum

I used the Scooba 390 for the first time this weekend and it seems that the robot had problem sucking up the dirty water from the floor. When I emptied the dirty water tank, there was hardly any dirty water. Can you please let me know what can cause this problem?


... Roomba iRobot Scooba 390 Floor Washing Robot

I left dirty water in my Scooba for two days. Now the tank smells bad and there is a green film in it. Any ideas how to clean it or does it have to be serviced? Thanks for any advice (except not forge


... iRobot 5800 Scooba Vacuum

After running for a normal cleaning cycle only about 1/3 of the water from the clean water tank has been moved to the dirty water tank.


This is normal. ... iRobot 5800 Scooba Vacuum

After running for a normal cleaning cycle only about 1/3 of the water from the clean water tank has been moved to the dirty water tank.


This is by design. not all the water from the clean water tank will end up in the dirty tank, some is left on the floor, some evaporates. ... iRobot 5800 Scooba Vacuum

Our problem with our Rainbow E Series is that it has sucked water up and blown it out through the lower part of the hepa filter, making the filter wet and dirty. This had happened before and the repair shop did not see any problems with the machine, so we replaced the filter and were very carful not to overfill the tank and to change the water often. Now it has happened again and ruined another filter. Do you know what could be causing this issue? Can the filter be cleaned or will a new one be


Thank you for allowing\012us to help, please respond with further questions and concerns\012\012Spanish speaking\012available for all problems\012\012 ... Rainbow E series Canister Wet/Dry Vacuum

Scooba model 6050. The robot picks up dirt as found in the screen, but does not vacuum up any water. The dirty water tank remains empty after using all of the clean water. Help. Thanks.


The dirty water lines may be clogged. I don't exactly know how to un-clog it, but I would check to see if there is any way to flush them out. or talk to the company's customer service people. They would know what to do without voiding the warrenty. ... iRobot 5800 Scooba Vacuum

Water leak I just bought this steamer a few days ago, and already I am having problems, when I fill the water tank that your suppost to fill the water runs out before I even turn the machine on. I have tried using plugs to keep it from doing this just so I can shampoo my carpet, this seems to work to a point, considering the fact that there are two holes underneath close to the brushes and one just a little ways back from that location. Do you know if this is something that should have plugs or


If you just pruchased this, then it is under warranty, take it along with proof of purchase to a warranty repair shop and have them fix it. If water just runs out, then there may be a seal missing or a water line off. ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

My scooba isn't picking up any water and the dirty tank is dry


I found that if I filled the two oblong extended openings under the tank with water and gave it a quick **** I was able to clear a large amount of [email protected] out. It took many attempts to get it to the point where I could blow into the holes and sen ... iRobot 5800 Scooba Vacuum

Hoover Max Extract 77 fills the dirty water tank with clean water from the clean tank.


... Hoover Vacuums

I have a Hoover STeam Vac Dual V. Replaced the water tank-no problem. but water still pours out through the bottom. when idle, when off, when running. dont need to press the lever. Help!


Te dual V models have an electric pump and 2 solenoids that control the soap and water to dispense. The problem you describe, sounds like the water solenoid is stuck open. and would need to be serviced by a repair shop. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

5500 model low suction is it possible that filters are the problem the filter on top of water tank is dirty and exhaust filter is also dirty


Change the filters & ensure that the water container is properly seated in the machine.If the water tank is not sealing correctly the machine will not genrate any suction. ... Karcher K DS 5500 Vacuum

Hello. My scooba 5800 had a check tank light on. I used a straw on the valve and that fixed the problem. Now the scooba runs like nothing is wrong, but there is no actual cleaning going on! It goes the full cycle, but no liquid comes out. The vac part seems to be working b/c there is fluff in the vac when it's done. Please help!


Hello, Take the battery out and hold the switch down for 30 seconds, to reset the curcuit board, then charge back up for 12 hours. this should take care of it. If I can help future please call @ 1561-848-3387 Thank you, Teresa. Clean Sweep Vacuums ... iRobot 5800 Scooba Vacuum

I've got two Hoover F8100900 cleaners, BOTH have sensor problems, saying that the dirty water tank is full when it is not. Is there any way to bypass these sensors?


... Hoover F8100900 Upright WetDry Vacuum

It's brand new - just out of the box! Noticed the dirty water tank is bone dry. There is no suction! The front removable nozzle seems to be loosely attached.. The metal clip doesn't seem to hold it tight. Not sure if that is the problem. But I have a very wet rug! Suggestion?


It sounds as if it wasn't assembled correctly. Was it already put together when you purchased it? It sounds like the Brush Bar Belt never got put on.Let me know if you need more help.Jim ... Bissell 1950-3 Quicksteamer Plus Vacuum

The water that is supposed to go into the dirty tank is running through the bottom of the machine and all over the floor. The float seems to be moving freely.


... Bissell 1400 Little Green Pro Canister Steam Vacuum

I have never used a shampooer before when I use it it says to empty out dirty water. I don't have any left. My tank is empty. Am I doing something wrong.


Suggest that you do the following.\015\012Remove the TOP ("Clean water") tank. Fill it 1/2 full of water. Put the top on the clean water tank and place it back on the machine.\015\012\015\012Release the machine handle and remove the ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hello, could you help please. I have a Bissel ProHeat 9400-M. The water remains in the bladder when the machine is on, in other words nothing happens and I cannot clean with it. Inside the tank the small flap is in the open position. I have always used your products although I did run the Bissell over an area that had been cleaned with another product. Could that have caused the problem by blocking it somewhere? I have cleaned everything and cannot see a blockage. Thank you for your help.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Carpet Powersteam water tank no dirty water goes in


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

Vax is dispensing from clean water tank but dirty water tank is not collecting anything


... Vacuums

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

My bissell pro heat does not **** up the dirty water anymore at least the dirty water tank does not fill with dirty water


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0711 seconds