Having problems with your iRobot Roomba 540 Vacuum ?

540 Roomba goes in tight circles left and right after backing off charging base - stops and give oh-oh signal and 9 beeps - I have taken off bumper and cleaned sensors etc - blown out with air and still have same issue - unit will also not find or go back onto charging base - any suggestions /

Answers :

Repair Help & Product Troubleshooting for iRobot Roomba 540 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

540 Roomba goes in tight circles left and right after backing off charging base - stops and give oh-oh signal and 9 beeps - I have taken off bumper and cleaned sensors etc - blown out with air and still have same issue - unit will also not find or go back onto charging base - any suggestions /

... iRobot Roomba 540 Vacuum

My Infinuvo Cleanmate QQ2 will not accept a full charge. It runs for 10 - 15 minutes and then says "battery low". I have a new battery and charger. I have charged it directly without the home base and have left it charging for days. Any suggestions? Thanks, Linda

... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

My irobot scooba does not spray cleaning solution out after about the first 30 seconds it is running. I have tried all the suggestions in this post with the suction bulb to charge with air, and then with water to clean it out. water does come out of both valves when forced with the bulb or immediately after using the bulb to charge it. then after it runs for about 30 seconds the floor is dry.

... iRobot 5800 Scooba Vacuum

Hi. My electrolus epic 6500 sr just stopped working while I was vaccuuming. Only the power light appears. I unplugged it, let it cool down, replaced the air filter and the bag. It still does not go on. Any suggestions?

It seems that the power supply unit has got the problem. Must check it up for any defects. There could be a burnt out connection. A bad switch too could be the culprit. The machine is getting the power is indicated by the power light. Hence one can d ... Electrolux Epic 6500 Vacuum

Hi, my Roomba robot is spinning around. I cleaned it by disassembling wheels, gear compartment, etc.. Cliff sensors cleaned with compressed air. Briefly ran fine, but started to spin again. It's not under waranty anymore. Any suggestion please! Thanks, Olga

Usually this occurs when the front wheel is jammed or can't move freely, please verify if this is the case or not on your Roomba. Also, what model number of Roomba do you have? it should be located on the bottom of the unit on a label. ... iRobot Roomba 540 Vacuum

** suction The best way to describe it is that when I was vacuuming I could see dust clouds at the front of the vacuum where the light is swirling around in the air. It was like it was blowing dust around instead of picking it up. I checked the tubing and found that it was clogged with some paper and hair ***** etc.... So I cleaned it out and tried it again and it still was not picking up properly. I had my husband take all the tubing apart to check for other clogging and there was none. When I

You have an airflow problem. You may still have a blocked intake or tube, also check the filter. The air is supposed to go in the bottom (of course) and I'm sure you k**w where it goes out. You probably can **te a reduction in exhaust. If this is ... Oreck XL Ultra Bagged Upright Vacuum

The flexible brush on my unit does not spin. It did 'by accident' pick up a cat poo that didnt make the litter tray while I was out, (and it happily spread it all over the house and skirting boards). I cleaned the unit, removed the base and wiped everything clean. I've unscrewed the flexible brush and cleaned underneath it but it still wont spin. Any suggestions?

... iRobot Roomba 530 Robotic Vacuum

My bissell model 18Z6 has developed a loud noise and vibration when the brush is running. I have removed the brush assy and cleaned all the hair, etc but still the noise. I ran the brush motor with the belt disconnected and all seemed ok, but of course there was no load on the motor. I suspect a problem with the brush assy bearings or axle or both but I hate to just throw parts at the problem. any suggestions would be greatly appreciated.

... Bissell Vacuums

Hello! The suction in my Dyson animal is very poor. I discovered small holes in the internal hose, but even after a quick duct tape fix, still having issues...sounds like the seal from the canister to the vacuum is leaking air. I know I need a major repair but my mother in law is coming tonight! Any suggestions? ~Lisa

Or you can do this for free:\015\012\015\012http://www.ehow.com/how_5870417_modify-dyson-prefilter-suction.html ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

We have a commercial Simplity vacuum series 6 and we are not getting any power. We tried different plugs, changed bag, etc. but still no power. Is there a reset button anywhere? Any other suggestions? Thank you for any assistance!

