Having problems with your iRobot Roomba 4210 Bagless Robotic Vacuum ?
After installing a new battery after not using Roomba for over 1 year it will not drive straight
Ok. What I would do is to disassemble the Roomba, clean both its wheels, Cleaning Head Module (including the gears) and the front bumper sensors. If after cleaning the front bumper sensors and same problem...you will need to replace the sensors. It's more than likely one or more of the IR LED are damaged.
Repair Help & Product Troubleshooting for iRobot Roomba 4210 Bagless Robotic Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
After installing a new battery after not using Roomba for over 1 year it will not drive straight
Ok. What I would do is to disassemble the Roomba, clean both its wheels, Cleaning Head Module (including the gears) and the front bumper sensors. If after cleaning the front bumper sensors and same problem...you will need to replace the sensors. It's ... iRobot Roomba 4210 Bagless Robotic Vacuum
SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?
I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test
If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001
I have a Roomba Discovery. In the past, I had to replace the charging dock. Then the battery died so I did not use it for two years. I finally bought a new battery and used the Roomba. It worked great. It did not find the docking station, and died. I have been charging it and the red light pulsates, but after 16 hours, it still is not charged...any ideas?
Hello. Turn your robot over and clean the charging contacts with the eraser end of a common pencil. Then Charge it and you should be up and running again. Regards, Joe ... Vacuums
Hi, this is our third Dyson DC-16.. the Trigger was shorting out on the first two.. Now we have the third one for about a year.. on charge when not using it.. don't use it every day, but for quick pickups only.. Just how long should the battery last? I was sent a new charger, didn't help.. it just won't hold the charge even tho two green lights are solid, but one red light does show up..
How are you charging your battery? Every battery has a memory. If you dont let it die the first come times then charge to full the battery will assume 40% is 100%. ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum
Shark/cordless /sweeper - over four years old. Started - but seemed like it was caught and shut off almost immediately. Not used year around - tried to start after absence. I have removed some hair and perhaps dental floss. Checked belt - it seems O.K. Do I need a new battery or is it just worn out.
Check the brush,is there any dirt got stuck in between brush rolls.If there is then it needs to be cleaned.Your cordless sweeper will automatically shut off if an obstruction is caught in the brush roll. the other thing to checks is dust contai ... Vacuums
Electrolux 2-in-1 Pronto is losing suction. We've had it about 1.5 years, but lately it seems to be losing power. Not part of recent recall. Filters are clean. Need new battery already? We use it about every other day
Yes try new battery it sound like a power problem.thanks ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne
I have a swivel sweeper, the original series, that is about one year old and is losing power. The battery has been replaced but it still seems weaker than it used to be. The brushes do not turn as quickly and the overall pick-up is not as strong as it was when it was new. Any suggestions on how to get the power back up to what it once was?
HiThank you for your queryI think what you will find is the base of the sweeper has 4 brushes, each of these brushes are run from a cog, if you can take the base apart you will find that it has been clogged up with hair and ot ... As Seen On TV Swivel Sweeper Vacuum
Last year my wife and I bought a new Dirt Devil Reaction All Surface vaccuum cleaner to replace the older Platinum Force. After using it a couple of times the new one gets clogged with dog hair easily and shuts down. I cleaned it out completely including the hepa filter but it will not handle the dog hair. The old one never had a problem and still works. We went back to using the old vaccuum cleaner because we can not find the receipt and had not registered the new one and are stuck with a new 1
Greetings jettin_us,\015\012\015\012Normally you can contact the store you purchased the unit at, and if you paid with anything other than cash, they may be able to retrieve your receipt for you. \015\012\015\012Once you get t ... Vacuums
My 4870 K Boss is 2 years old. I have replaced belts & filters in the specified intervals. This last time I replaced the belt after a year, it shredded 3 of them on the outside edge of the belt in about 5 minutes of use. I ordered a new brush roller & heavy duty belt which I installed. It began shredding the belt in less than 5 minutes of use. What is your suggestion? Is this a known problem with this model? Eureka says no and is not standing behind it.
The only reason why it would be shredding the belt is if the pulleys were not lined up correctly. Check the allignement of the belt to make sure there is nothing kepping the pulleys from being in line. The other thing that it could be is if the rolle ... Vacuums
Battery charge I just purchased a new battery pack insert for my Roomba, Replacement was a breeze and it now works great. My question is; The last battery I bought ( not from you) was a full cased roomba battery pack that didn't last a year. Roomba says leave the r Roomba charging all the time so it's ready when you need it, and that's nice but I feel that leaving it charging like that it will kill the battery faster as it is always warm to the touch. These battery's should last at least 5
Dave you are correct. You should never over-charge anything like a Roomba, Cel Phone, etc. That will kill a bettery very quickly. ... Roomba Robotic Floor Bagless Vacuum
I have a miele S4210 vacuum. It has a SAB100 accu nova battery brush which will not work. After charging the battery, light comes on saying not charged and now the power head brush won't turn. I had problems with my first powerhead so I purchased another and it worked for a short time and now I have the same problem again. I have four batteries I use interchangeably but nothing seems to work. I spent a fortune on this vacuum and to tell you the truth I hate it! Contacted Miele after 1st year of
... Miele S300 Bagged Canister Vacuum
My first proheat lasted four years so I bought a new one. After I used my Pro Heat for only the fourth time my first issue occured, the gear on the pump that runs the brushes came off, so I had the one from my old proheat, I just changed the gear spindle that is screwed to the pump and fixed that problem but now it will not pump water. That is why I bought a new proheat, I could not get the old one to pump even after a new pump and made sure all lines were not cloged.
