Having problems with your iRobot Roomba 560 Robotic Vacuum ?

560 moves away from dock appears lost

\015 560 moves away from dock only a foot or so and then spins around in a circle goes forward a few inches and the spins around again appearing to be lost. unit is 16 months old. Have cleaned all brushs, wheels, filter and reset software. What is the most likely problem and best solution to rectify same?\015

Answers :

Hey gsaban
does it sing 9 beep when it stops ?
if it does, you are facing a known issue of bumper sensor fail.
See this page and other 9 beep threads on FixYa

have fun
Repair Help & Product Troubleshooting for iRobot Roomba 560 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

560 moves away from dock appears lost

Hey gsabandoes it sing 9 beep when it stops ?if it does, you are facing a known issue of bumper sensor fail.See this page and othe ... iRobot Roomba 560 Robotic Vacuum

My Roomba Discovery doesn't appear to hold a charge

Cor2an,That sounds like a classic battery failure in the Roomba discovery series. There are sensors inside the battery pack that go bad too. Either way...it's not very practical to repair the battery....the best shot you have would be to orde ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Lost suction my DCO7 lost suction in the hose I started taking it apart and cleaning it and looking for clogs (probably more than I should have) and when I put it back together it has awesome suction in the hose but no suction in the base. It just pulls the pine needles up (christmas tree) but they never appear in the "bag" compartment and when I look they are just all gathered in a clump in the bottom by the brush.

Hi.\015\012\015\012Remove the sole plate turn the 3 plastic screws to unlock & lift off.\015\012\015\012Now remove the blockages that have accumilated from the oppening of short clear hose.\015\012Check you can turn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have the Janome 6600 P. Beginning a seam the thread knotted and the machine made noise and needle would not move either up or down. I manually moved the needle using the handwheel and cut away the knotted thread. I began sewing again but instead of starting at the edge began about a half inch down, forward stitched, reversed to lock threads and problem repeated and received the message to "Stop for safety purposes". Did that. Referred to the manual, tried manual recommendation. Did not work. I

... Vacuums

Bumper sensor appears to malfunction - machine moves 6-8 inches and reverses just as if it ran into an object, then it moves 6-8 inches and changes directions again, over and over. if i count correctly, the error beeps count to 8 or 9 (they come too fast!).

... iRobot Roomba 550 Vacuum

Kirby Sentria Hi, I have a new Sentria & used it for the first time today. It was going fine & then I could smell smoke & it started to make a loud noise so I turned it off quickly. If I turn it on it immediately starts making the noise again & I can see it is all lit up inside like something is burning or sparking. I have checked the roller & it is moving & I have checked the fan which is moving & doesn't appear to be damaged in anyway. This product is from the US & we are in the UK & we are us

Sounds like the motor burned up. not sure if travel adapters will handle a large load like a motor, around 8 or amps. power needs in US are 110 volts ac, 60 hertz.I believe UK is 220 volts and 50 hertz. usually when a vac is brought to eu ... Kirby Vacuums

Sewing machine Viking emerald 183 lost manual in move. how to move needle position from side to side within foot ? Any on line manuals? TU ---gina

... Husqvarna Vacuums

I have a Hoover Elite Rewind model #uh71009. We moved recently and it was jostled around and the red power switch popped out. I put it back in but it's stuck; it stays either left or right, it doesnt move back and forth. It appears there may be another piece missing from the power switch...all I have is the red switch and a tiny cylindrical metal tube with a spring on one end. This piece fits into the hole on the red switch. Inside the vacuum itself where this goes, there is quite a large cavity

... Vacuums

I bought a spot scrubber and when i moved i lost the operating di

Check also teh following link:\015\012Please read these instructions carefully before using your Spo ... Dirt Devil SE2800 Spot Scrubber Handheld Wet/Dry Vacuum

Purchased a shark steamer couple of years ago..not used yet..lost instructions in a recent move.. may I possibly have a duplicate set of instructions??

Rich was kind enough to let me download a duplicate manual.\015\012Thanks for the help Rich! (Plus it was free) ... Euro-Pro S3325 Handheld Steam Vacuum

I need a charger that I have lost in moving: Ad-0920-ul It is for the Shark upright. Thank you would be so greatful if you can find this for me. from California, Jae

I have a charger that is lableled\015\012Shark V1917 APL1172 AC Power Adapter \015\012Model KA12D120015023UAC Adapter Power Supply for models V1917 & APL1172\015\012if this will work for you please let me know and we can ... Euro-Pro S3325 Handheld Steam Vacuum

Lost the instuction book when I moved - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Hello,Here is a link to the Bissell website. You'll see the search box.Enter your model number. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Where can I get a charging cord for this. I lost it when we moved. What is the charging output?

