Having problems with your iRobot Roomba 560 Robotic Vacuum ?

9 beeps and only goes backwards. Is it fixable?


Answers :

Yes. This is from the iRobot website:

Why does my Roomba back up for no apparent reason?
\012\012If Roomba starts to back up for no apparent reason and plays the\012"Uh-Oh" sound followed by 9 beeps, the bumper may be stuck with dirt and debris.
\012\012Please try the following steps:
\012\012Gently tap both sides of the bumper several times to shake out any debris that might be causing the bumper to stick.
\012\012\012Try cleaning around the bumper with compressed air.
This is a known fault that can be fixed easily if you want to DIY.
you can see the step by step manual of fixing this Roomba HERE
have fun fixing your iRobot Roomba
Avi
Repair Help & Product Troubleshooting for iRobot Roomba 560 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

9 beeps and only goes backwards. Is it fixable?


Yes. This is from the iRobot website:Why does my Roomba back up for no apparent reason?\012\012If Roomba starts to back ... iRobot Roomba 560 Robotic Vacuum

Hi, my roomba560 goes one foot straight ahead, then turns right for halv a foot. stops, beeps four times, and the light goes red. I charged it up, measured the voltage to 16.6 on the battery.. same thing every time. Is it battery? i have cleaned it, gearbox, everything..


... iRobot Roomba 560 Robotic Vacuum

Irobot roomb will not work. I've discharged the battery and recharged for 16 hours. Acts like it is going to come on but sort od revs up and then gives a series of 6 or 7 or 8 beeps.. Goes so fast I cant count them. I've cleaned everything. Aftertyring a couple to Times, it seems that the battery discharges... Clean light goes red. Please help... i need this thing to work!,,


... iRobot Roomba 550 Vacuum

My roomba mounts up to the charger the light blinks red then after a time it goes green but when I dismount it and push the green button it immediately goes red. It doesn't beep or do anything. It is that the battery is not charging?


You have dead nimh (nickle metal hydride) batteries. You\012will need a replacement. You can test for this by removing the battery\012and holding the power button for 15 seconds. This will restart the\012charging cycle as if the battery were new. ... iRobot Roomba 560 Robotic Vacuum

It just goes in circles. It doesn't beep. Just goes in circles. I have had it about six months and have not had any problems with it.


You can compare with the video on this website: www.eesolutions.ca. They also sell repair kits to fix the problem. It sounds like you have the IR Bump Sensor Error/ 9Beep Error. ... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

My irobot goes backwards a short way, stops, turn, goes backwards some more, repeats the process over and over until it gets stuck. No beeps, no talking.


Your problem is the circle dance problem or 9 beeps errorsearch the site and you find solutions ... iRobot Roomba 530 Robotic Vacuum

My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.


... Roomba Robotic Floor Bagless Vacuum

I keep getting errors on my roomba 560 telling me that I need to remove and clean the brushes. I reset it and it goes for about 2 minutes and beeps again (and the brushes look fine) What am I missing?!


Try also cleaning all the filters ... Vacuums

540 Roomba goes in tight circles left and right after backing off charging base - stops and give oh-oh signal and 9 beeps - I have taken off bumper and cleaned sensors etc - blown out with air and still have same issue - unit will also not find or go back onto charging base - any suggestions /


... iRobot Roomba 540 Vacuum

I have a multifunction robotic auto vacuum cleaner model number XR210. It doesn't seem to be charging when at the docking station. The light is flashing on the docking station as if it was charging, but then I am getting intermittent noises like the vacuum is about to start up, then it beeps and goes silent again. I have emptied the machine. The display does not read 88 as if there is a malfunction, so I'm really not sure what's wrong with it. If I put the vacuum to the docking station the displ


... Vacuums

I have 2 #560 roombas. They both beep 9 times. I have replaced batteries and also cleaned the bumpers several times. Why does it beep 9 times?


Try this linkhttp://uksupport.irobot.com/app/answers/detail/a_id/880/?cc=uk ... iRobot Roomba 560 Robotic Vacuum

Powers on but will not run, goes BONK when button is pressed.


