Having problems with your iRobot Roomba 530 Robotic Vacuum ?

After cleaning my irobot dust compartment is empty but the brush compartment has fluff in it please advise how i can fix this?


Answers :

Go to http://homesupport.irobot.com/app/home
see the resources available for troubleshooting, and fix it, videos, manuals.etc.
God bless you
Repair Help & Product Troubleshooting for iRobot Roomba 530 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After cleaning my irobot dust compartment is empty but the brush compartment has fluff in it please advise how i can fix this?


Go to http://homesupport.irobot.com/app/homesee the resources available for troubleshooting, and fix it, videos, manuals.etc.God bless you ... iRobot Roomba 530 Robotic Vacuum

Hello. My scooba 5800 had a check tank light on. I used a straw on the valve and that fixed the problem. Now the scooba runs like nothing is wrong, but there is no actual cleaning going on! It goes the full cycle, but no liquid comes out. The vac part seems to be working b/c there is fluff in the vac when it's done. Please help!


Hello, Take the battery out and hold the switch down for 30 seconds, to reset the curcuit board, then charge back up for 12 hours. this should take care of it. If I can help future please call @ 1561-848-3387 Thank you, Teresa. Clean Sweep Vacuums ... iRobot 5800 Scooba Vacuum

I have a Mr Coffee PSTX Series coffeemaker, the clean light came on and I started the cleaning process, about 20 minutes into it, an alarm went off, the cleaning light was blinking and I can not clear the alarm. It has not finished going through the cleaning cycle and is frozen on with the alarm. I can not clear it. Please advise.


... Vacuums

Noisy vacuum I have a eureka capture that I bought in april it's making a horrible high pitched squeal type noise, I have made sure my roller is clean, my filters are clean, i replaced my hepa filter and there are not any blockages I don't know what else the problem might be. Could you please offer other suggestions to fix this?


... Vacuums

Hi, my Roomba robot is spinning around. I cleaned it by disassembling wheels, gear compartment, etc.. Cliff sensors cleaned with compressed air. Briefly ran fine, but started to spin again. It's not under waranty anymore. Any suggestion please! Thanks, Olga


Usually this occurs when the front wheel is jammed or can't move freely, please verify if this is the case or not on your Roomba. Also, what model number of Roomba do you have? it should be located on the bottom of the unit on a label. ... iRobot Roomba 540 Vacuum

I have a bosch generator iron, purchased in October 2010 which I have been really pleased with up until this morning. The steam is now spitting all brown marks over my ironing. Can you please advise how to clean. Thank you


I would empty the water out and attempt to flush it out and steam some C.L.R through it ... Bosch Vacuums

Irobot roomb will not work. I've discharged the battery and recharged for 16 hours. Acts like it is going to come on but sort od revs up and then gives a series of 6 or 7 or 8 beeps.. Goes so fast I cant count them. I've cleaned everything. Aftertyring a couple to Times, it seems that the battery discharges... Clean light goes red. Please help... i need this thing to work!,,


... iRobot Roomba 550 Vacuum

I have a vax cylinder model V-094. Working fine then started to play up. Switch it on and the motor seems to struggle to power up. Kind of wurrs up and down. Was thinking it could be the brushes have worn. Tokk to bits and cleaned her up, took a look at motot and brushes, cleaned them too, back together and still them same problem. Help please, hoover is not old but has done some work really don't want to through away something that can be fixed.


Hi.\015\012\015\012after all you have done I would be pretty confident its the motor thats faulty they are expensive to buy so machine is going to be scrap,\015\012\015\012Sorry.\015\012\015\012 ... Vacuums

My Dyson DC24 will not pick up despite the rollers are spinning.(i have cleaned the rollers) All the filters have been changed. When usng the hose after a second a loud hiss can be heard and then no suction. Please advise


I have the feeling you have something stuck somewhere at the hose. carefully use a clothe hanger and clean inside the hose. use a flashlight to see the object. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Model number f 5912-900 hoover steam vav with clean surge.This is not the f5914 model........my new machine has 10 min. on it...in mid use it has stopped sucking and now is blowing more than anything, I took the front clear piece off as well as the black cowling/shroud and can find no obvious hoses to un-clog nor anything else to un-clog for that matter...I am looking for advise to fix this thing now, myself


Here is a list to go by for no suction problems that you can follow along with they are common proble\015\012Problem #1 Steamvac is not Sucking!If your Hoover Steamvac was working properly and suddenly it is not sucking any ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

IRobot only turns in 360 degree circles, it is fully charged and cleaned. How does it get fixed?


\015\012\015\012\015\012\015\012\015\012Your bump sensors are malfunctioning. I had the same problem. The best thing to do is order a repair kit. I ordered mine from EESolutions.ca and it worked great. I'd recommend... ... iRobot Roomba 530 Robotic Vacuum

I have a DeLonghi coffe urn Model # DCU61. It leaks terribly during the brewing cycle. I believe I broke the seal. I tried to unscrew the glass knob on the cover to clean it and discovered it didn't screw on! Please help me. I can't seem to find an appliance repair that will fix coffee urns.


