Having problems with your iRobot Roomba 550 Vacuum ?


\015 It has circle disease\015

Answers :

Try blowing out the unit, particularly the bumper, with compressed air. Clean off the little windows on the underside of the bumper-- these are the cliff sensors. Then, most importantly, tap the bumper with your hand about half a dozen times to knock loose anything that's stuck. If the issue persists, give a call to customer support and let them know you're having the 9-beep errror.
Repair Help & Product Troubleshooting for iRobot Roomba 550 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Try blowing out the unit, particularly the bumper, with compressed air. Clean off the little windows on the underside of the bumper-- these are the cliff sensors. Then, most importantly, tap the bumper with your hand about half a dozen times to knock ... iRobot Roomba 550 Vacuum

My roomba keeps circling like it is in the spot clean mode

... iRobot Roomba 400 Bagless Robotic Vacuum

Roomba 560 goes in small circles like it is in "spot mode". Wheels are clean and push up and down and turn easily.

This is the Circle Dance. Compare the behavior with the video on this site. You can also order a repair kit on the site as well. ... iRobot Roomba 560 Robotic Vacuum

Mine is the Discovery model but the fix it should be the same. My problem is that it only goes in a small circle and will not move on. It ACTS likeit is stucfk in the "spot" mode.

Hi,\015\012 \015\012You are correct though you have the discovery model the way to understand the code and find the troubleshooting steps are same. First when the status light comes on, the Discovery is goi ... iRobot Roomba Red 4100 Bagless Robotic Vacuum

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A

This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

My roomba 530 keeps on circling around. What can I do?, just runs in circle. It's new and everything is cleaned. It was fun for three cleanings and then started that circle dance.

... Roomba Robotic Floor Bagless Vacuum

I have a dyson dco7 it just recently started making a horribly load noise if i run it in carpet mode but not in hard floor mode what can i do?

Change the belt(s). Here are the belts you need:Dyson DC07 Belts ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I dont have directions on how to run it sister gave it to she had lost directions i need to know how to run the machine i have some spots i want to clean

You don't mention the model, but user guids can be found at the below site.\015\012\015\012 ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

UPM Model ET170 Electronic Timer Programming: A. Is it required to associate one program number with each day of the week? B. Can two programs run during the same day? C. Can each week day run a different program number? D. What is the shortest ON time one must program for the RANDOM function to provide two ON-OFF cycles? E. How do I end the programming mode and start the timing sequence. The instructions with the timer are not clear to me. Thanks for your help.

A. It is required to program each day of the week.B. No. Either it is programmed to be on or off.C. Yes. Each day can run a different program.D.Short random is for 1-2 hours. Long Random is 2-3 hours.E. Once you are done progr ... Vacuums

The cleaning solution on my bissell spot bot is not being pumped through....on the stationary mode or the manuel hand held mode with the brush attachment

I had the same problem, and found that the culprit was that the small filter element. about the size of a dime, that sits arount the nozzle activator (pin that depresses the clean water nozzel) was clogged with "gunk", and prevented cleaning solution ... Bissell 12005 Spot Bot Handheld Vacuum

I purchased the Sharp Ultra-Thin Digital Alarm Clock Today. SPC431A The first one I bought the digits did not show up on the right side of the clock. I went and exchanged it for another, after showing the store what was wrong with it. I have now been able to set most all of it, but... 1) It is on 24 hr mode, instead of AM or PM. The instructions that I have do not say anything about a 24 hr mode. I have tried running through the clocks hours, to see if that would change it back to AM or P

... Vacuums

Running backwards in circles.