OK, I have fixed my Roomba!! First I went out and searched the web for Troubleshooting info. What I found was the diagnostics that the factory uses to test them. So going through the diags. I found that 3 of the 4 IR Sensors along the front were no ... Roomba Robotic Floor Bagless Vacuum

The Roomba goes around in circles. If it


Sounds like the 9-beep error. Google "roomba repair kit" to get it fixed. ... Roomba Robotic Floor Bagless Vacuum

My roomba goes round in circles. sometimes it stops and moves a centimeter backwards and then again it goes round in circles. if you press the ,,dock'' button it goes back to the station. if you press the ,,clean'' button, again, it goes round in circles.... the machine is cleaned, the sensors aren't covered with dirt, the weels and brushes can rotate freely.... can anybody help me??? thanks in advance franz


Here's the link. IR Bump Sensor Fix ... iRobot Roomba 560 Robotic Vacuum

Roomba Red 4100 goes for 5 seconds then stops


... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Im trying to put the peice back together that goes under the tube that hold the water the part that goes into the hole in the vacum.. i took it apart because its not spraing right to see if it was cloged.. and now im not sure how it goes back together.. can you please help me.....


I tried to find a service manual for this, but came up with only a exploded view diagram:\015\012\015\012http://ineedbags.com/images/b8920.jpg\015\0 ... Bissell 8920 ProHeat 2XTM Upright Vacuum

I am putting my bissel 8910 back together and behind the motor there is a black 3-way tubing connector. One side goes to the pump discharge, one side goes to a tubing going to the right rear wheel (facing the unit from the front) I don't know where the third side goes to. I do not seem to have another tubing for this one to go to? Maybe it is lost or ?


Hi, its hard to know what its for without seeing it. The best way to test this is to start the machine and vacuum a part of the carpet/ floor. Then let me know wht the vacuum is not doing. This will narrow it down. Please, get back to me. This sounds ... Bissell 8910 ProHeat Clear View Upright Vacuum

Self propelled vac: goes great on hard floor or hard slick carpet. Goes backwards fine but will not pull itself forward very well. Requires some effor to push it forward. I have adjusted the cable so the lever on the motor goes as far forward as possible. Suggestions? Model U6446-900


Dear Nasherrill,\015\012\015\012I've found a friend! I thought I was the only person in the world who owned the Hoover Model U6446-900! This model does not appear on the http ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My scooba seems to work fine but no longer makes the beeping noise. Several weeks ago the beep was sounding very strange almost like a battery was dying. Now it's not making any noise at all. Is this the beginning of more problems or can the machine function just fine without the beeps? If not then how can I fix it?


Your speaker went out. It could be totally isolated. You're not going to be able to determine what's wrong with your Scooba if something does happen, though, because without those beep codes, there's no way for the robot to communicate with you. ... iRobot 5900 Scooba Robotic Wet/Dry Vacuum

While replacing my power cord on my DC25 a spring popped out I have no idea where it goes. I need a diagram so I can see where it goes


Here is how the switch assembly should go together: ... Dyson DC25 All Floors Bagless Upright Vacuum

Sponge filter I have a kirby sponge filter for my Sentria shampoo system and dont know where it goes. It stop working and making foam. Kirby sent me the sponge filter saying this is what i need and i would know where it goes. I dont nor kind I figure it out. please help!!!!!!!


On the end of the shampoo tank where it attaches to back of motor where the bag is normally attached ... Vacuums

Vetus bcc 1000 inverter/charger When this unit is started it goes into overloadthe battery bank is new and we have isolated it from the narrow boat electics and pluged in a fan heater but still it goes into overload.


... Vacuums

I inherited a Simplicity 4380ED serger. It won't cut the fabric. I changed the lower blade for a sharper one. It is lying level with the throat plate. The upper blade is smooth. The fabric edge goes along the upper cutter and rolls over from the top and goes through the serge stitching.. No cut.


A tech on this site wrote this, when a similar model as yours was "mangling the fabric":\015\012Best Solution\015\012posted on Jul 07, 2009\015\012\015\012\015\012 \015\012\015\012 ... Vacuums

My Singer Advance #4722 beeps when i try to sew a butonhole. I have the presser foot on. I have set the smaller buttonhole setting but the machine only beeps


... Vacuums

MY ROOMBA BEEPS TROUBLE CODE 9 BEEPS--I HAVE INSPECTED THE BUMPER AND BLEW AIR AROUND IT BUT TO NO AVAIL AM I OVERLOOKING SOMETHINS THANKS


Heyyou did well, but it may have a fault bumper sensorsee this pageHave funAvi ... iRobot Roomba 560 Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0159 seconds