Having problems with your iRobot Roomba 560 Robotic Vacuum ?

Hello the problem i have with my roomba is? it

\015 Hello the problem i have with my roomba is? it stays in one spot for a while then the voice comes on and says please remove and clean roomba wheels\015

Answers :

The best course of action is to do as it says and remove the base plate and the wheels and clean them. Don't neglect the caster in the front when you clean the two drive wheels.
Repair Help & Product Troubleshooting for iRobot Roomba 560 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello the problem i have with my roomba is? it

The best course of action is to do as it says and remove the base plate and the wheels and clean them. Don't neglect the caster in the front when you clean the two drive wheels. ... iRobot Roomba 560 Robotic Vacuum

Roomba Stops I've had a Roomba for about 2 months. Lately, it runs for about 45 secs, then stops, makes a two-tone (descending) sound, and flashes the CLEAN button while the STATUS button is red. I've emptied the dustbin on it. Can you help? I am seeing the same problem on my roomba today. I cleaned all that I could., the brushes, the pins on the sides and all that and it still gives the same problem..Any other fix?

Run your roomba through a self diagnostic test. I have posted the link below. Tell me your findings.\015\012\015\012\015\012http://mysite.verizon.net/gsplews/Diagnositic-Tests_Proc.v.0.5.htm ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have iRobot Roomba 4210 and I have a problem with charge battery. The battery is new. When I charging a battery in other iRobot Roomba the battery was full charged. When I charging in my iRobot Roomba the battery was empty. My fast charger is OK.

The charging circuit on the main board is fried. This is a common issue. You need some good electronic repair skills, and equipment, to replace the problem components ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba 560, the small red light above the schedule button will not reset and the roomba will not run. The problem started when I the roomba sat dead for 12 hours. I tried the spot dock reset trick with no luck. The clock and sunday light stay let also.

This work ok for me ihave a 560 thanks ... iRobot Roomba 560 Robotic Vacuum

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

Windtunnel Hello: I was reading thru another readers problem of power to vacuum but won't turn on. Same problem for me. All hoses are free of clogs and I have the vacuum basically taken apart as far as I can. You state a THERMO by the motor may be open. What does this part look like? Thank you. Craig

The thermo is a small square piece with two wires coming out of it. Did you check the switch? The switch has a high failure rate. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I bought Roomba 560 robot vacuum cleaner about 3 weeks ago and it has been cleaned without problem all kind of positions of floors (also carpets) Last friday I anyway mountained nearby of outcoming door the black carpet. Now the situation is that Roomba doesn't move and clean above of this carpet. What is the reason and how to solve it ... ?.

Ok, take regular WHITE paper. Do not press it on the sensor, just make it long enough so it covers the sensor. Then, take some clear tape, and tape the piece of white paper over it. Watch for the wall brush and stuff, don't get it to close to them or ... iRobot Roomba 560 Robotic Vacuum

Roomba 530 I have a problem with my robot roomba 530. IN fact after 2 minutes, i start to "dance" in circle and stop and the red light is on and 9 beeps.....i don't know what to do....thanks a lot for your help Christophe

Hey\015\012\015\012Please look for other same problem posted here ;-)\015\012\015\012You are probably facing a bumper sensor issue.Try to clean the bumper first and if this goes on, either call ... iRobot Roomba 530 Robotic Vacuum

Hello, Last night my Roomba got stuck on a blind cord and now it keeps repeating Error move roomba to a new location and I've done it a dozen times, it still won't work. I've checked the wheels and are fine. What's wrong? Thanks

... Roomba Vacuums

Hello! I have a problem with my Tefal Sensio scales. They are now probably around four years' old and have been in perfect working order up to now. Well, I had some problems before - the moment I'd step on them, instead of going into "calculating mode" as they usually do, they would show the number 92 straight away and then the display would change into some strange symbols (please don't laugh here :-) - my weight in kg is 55, my husband's around 80 and each of us gets 92 reading). Previo

... Vacuums

Roomba 531 docking problem - iRobot Roomba 530 Robotic Vacuum

... iRobot Roomba 530 Robotic Vacuum

I have a similar problem as many do with this model, "clean Roomba's brushes".. We took it apart last night, cleaned out all of the dust we saw. we removed the cover, the housing for the brushes and everything else we could. Still has the same problem. What now?