If your Roomba's speaker isn't working, you need a new Roomba regardless. Give a call to customer support (877-855-8593) and they'll help you out. ... iRobot 4150 Roomba Vacuum

Roomba running in circles

... iRobot Roomba 530 Robotic Vacuum

It runs mostly backwards, and in circles and will push itself up

Make sure you have the battery in correctly plus to plus and minus to minus ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Bissell spot bot will not run

I returned it. I didn't see why I would have to pay you to fix a problem when It came broken. please take me off your list. \015\012\015\012Thank you ... Bissell SpotBot Hands-Free Compact Deep Cleaner - Silver

For the first time, I tried using my Kirby Sentria shampoo attachment. I've lost the manual but found instructions online for making the swap from regular vac to shampoo-er and got it all assembled. The foam laid down just fine, however, when I run the vac back over the foam to pick it up, there is not a stitch of water showing up in the tray. First I thought maybe it was bc I hadn't put that much of the foam/water onto the carpet, but 12 hours later, the carpet is still wet in spots. Clearly

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=638285\015\012Generic problem for all Vacuums\015\012For the first time, I\015\012Posted by MHicks on J ... Vacuums

My hayward phantom pool vacuum runs in circles at the bottom of the pool

My hayward phantom vaccum won't dive and clean bottom of pool. ... Vacuums

Cleaning solution does not come out of the rotating cleaning head or the hand-held nozzle the solution pump seems ok but does not run (electrical continuity check between the two leads on the pump show very low resistance so they seem to be intact) - no dirt or blockage is apparent (it is a very simple device with 1 moving part wires to the pump also pass a continuity check THERE IS NO VOLTAGE on the pump leads from the control circuit board when I turn on the "manual" cleaning mode - a

You can contact Bissell directly at the following\015\012\015\012For UK inquiries:\015\012Monday - Thursday 9 am — 5 pm\015\012Friday 9 am — 4 pm\015\012\015\012BISSELL Homecare (Overseas) Inc ... Bissell SpotBot Robotic Wet/Dry Vacuum

My roomba 530 runs in a circle and does not move forward. After 2 minutes it stops with 11 beeps and a flashing red light to the left of the power button. It has no clicking noise. Does anyone know what is the problem?

Hey'\015\012This means Roomba is not registering obstacles. Roomba may be stuck in one place.\015\012Roomba may be in extremely large room, try setting up virtual walls to create smaller area.If Roomb ... Roomba Robotic Floor Bagless Vacuum

My Roomba 4210 plays the dead battery song 10 seconds after I press Clean, Spot or Max. But I notice that I can put my roomba in diagnostic mode (with brushes, wheels etc) for long periods of time with plenty of strong power. Why won't it clean for more than five seconds without that dreadful tune, flashing power light and an amber status light?

... Roomba Robotic Floor Bagless Vacuum

Roomba 560, the small red light above the schedule button will not reset and the roomba will not run. The problem started when I the roomba sat dead for 12 hours. I tried the spot dock reset trick with no luck. The clock and sunday light stay let also.

This work ok for me ihave a 560 thanks ... iRobot Roomba 560 Robotic Vacuum

Roomba just runs in small circles - iRobot Vacuums

I just recently had someone bring in a roomba discovery and all it would do is stay in a tight 4 tile area and go in circles. battery was fully charged and all bumpers were clear.\015\012\015\012i took a can of air blast for cleaning comp ... iRobot Vacuums

Roomba just runs in small circles

It's little brain is having a seizure. Really! It's a programming fault. If you look on the machine, usually the bottom, you'll find a 1-800 number you can call and they have a solution for it. It's fairly common for this to happen and it cannot be s ... iRobot Roomba 4210 Bagless Robotic Vacuum

My roomba now just spins in circles in one spot. it does not go anywhere.

Try blowing out your bumper with compressed air. Tap the bumper with your hand to knock loose any obstructions. Then run your Roomba. If the behavior persists, the best way to resolve it is to call customer support. (The number should be in your docu ... iRobot Roomba 560 Robotic Vacuum

My roomba runs in circles - iRobot Roomba 4210 Bagless Robotic Vacuum

Try using a leaf blower, up close and all around. I was having problems with (I assume) the sensors under the bumper and (maybe) the wheel sensors, but after blowing it out with a leaf blower it works fine. ... iRobot Roomba 4210 Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0599 seconds