Having problems with your iRobot 5800 Scooba Vacuum ?

Scooba 5800 It vacumms but it does not release any water. Tank is full. What do i do?


Answers :

Did you try priming the pump?
I had this problem several times. Once I needed to realign how I had inserted the lint screen and the other time I had to realign how I put the rubber thingie in and i was sucessful both times.
Repair Help & Product Troubleshooting for iRobot 5800 Scooba Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Scooba 5800 It vacumms but it does not release any water. Tank is full. What do i do?


Did you try priming the pump? ... iRobot 5800 Scooba Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

I have a Thane h2o mop ultra, I added some bleach to the water tank to clean better, the unit worked for a while, enough to clean 1 room, then even if the tank is still full of water the steam is not


... Vacuums

I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.


Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums

Hi my hoover f7425-900 is not releasing water from the clean water tank but the detergent is being released can you help me? thanks


The most common reason for this problem is that the solenoid operated valve on the rinse cycle has failed, and is not opening. The solenoid assembly will probably require replacement. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Eureka Atlantis Express is brand new - never used. I took it out of the box, read the manual, filled the soap and clean water tanks, put them in. I lifted the machine off the counter to take into the living room but all the water came running out of the bottom all over the kitchen floor. I can see where the little white plastic piece sticks up into the water release valve and lets the water out. How do you stop this? Can it be fixed?


... Eureka 2553A Atlantis Handheld Wet/Dry Vacuum

I did not get a manual with my vac. I am trying to soak up water from a water tank leak and water seems to go right trough the vac and water is coming out the blower hole. the tub is not full.


There is a special sock that you need to buy for it. You can run the paper filter if your in a pinch but after that one time, that's it, that filter is ruined.The paper filter is for dry vacuuming, the foam filter is for wet vacuuming, You have ... Ridgid 9 Gallon Wet/Dry Shop Vac 96882 Canister Vacuum

Polti Vaporetto 2400: Water out light comes on when tank is full


Hi you need to put 5ml of Kal Stop fo Polti machines into 1000/1500ml of water into the tank, The stronger solution is better (1000ml) Let it heat up and this should break down the limescale on the solenoid. I tried this today and it has worked sav ... Polti Vaporetto 2400 Canister Steam Vacuum

RAPIDE ULTRA W90-ru-b NO LONGER SPRAYS THE SHAMPOO ONTO THE CARPET. CHECKED THE TANK IS FITTED SECURELY,THE TANKS EITHER FULL OR EMPTY DEPENDING ON EITHER ITS THE TANK FOR SHAMPOO OR THE ONE FOR DIRTY WATER, AND ANYTHING ELSE I CAN THINK OF. IT STILL DOESN'T SPRAY.


... Vacuums

Water seems not being introduced to heating element,which is hot, Depressing the handle appears not to be releasing water from tank; very little if any steam or water comes out base even after holding the handle down for a prolonged period and or pumping the handle.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Empty lights flashes with audible alarm although water tank full


... Polti AS700 Canister Steam Vacuum

Zip Hydroboil. 7.5 Liter. Water does not come out at outlet tank although reservior is full of water


... Vacuums

I have a Bissell powersteamer powerbrush that sprays for only a few seconds then stops. If I wait 20 seconds or so it will spray again for another 1 or 2 seconds. I have only used Bissell cleaning products in it and clean it every time after use. The hot water tank and cleaner tank are full.


... Bissell Vacuums

After running unit for about 15 minutes, when pushing the unit foward, spots of water appear on the carpet. Soap and water tank is full.


The water is going to be coming from a small seal in the bottom of the soap tank. I would suggest turning it on, on a hard floor. Then when you see that it is dripping, then trace the water back to the source. I am sure that it is coming from the soa ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Nothing spraying out of Bissell Powersteamer Proheat. I've check filter under flow indicator, pump belt is fine, cleaner in proper tank, bladder of water tank is full. We've had it for a very long time but it's barely been used. Can anyone help?


... Bissell 1698-1 PowerSteamer ProHeat Plus Upright Vacuum

The flap that closes when the dirty water tank is full keeps closing as soon as I turn on the cleaner (the tank is empty).


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.


... Vacuums

The bottom tank is not filling up with water and it seems like less liquid is being released out of the top tank


Your diffuser may be clogged above the brushes. check the front squeegee to make sure that it is in tact. Remove the lower tank and look at the intake hose, these often tear over time due to plastic getting stiff. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Both tanks are full and there still is no water on the floor


Possibly, the vinyl hose, where the solution flows through, is pinched shut fron sitting on the closed position. I've been able to rotate the hose sometimes, to allow flow. A drop of alcohol where the hose is on the fitting will loosen it. Store ... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell pro heat steam carpet cleaner, not releasing water.


That means that you need to replace the pump belt. Here is the belt you \012need and a manual you can view:\012\012Bissell 7901 Belt and ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Have a polti vaporetto 2400 been used 3 times approx but out of warranty heats up ok but wont release steam when trigger pressed.have tried flushing water in tank with no results


These machines like to be used regularly. if allowed to sit (especially after using tap water) they may buld up lime deposits on valves and cause them to stick. you could try filling with vinegar and let set, also tilt it so vinegar runs into valve a ... Vacuums

Lost Suction This is my second hoover steamvac and i am having the same problem with my new one as i did with the old one that i tossed out. I have used it about 12 times and it worked great the first 6 times... Now i'll empty a full tank of water and only half will get sucked back up. I have tried taking it apart and cleaning and also the rubber seal had some gaps so i sealed those thinking that it was leaking air from there...can anyone help? I am so close to chucking this one and buying somet


Usually when there is no suction, one cause is the lid to the recovery tank is not on all of the way in the back. Also if you have that foam filter on the underneath side of the recovery tank lid, it needs to have a 1/4 in or so gap from the top of ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My new domestic Pentax cam 50 water pump is sometimes going to 0 bar and not cutting in I would like to adjust the lower pressure from 1.5 bar (22 psi) to 2 bar (30).I have a diaphram type pressure tank.


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0735 seconds