Mine did the same thing and no mater how much I cleaned the brush or pulled fibers of the ends it did not stop until I:Removed the little yellow tabs on the ends of both brushes and used a tooth pic to remove the built up inside the bearing ass ... iRobot Roomba 530 Robotic Vacuum

Hello, I have a problem with my Eureka Powerline bagged upright vacuum. It has a 12 amp motor and is model #4352, Type D. It was probably bought new in 1998. My problem is, while vacuuming today the motor seemed to slow down all of the sudden and then began smelling like burning rubber. I shut the vacuum off to check for blockages but could not find anything blocked. When I then turned it on again it runs but seems to only be running at 1/2 the motor speed and still has the rubber buring smell.

It sounds like a rubber sealing in the motor has come loose and is being constantly rubbed against the walls of the motor with would cause the smell and loss of motor speed caused by the fricton of rubber against the rod so if you can get to the moto ... Vacuums

Why does our Roomba says there is a problem with the brushes even after they have been thoroughly cleaned? It will run a minute maybe then tell us there is a problem, check brushes.

You need a new battery if you have done the battery reset,and then leave the unit on the charger for 16 hours straight if the problem continues after the charge you need to get a new battery ... Vacuums

Charge light on roomba won't come on when charging. Light on charger is on and shows unit is docked, but no light comes on roomba red unit itself. Is this a bad battery or problem with unit itself??

... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Problems with roomba 530

Before taking apart your Roomba read this!!! First to see if it is a defect or really the brushes, take the brusehs out and run roomba with out them. If you still hear the clicking/ thumping then try taking it apart or call roomba. But ... Roomba Robotic Floor Bagless Vacuum

Hello, I have an Electrolux vacuum. In desperation, I vacuumed up some water and my machine stopped. I am hesitant to take the machine to a repair place for fear that if it is a simple repair they will not be honest. Can anyone give me advice on whether this is a problem that requires a new motor or major repair? Thank you!

Although it's never to be recommended, it is sometimes possible to vacuum up a little water without doing significant damage. However, the fact that your machine then stopped suggests that the electrics got wet. That may or may not have caused expens ... Vacuums

I have a roomba 530 and the brushes don't spin what is the problem i took it all part and cleaned all the hair and dirt and it still won't turn?

The cleaning head module electronics are probably burnt out, this is not terribly uncommon. Your best bet is to contact Salton and purchase a 530 replenishment kit (http: ... Roomba Robotic Floor Bagless Vacuum

My roomba 530 runs in a circle and does not move forward. After 2 minutes it stops with 11 beeps and a flashing red light to the left of the power button. It has no clicking noise. Does anyone know what is the problem?

Hey'\015\012This means Roomba is not registering obstacles. Roomba may be stuck in one place.\015\012Roomba may be in extremely large room, try setting up virtual walls to create smaller area.If Roomb ... Roomba Robotic Floor Bagless Vacuum

Roomba Red Problem

Mine did a similar thing. I kept trying to use it anyway, when it made a violent jerk (I thought it had broken something) and it started to work again.\015\012\015\012Have you tried pressing both buttons at the same time to make it go st ... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Dyson DC04 hello, my dyson seems to run ok in upright but when i tilt back the motor sounds like it is struggling, do you think it's down to the rollers being to low and can you adjust height of rollers to overcome said problem? yours chris

Hi.\015\012\015\012If the motor is struggling check to see how easy it is to rotate brush by hand it is stiff to rotate the bearings in the roller may be siezed or the roller could be clogged with hair etc check it & let me know what ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Hello. My dyson dc04 keeps making a loud screeching noise when im vacuuming. It seems as though the plastic from the brush is catching on the plastic on its holder either side of the belt. Is there any way of fixing this problem?

Remove base cover by 3 'screws' 1/2 turn anti clockwise and clean well remove fibres replace cover and re try. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Roomba red problem,

There should be 2 quarter sized sensors on top/behind the brush that detect granular objects. I'd try cleaning those off. they might need to be replaced though. ... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Hello I can not find my manual for my vax vs19 swift vacuum cleaner and I am having problems with the cleaner not picking up. It is a 1600w machine and is fitted with a hepa filter, my son took it apart and without the manual it is difficult to reassemble not sure if he has put it back together properly.

Check out this site;\015\012\015\012http://www.vax.co.uk/support/vacuum-cleaner-user-guides\015\012\015\012Scroll down to the one that's applicable. ... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0323 seconds