Having problems with your iRobot Roomba 560 Robotic Vacuum ?

My roomba is about two years old. I have not used it very much. It has been on the battery charger all of the time. It had been awhile since I had used it and I pressed the clean button and it left the dock, but will only go in a circle and after awhile, t turns itself off and the on/off button lights up. Any suggestions?

Answers :

I had this happen to my Roomba and it turned out to be a fried main circuit board. I called iRobot tech support to help get the diagnosis and they insisted on sending me a wheel module for me to swap in but that didn't work and when I called back in to report their solution was a flop I had to go through all the trouble shooting again before they agreed to ship a replacement robot (I was in warranty when I first called in about the issue but it had expired by the second call explaining their resistance to sending a replacement).\015\012
\015\012There are some other possibilities but before that remove the battery and, with the battery out of the unit, press and hold the power button for 5 or so seconds, reinstall the battery and try again. if you're still spinning in circles I'd recommend purchasing a replacement wheel module from the iRobot site. While your waiting for it to arrive you should probably give the robot a good cleaning. Use compressed air to get into all the tight spots. DO NOT USE LIQUID. a damp cloth to wipe down the unit is ok... kinda.\015\012visit robotreviews.com for details on your robot.\015\012
\015\012Cheers,\015\012 immorion
Repair Help & Product Troubleshooting for iRobot Roomba 560 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My roomba is about two years old. I have not used it very much. It has been on the battery charger all of the time. It had been awhile since I had used it and I pressed the clean button and it left the dock, but will only go in a circle and after awhile, t turns itself off and the on/off button lights up. Any suggestions?

I had this happen to my Roomba and it turned out to be a fried main circuit board. I called iRobot tech support to help get the diagnosis and they insisted on sending me a wheel module for me to swap in but that didn't work and when I called back in ... iRobot Roomba 560 Robotic Vacuum

My roomba 530 runs in a circle and does not move forward. After 2 minutes it stops with 11 beeps and a flashing red light to the left of the power button. It has no clicking noise. Does anyone know what is the problem?

Hey'\015\012This means Roomba is not registering obstacles. Roomba may be stuck in one place.\015\012Roomba may be in extremely large room, try setting up virtual walls to create smaller area.If Roomb ... Roomba Robotic Floor Bagless Vacuum

Vacuum is completely dead. fresh bag, left it sit for over an hour. don't know where "reset" button is or how to check if a fuse on the device is blown. I did check house breakers and I also used several wall outlets. stumped.

... Eureka Oxygen 3 Ultra Canister Vacuum EL7020B

Nothing inn the canister after using,suctione working,bottom roller working,no air leaks from hoses.Also when running awhile it shuts off by itself,have to wait awhile to use again

I'm not sure what vacuum you have, but that sounds like a blockage to me. Thermal shut off kicks in, shutting the motor down, to prevent damage from overheating. After waiting like 1 hour it probably comes back on. Make sure hose, filters, bag (if an ... Vacuums

My TDK Clock Radio for iPhone & iPod (ADS-6P) freezes when I use the power button for the radio feature or try to set the alarm using the radio. Also using the ipod or iphone dock doesn't work. I have no idea what has caused the issue. Turning it off and on again doesn't help - it is still completely frozen and unresponsive to buttons pushed on the applicance one it has frozen. Can you help? I was given this item as a gift so I do not have the reciept.

... Vacuums

I would like to always use the GO TO button to go to a specific bible locatilon, but I more often get something else from the square and arrow button.. I would like to always be able to use the GO TO button. How do I do this each time that I wish? [email protected]

Hello\015\012What is it we are working on here?, need specific make and model number of device. You also have this listed under the category of "VACUUM PROBLEMS" is this where you wanted it listed? ... Vacuums

My roomba goes round in circles. sometimes it stops and moves a centimeter backwards and then again it goes round in circles. if you press the ,,dock'' button it goes back to the station. if you press the ,,clean'' button, again, it goes round in circles.... the machine is cleaned, the sensors aren't covered with dirt, the weels and brushes can rotate freely.... can anybody help me??? thanks in advance franz

Here's the link. IR Bump Sensor Fix ... iRobot Roomba 560 Robotic Vacuum

When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it

My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

We have a Bissell Proheat Cleanshot 2X Model 9500 Steam carpet cleaner. The first time we used it things were great. The second time we used it it left tracks in the carpet. We have no idea what caused this. We tried using the machine on an entirely different carpet and it did the same thing. After vacuuming the carpet about 10 or 12 times, the tracks are still embedded in the carpet - HELP!!!! We're read and reread the manual and contacted customer service and received no help.