Check the reset switch on the back of the machine toward the bottom. Maybe next to a silver sticker.If you need any help contact me.TimTheVacCenter.com ... Simplicity Vacuums

My dyson dc18 has no suction, i havent found any plug in the tubing etc? there seems to be air blowing out around canister, is that normal? Help, any suggestions?

... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated

1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Need a charging base for a Black&Decker CHV7200 DustBuster

You can find the charging base here. hope that helps.\015\012http://www.ereplacementparts.com/charger-and-base-p-102673.html ... Black & Decker Vacuums

I am charging Remington Shaver FS360 for the first time I have put in charge for almost 12 hrs (the instruction is to charge it for 24 hrs at the first time) but still the charge led is not glwoing. I am not sure wheather it is still charging or not. Could you please help me out to figure out the problem.

... Vacuums

I have a JAZZ portable power pack (300c) that I've had for a long time. When I plug it up to charge it, it want take a full charge. Also the air compresser doesn't pump air like it should. It mainly in the motor for air pump.

... Vacuums

I have a WRPL 25P Dehumidifier, Serial # NQ336USA2733, that I purchased at Canadian Tire, Corner Brook, NL, Canada on July 25, 2009. I recently noticed that the dehumidifier wasn't working. When I turn it on, it just blows cold air and does not absorb the moisture in the air. I am wondering if it is still under warranty. Please advise if the product is still under warranty and what steps I need to take to have it repaired or replaced. Thank you.

... Vacuums

My robot will not charge. Tried multiple resets and new battery from irobot.com (both suggested by Irobot customer service) but got nowhere. The vacuum did work for a short time (until the new partially charged battery ran out). If I bypass the internal charging circuits and charge directly from the charger (with jumpers) the robot seems to work fine. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.

Replace the battery charger ... iRobot Roomba 4210 Bagless Robotic Vacuum

My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.

... Roomba Robotic Floor Bagless Vacuum

No suction I have the central vac type. It has no suction at the can. I pulled the hose going to the walls and tested there...and nothing. I removed the dirt can and checked the motor ...it is spinning but does not feel like any suction. I checked the exhaust and it is pushing strong air out. I also cleaned the filter and still nothing. Is there a relay or something that would cause only exhaust air. I emptied the can of dirt and put it back together and have absolutely no air.....hear the motor

On some units there is a screen that protects the impeller of the motor. If this gets sealed off with debris then it is like putting a potato in the tail pipe of a car. Taking the top off the unit reveals the motor. DO UN-PLUG the unit first from th ... Electrolux Central Vacuum

Hi, my Dyson DC16 works fine but after removing from charge base following recharge the red and green lights remain lit and the unit will not operate until i remove the battery and reconnect to vacuum,this extinguishes the lights and now can use with no problem.I guess that the charge control within the vacuum is not recognising that the unit has been removed from charge,is there a solution? Thanks

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a Roomba Discovery. In the past, I had to replace the charging dock. Then the battery died so I did not use it for two years. I finally bought a new battery and used the Roomba. It worked great. It did not find the docking station, and died. I have been charging it and the red light pulsates, but after 16 hours, it still is not charged...any ideas?

Hello. Turn your robot over and clean the charging contacts with the eraser end of a common pencil. Then Charge it and you should be up and running again. Regards, Joe ... Vacuums

My Roomba ha sboth light flashing green at the home base station. It seems as if it will not take a charge when I manually docked it to the home base. Why is it flashing both green lights at the home base?

... Roomba Virtual Wall 3002 Vacuum

Food Saver VAC 550. It used to work great, but now it doesn't remove all of the air from the package. It seals, but with air in the package. I have cleaned the vacuum seal, but it still leaves air in the package.

My FoodSaver vac 550 won't turn off after it's done sealing. what does this mean? Can anyone please help me out. ... Vacuums

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0756 seconds