Is your new machine a 2X or like the old style proheat? ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
How long are the batteries for virtual wall supposed to be working for? Even though I try to remove them after each cleaning , or use fresh batteries, the wall does not respond straight away. I can n
... iRobot Vacuums
My Bissell BS3920F upright (similar to the 10N6F) has been working wonderfully for the past 3 years but suddenly seems to not pick up dog hair as well as it used to. It has been pulled apart by my husband to ensure nothing is blocking the hoses etc and when running the suction seems to be there. It seems to grab the dog hair and leave it in a straight line directly under the unit without picking it up. I then disconnect the hose and use to hose to pick up the dog hair. This works well but obviou
Check to see if your brush is not worn down, they do wear with age - compare the length of the bristles with a new one. Replace the brush ir there is a significant difference in bristle lengths. Also check the flexible ben ... Bissell Vacuums
Hi, I have a Casio fx-115s scientific calculator which I've had for around 25 years. I am unable to use the bracket function and have lost the instructions. Could you please give any advice to save me having to buy a new calculator? I'm not sure how to use the brackets, whenever I press the ( ) buttons, it shows -E- on the screen which I'm presuming is an error message. Please help.
You should be able to use parentheses in the same order in which you would write the arithmetic expression. For example, 4*(3.5-1.5)= should give you 8. Without the parentheses, this would 12.5.Essentially, the left parenthesis comes imme ... Vacuums
I have a 2 year old Electrolux ergorapido cleaner that gets used daily for about 2/3 min, the blue light on the stand comes on when the cleaner is put on to charge but fades after about 5 min & the batteries dont charge, would this be a faulty ac adaptor or worn out batteries
No, not worn out batteries.For my experience, if the batteries were worn, they would charge with the blue led being on and after that, the vacuum wouldn't hold his charge. just that.This is a different problem. Check the contacts between the ... Electrolux Vacuums
I have an euro-pro steam cleaner model # sc505 that is about 2 years old. It has only been used a limited number of times, about 3 or 4 times. It now has a tightly sealed safety cap on it and it will not release allowing me to add water to the steamer to use it now. Any tips on fixing it? I'd love to have a products guide to items that are available for compatiability with our sharkie. We constantly see new items available and wonder will that product work with ours?? Thanks!
... Euro-Pro Shark SC-505 Handheld Steam Vacuum
I have a Everstar canister vac 1200 (owned for about 4 years) and the hose broke apart. I taped it together and have used it for about a year but it has failed. The telephone # in the manual no longer belongs to Everstar (if it ever did). I bought this vac from Home Depot but no longer have a receipt. Any ideas on where I'll get a new hose?
My roomba is about two years old. I have not used it very much. It has been on the battery charger all of the time. It had been awhile since I had used it and I pressed the clean button and it left the dock, but will only go in a circle and after awhile, t turns itself off and the on/off button lights up. Any suggestions?
I had this happen to my Roomba and it turned out to be a fried main circuit board. I called iRobot tech support to help get the diagnosis and they insisted on sending me a wheel module for me to swap in but that didn't work and when I called back in ... iRobot Roomba 560 Robotic Vacuum
I have a dyson dc07 with a malfuncitoning clutch diagnosed here on fixya. I've replaced the clutch and the grinding noise when the clutch is engaged for carpet and non rotating brush problem presists. This is after replacement of the clutch with a new part. Install of the new part went well and there are no otehr apparent problems with the unit. Ideas? The unit is only a couple years old and not used that much on carpet. For an expensive vacuum I'm not that impressed with it at this point.
Greetings from GoVacuum,\015\012\015\012If you have replaced the clutch already, then this can really only be one other problem, and that is the roller brush. If the roller brush's bearing have locked up, and the brush is no longer spinn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I have a kenmore progressive direct drive handi mate jr. upright vacuum. My daughter used it last night to vacuum up some cat litter that had spilled on the floor. I went to use it today and it turned on for a second and then stopped working. I have hit the reset button but it will not turn on. Help this vacuum is only 2 years old Is there anything that I need to reset or do so that the vacuum will work again?
Its probably clogged up with cat litter.might have gotten into the motor.your motor has a motor guard inside if it. when it overheats it will shut down till it cools off.you need to clean all th cat liter out of it.and clean the filters.with a direct ... Kenmore Vacuums
Belts breaking/melting The original belt broke at almost 1 year so I replaced it. I changed the carpet setting to shag even though my carpet is very low pile to make it easier on the vacuum. I didn't get to use it but just a couple minutes and could already start smelling the new belt getting hot. I checked the roller and it is easy to spin. Not clogged with hair or dirt. Now the inside of the new belt has small pieces of rolled rubber instead of being smooth. The metal shaft that goes into the
... Dirt Devil M088905 Vision Bagless Upright Vacuum
Just properly installed a Hampton Bay ceiling fan - Midili, 44inch Model #44-MDL. Loaded the remote control with a 9 volt battery and the remote is EXTREMELY HOT. Changed out the battery with another brand and the same thing happened again. It is so hot you cannot even hold the remote! Help...! I want to use my new fan.
Hello,I have iRobot Rooomba Discovery 4200 about 2 years,but I didn't use it about 1 year.Now I tried to use it again,but doesn't work.I charged it 16hours,the power was green,but after leaving home base again red lihgt on power and stopped to work.Do you think that I need to replace battery?Thank you
The Roomba's batteries are made to be in constant use. It is more likely that the battery cells are dried up. You will need to replace the battery. ... iRobot Roomba 4210 Bagless Robotic Vacuum