It looks very much like a black and decker try one of there store's ... Oreck ElectrikBroom AV-701B Handheld Vacuum

I have a BC-A41 vacuum cleaner which has been working well, but now it appears to blow stuff away from the cleaner as I hoover. I find the hose packed up with stuff, but no content in bag. I recently changed the bag...could it be that the bag is not fitted correctly..I am puzzled by the instruction to put the bottom under the rib. I am a pensioner on my own, and would welcome any help. Thanks, Jim

I think there should be some probem in the vacuum section..its failing to **** the objects ... Vacuums

I have a roomba 530 pet series. It appears that the brushes aren't turning. They are free of dirt and debris and move easily when manually turned. But, You can tell there may not be a motor turning, because the roomba is more quiet than normal when you turn it on. Also, the hair just collects along the bottom of the brush and doesn't get pushed into the bin.

The belt either broke or has come off the track.... this should be easily accessable from the underside of vaccuum ... iRobot Vacuums

The hand held dyson does not appear to charge. does the battery come away from the unit as I can't seem to release it? Would there be any point in buying a new battery as I don't know if this is the problem. The red light stays lit all the time it is on charge and when I take it off the machine does not respond at all.

The battery is located at the bottom of the handle. To release it, press and hold down the button on top of the battery case (it has 3 ridges on it). That releases a catch and you can then slide the battery out to the rear. This can be quite ha ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Lost operation manual for my Roomba 2.1 in our recent move. Item was purchased in Aug 2007 at Costco. Where can I get a replacemnet operation manual through a free download? Thanks in advance for your assistance.

... Vacuums

I want to install a new hose on a Sears vacuum Mod #116.23812300. How do I remove the Hose Connection Cover(#4370325)? It appears to be a flexible plastic part, however, it will not move from it's position on the old hose.

Hi,\015\012\015\012Please CLICK HERE \015\012This guide will explain you how to replace the hose.\015\012\015\012Goodluck.. ... Vacuums

My Panasonic performance plus platinum vacuum cuts off and on while using the beater bar, this doesn't happen at all using the stair cleaning attachment. It appear electrical contact is being lost where the lower plug makes contact.

The solution to my problem which is located at the lower electrical plug on the long wand was to expermint using a nickel and placing this in an area where the long wand connects with the beater bar section, here there is a gap which allows too much ... Panasonic Vacuums

While cleaning, the vacuum sucked up a nail and I suspect it may have punnctured the hose from the vacuum base to the uppper cannister. The reason is that it appears to have lost its suction power and nothing gets into the fliter cnnister area any more. How do I replace this part ?z?

You will have to basically split the vaccume in half to gain access pulling the plastic covers off.usually philips head screw/ ... Bissell 6591 Power Trak Revolution Bagless Upright Vacuum

Lost Part I have a 6.5 hp 18 gallon shop vac ultra pro. There is a part that goes into the inside of the tank and screws into the collection hose that attaches it to the tank. This part accidentally got thrown away when someone dumped it and now I cannot attach the hose to use the vacuum. Can this part be purchased separately?

I found a manual online for the shop vac and found the part number. Did locate part online.\015\012Thanks, ... Shop Vac Vacuums

I lost the attachment while moving. Where can I get replacement parts?

Www.vacuums24x7.com/dirtdevilparts. ... Dirt Devil M088905 Vision Bagless Upright Vacuum

I just purchased a Dirt Devil machine on Monday, I finally got it put together today and the brushes are not moving, dust is swirling around but no brush movement, I have changed all the nap settings, nothing, I am having company tomorrow and I threw my other vacuum cleaner away, HELP ME. Thank you.

Sounds like you may not have the belt attached or it is broke. ... Dirt Devil Vacuums

Frozen top The top of my Shark sc505 is on so tight that I cannot get it off even with heavy duty tools. It appears to be frozen and will not move. How can I get it off so I can use it again?

I just bought one from a thrift store we were able to get the top off! We used wd 40 and vice grips and it came off. The machine looks like it was only used once and someone left the water in it. I immediately put white vinegar in it and rinsed it ou ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

My vacuum is not sucking theirs a yellow pellet that indicates the air flow. And when i turn it on it moves and i think thats part of the problem i don't know what to do i lost my manuel help.

Try emptying bag. then clean filter. then unblock hose using a broom handle. let us know how it goes. ... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0476 seconds