Having problems with your iRobot Roomba 550 Vacuum ?

Roomba goes in a circle moves about 5 inches and then turns in a circle again. It won't dock or go any farther than a few inches before turning in a circle again. The roomba has been cleaned inside and out. All hair and debri as been taken out of the wheels and brushes. i opened the case and cleared all the debri and i dusted the sensors in the front. Not sure what to do now.

Answers :

Repair Help & Product Troubleshooting for iRobot Roomba 550 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Roomba goes in a circle moves about 5 inches and then turns in a circle again. It won't dock or go any farther than a few inches before turning in a circle again. The roomba has been cleaned inside and out. All hair and debri as been taken out of the wheels and brushes. i opened the case and cleared all the debri and i dusted the sensors in the front. Not sure what to do now.

... iRobot Roomba 550 Vacuum

Roomba only circles back and forth in a very small area as if something is stuck. I have cleaned and cleared all the lint and hair from all wheels and it continues in small semi-circles, moving only a few inches.

Either the infrard sensor is defective or the steering is defective ... Roomba Robotic Floor Bagless Vacuum

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A

This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

My fully charged Roomba 560 just moves a few inches, cleans spins in a circle then stops and a red exclamation point appears. (I've misplaced the manual help !

You have dead nimh (nickle metal hydride) batteriesYou\012will need a replacement. You can test for this by removing the battery\012and holding the power button for 15 seconds. This will restart the\012charging cycle as if the battery we ... iRobot Roomba 560 Robotic Vacuum

My 550 roomba will not go forward or dock. It just turns in circles and occassionally moves backward a few inches.

... iRobot Roomba 550 Vacuum

For my roomba 540 the dock station light is on. To dock the roomba goes towards the dock but when it reaches the dock tries to find the metal contacts, goes over them but is unable to dock. It used to dock fine. I did open the roomba to check its battery but I think it still worked after I opened it.

... Roomba Robotic Floor Bagless Vacuum

Model UH60010, Series X12.0, Mfg code K09A. While attempting to use the hose and the extensions to clean shelves, my wife reported no suction. I removed the brush roller and the plastic piece just below where the hose opening is located and saw a "flapper" door that was closed and had some debris sort of jamming it. I removed the debris, but the door requires extreme pressure to open to permit the dirt, etc to moved up thru the opening , through the hose, etc. I thught maybe that somehow tg

Hello,Check to make sure\015\012the dirt canister is empty. If dirt canister is full, then you will \015\012experience\015\012reduced suction. Empty dirt receptacle.\015\012 Could\015\012 be a clogged hose - ... Vacuums

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.

Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

Roomba turns in circles going one direction and then another but can not go forward in a straight line. Aftter a few moments of going in circles, it cuts off and says inspect and clean roomba's wheels. We have done that 5 times and to no avail.

... iRobot Roomba 530 Robotic Vacuum

My roomba 530 keeps on circling around. What can I do?, just runs in circle. It's new and everything is cleaned. It was fun for three cleanings and then started that circle dance.

... Roomba Robotic Floor Bagless Vacuum

My roomba goes round in circles. sometimes it stops and moves a centimeter backwards and then again it goes round in circles. if you press the ,,dock'' button it goes back to the station. if you press the ,,clean'' button, again, it goes round in circles.... the machine is cleaned, the sensors aren't covered with dirt, the weels and brushes can rotate freely.... can anybody help me??? thanks in advance franz

Here's the link. IR Bump Sensor Fix ... iRobot Roomba 560 Robotic Vacuum

Roomba wont stop going in circles,code 9 comes up, cleaned front caster wheel to no avail. 500 series roomba. called company said we need a new one, if this is the best we can get out of a roomba they are junk.

\015\012\015\012Your bump sensors are malfunctioning. The best thing to do is order a repair kit. I ordered mine from EESolutions.ca and it worked great.. ... iRobot Roomba 560 Robotic Vacuum

Roomba that is 6 years old has started spinning in

Sounds like it is stuck in the "spot clean" mode. Are you familiar with this command and sure that you are not pressing it? If so, there is not much else left to do as iRobot doesn't give much repair help. All they do is offer an upgrade to a more ex ... Vacuums

Roomba 770 keeps spinning in circles

... Roomba 770 Robotic Vacuum

My roomba pro elite just goes around in a circle. how can I fix this? I have cleaned the roomba as thoroughly as I can. Could it be a recently changed wheel tread?

The infrared sensor circuit has failed, u will need to have it repaired ... Roomba Pro Elite Bagless Robotic Vacuum

I am replacing drive belt on Eureka 4870 upright. Before installing I removed bottomplate and was cleaning out accumulated lint, hair and grit. Found a pair of identical (reciprocal) felt gaskets sucurely inserted above and below the roller brush, and one small loose piece of felt approximately 1/3 inch wide by 1 inch long that came out as I was pulling out debris. It has a slight crease across the middle as though I was not resting on an entire flat surface, but I find no other clues as to wher

If you go to this URL:\015\012\015\012http://www.VacPartsWarehouse.com/Eureka-4870-Ultra-Smart-Vac-s/1928.htm\015\012\015\012in the exploded view of the unit, identifying the parts and look at item 18, I believe it is where your felt part ... Vacuums

The roomba or I robot will upon pressing the start button go around in circles, than starts to goin one direction, than stops and goes in a circle. The unit is clean and the unit reset. Bill

Is the front bumper **** in? ... Roomba Vacuums

Roomba 530 I have a problem with my robot roomba 530. IN fact after 2 minutes, i start to "dance" in circle and stop and the red light is on and 9 beeps.....i don't know what to do....thanks a lot for your help Christophe

Hey\015\012\015\012Please look for other same problem posted here ;-)\015\012\015\012You are probably facing a bumper sensor issue.Try to clean the bumper first and if this goes on, either call ... iRobot Roomba 530 Robotic Vacuum

Roomba discovery runs in jerky circles - Roomba Vacuums

... Roomba Vacuums

I have a roomba 530 pet series. It appears that the brushes aren't turning. They are free of dirt and debris and move easily when manually turned. But, You can tell there may not be a motor turning, because the roomba is more quiet than normal when you turn it on. Also, the hair just collects along the bottom of the brush and doesn't get pushed into the bin.

The belt either broke or has come off the track.... this should be easily accessable from the underside of vaccuum ... iRobot Vacuums

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug

Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Roomba 560 goes in circles. appears lost - iRobot Roomba 560 Robotic Vacuum

I had the same problem. This is the 9-beep error. It goes in backwards circles. Pretty much a bad component in your Roomba, makes it think that it is constantly in collision mode. This makes it go backwards in circles. I fixed mine using this ... iRobot Roomba 560 Robotic Vacuum

My roomba seems to have circling disease as it only goes in circles. I have cleaned the sensors (and anything else I could think of).

... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

My roomba runs in circles - iRobot Roomba 4210 Bagless Robotic Vacuum

Try using a leaf blower, up close and all around. I was having problems with (I assume) the sensors under the bumper and (maybe) the wheel sensors, but after blowing it out with a leaf blower it works fine. ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba red 4100 cleans in small circle stops starts agains cleans small circle stops then status light comes on and clean button blinks.

When the status light comes on, the Roomba is going to sing "uh-oh," and then beep a number of times. Count the beeps. They're a code that tells you what's wrong with the Roomba. You can check iRobot's website for a chart of beep codes. Search "What ... iRobot Roomba Red 4100 Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1103 seconds