First things first. It's only the second time you have used the machine, so it must be fairly new. If you have a receipt and the unit is less than a year old you should take it to an authorized Bissell repair center and have the machine inspected und ... Vacuums

REMOTE CONTROL IS MALFUNCTIONING & NOT TURNING ON CUSHION - Hello. I bought a used (by near new) Shiatsu+ Massaging Cushion from Ebay. When I installed it today the remote control was faulty. When you push the Power button, the blue light comes on, but none of the other buttons work. When you push the Power button again to turn it off, it clicks & turns itself back on again. So it's running but nothing is happening in the massage cushion. I did see a card in the box saying "For the Shiatsu

Before you use this cushion you MUST first 'unlock' the rollers which are held in place by a screw which MUST be removed or the unit will self destruct. The manufacturer provides a hex wrench to remove the shipping screw and a large label on th ... Vacuums

George i have just bought George from a friend and he has never used the wet side of things . When i turned the hoover on i cant seem to get the wet button to work. Do i have to have the hoover main button on first and then press the wet button?

The pump can seize up if the the system is not flushed with clean water after using carpet shampoo. You should run half a tank of clean water through Geroge before putting him away.The only solution is a new pump or pump motor. ... Numatic GVE370 Canister Wet/Dry Vacuum

I have a Eureka Mega Boss Central Vac Model # CV1801P. The suction works when the handle button is pushed left (floor mode) but no suction happens when the button is pushed right. When the floor attachment is hooked up and the button is pushed right, the brush rotates, but there is no suction.

... Eureka Vacuums

I set up my ONYX SW2300XS which I recieved as a gift (so no reciept) for the first time today. At first it was working well, I inserted a dvd and it played well. I played with the zoom and the skip buttons on the remote a bit and left it playing while I went a did other things. I came back about halfway thru my movie and wanted to skip scenes but the remote did not work. So I tried the NEXT button on the machine. This did nothing, so I tried the STOP button and that did nothing, the dvd was

Mine does the same thing! The store told me it would play all formatted but it does not! Its junk!! ... Vacuums

I have a bissell powerwash 1690 and there is no whine noise when I switch on the spray button like it used to, as I used to treat the carpet with the cleaner first for few mins before using the suction, but now no longer a sound when I switch on the spray - what could be the problem?

... Bissell Vacuums

I have a Dyson DC17 and I cannot get the detachable hose to pull up to use. I have tried pulling it up but it does not move and I can not use my detachable pieces. Is there a button I need to press - How do I fix?

Yes there is a button to release it near the handle i think , \015\012\015\012hope this helps ... Vacuums

I purchased a used Roomba 550 off of Craigs List and got it home and it just goes in circles. Am I doingsomething wrong? I used to own a cheaper model and it worked fine until it finally gave up the ghost.

... iRobot Roomba 550 Vacuum

Haven't used in awhile and want to know how to fill and use

... DeLonghi ST100P Steam It Canister Vacuum

The roomba or I robot will upon pressing the start button go around in circles, than starts to goin one direction, than stops and goes in a circle. The unit is clean and the unit reset. Bill

Is the front bumper **** in? ... Roomba Vacuums

Currently my dyson does not work when in the upright position. When I pull the handle back, it will run, but the suction is not very good at all. I tried washing the filter, but that didn't work. Sometimes it works for awhile, but then the problem occurs after the machine has been used for awhile. What do you think the problem is?

Hi its Darran at Dyson.It sounds as though the brush bar may not be turning properly when you put the machine into the upright position. To test, lie the machine on its side in the vacuuming position (head released) then switch it on and ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Sharp carousel double grill convection microwave oven R820JS/R820BC - the start button won't work when we try to cook in microwave. Can use timer, start button works, can set clock etc. but cannot seem to cook in oven.

... Vacuums

My upright kenmore progressive vacuum will not suction up when using the sweeper. It will suction things when I use one of the tools. I have put in a new bag and have tried to see if anything is blocking the bottom. It sometimes makes a very loud noise when I try to vacuum. If I press the intell clean on and off yellow button the noise may go away but it still does not work.

Double check hose placement, making sure you have the hose inserted into the correct slot. The long attachment nozzle stores in the front hole on the right, and the sucking hose inserts into the rear hole on the right. I know this is too simple of a ... Vacuums

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.

Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

I have never used a shampooer before when I use it it says to empty out dirty water. I don't have any left. My tank is empty. Am I doing something wrong.

Suggest that you do the following.\015\012Remove the TOP ("Clean water") tank. Fill it 1/2 full of water. Put the top on the clean water tank and place it back on the machine.\015\012\015\012Release the machine handle and remove the ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Check all filters, if they can be washed do so, if not clean or replace. next check for a clog in the machine and in the hoses. the machine as a thermal device that if it senses an overload or getting to hot, the machine will shut itself off for safe ... Vacuums

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm

I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7438 seconds