HelloFirst locate where the leak is coming from,Leaks in pump coffeemakers are often due to faulty tube connectors. Unplug the coffeemaker and fill the reservoir with water. If water leaks from an elbow, clean the mating surfaces before r ... DeLonghi Vacuums

We have a Dyson stowaway DC20 Turbine and the turbine head is not spinning at all.Can you please advise if this can be fixed and how. Thankyou from, Bev Effern 0411 018 531


Are the pins at the connection between the wand and head damaged? Has the turbine been verified that there is not blockage? ... Dyson Vacuums

Hi, I have a dyson dc24 which I purchased two years ago. It has suddenly stopped picking up after going over a thick pile carpet. I've cleaned the filters. Can you please advise what I should do


Your head is probably plugged with pieces from the thick pile carpet, open up the head and clear the blockage. ... Dyson Ball DC24 Bagless Upright Vacuum

My irobot scooba check tank light will not go off, I have tried cleaning everything, priming and the light still won't go off, someone please help me! hollie


... iRobot Scooba 380 Robotic Vacuum

I recently bought an upright MC-E4061 and have a problem with the paper filter clogging prematurely, it needs weekly cleaning. The filter clogs too easily with the main plastic bowl having very little debris! Our older panasonic, used daily, is not problematic. Please could you advise as the paper filter is time consuming to clear.


... Panasonic Vacuums

Help Hi I have had my irobot roomba model 4000 now for 3 months now, I just LOVE it sooo much. I have used it everyday since I got it. But now it is not working. I cleaned it all out I even sprayed it with that air spray can. What happens is, It starts to go then it acts like there is something in the way and stops then goes the other way, then goes off. What is wrong? Please help!!!


I had the same kind of problem with my model 400 today...after starting it and having it go in a circle for 30 seconds or so it would finally run into something and then back up a few inches, turn, then go forward a few inches, then back up a few inc ... iRobot Roomba 4210 Bagless Robotic Vacuum

I want to clean fluff from underneath the transparent front panel of my Bissell 11 7901. I have removed the screws from the bottom of the panel, but it remains firmly in place. I do not want to apply apply forceful leverage in case there is something else that needs to be done before the panel will come off. Any suggestions, please? Peter


I just did this one myself, You've done most of the hard work already.Be sure your holding tank is out and not in the way.Double check the down front screws are still out since you sent in you question. Now tweak the front section (the business end) ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a hoover all terrain cleaning for carpets and hard floors and the Brushes will not rotate. I have replaced the filter on the bottom which is recommended by hoover and the brushes still wont rotate. Please advise


I assume this unit has no mechanism to turn the brush but instead using the air flow to activate the brush, in this instance it could be that there is dirt which is caught up in the brush which is stopping the rotation.A nice good clean and make sure ... Hoover Vacuums

Bosch Vacuum Cleaner: I changed bag. Cleaned out all suction hose and hepa filters, however, my 1450 w 12 amp upright vacuum cleaner will die after five minute run - overheating. Please advise.


Greetings from GoVacuum.com,It sounds like you may have a bad thermal switch inside the machine. Most vacuum cleaners have a switch connected to the motor, so if the vacuum cleaner is running hot, it will shut off to prevent any damage ... Bosch Vacuums

My dyson DC16 constantly shuts off even when battery is fully charged. I cleaned the filters to see if that was the problem. It only runs for a few seconds before it shuts off. It will run intermittently for about 10 minutes before dying completely. Please advise


Hi its Darran at Dyson. From your description of the problem, it sounds as though there is a problem with the battery. Your DC16 will have been supplied with a 2 year guarantee. If it still within this period, please contact ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Kirby heritage II vacuumn doesn't pick up much. have taken it in for repair a couple of times at a substantial and after a about a year same problem again. Have checked connections, cleaned out. please advise. Thank you


How does the kirby heritage toe control work and where does the sping go. ... Kirby Vacuums

Unit does not spray water for deep cleaning. One can hear the motor running of the ''spray'' action, but no water comes out. I have followed the DVD instructions exactly. Please advise Thanks Anne


Sounds like you have an air lock in line before motor. turn unit upside down and disconect hoses. reconnect and try again with plain water. good luck ... Vacuums

Our dog urinated on the machine. We cleaned both filters & plastic areas. Some might have gotten into the motor housing since it still smells terribly when turned on. Please advise


Place a Febreze sheet in the canister/dirt bin where the dirt collects. Let it spin around in there whilst you're using the machine. The fragrance will be spread throughout the vacuum cleaner. If that still doesn't work, you can always replace your f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My electroluix super pro z 6160 with a turbo head has lost suction. the last thing vacd up was a broken drinking glass. please advise of anything i can do to fix.


Hi,\015\012\015\012According to your problem, first check the suction pipe if\015\012there is any blockage. Clear the blockage. You can try with attaching another\015\012head. If the head is faulty the change the turbo head or repair it. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0565 seconds