Having problems with your iRobot Scooba 380 Robotic Vacuum ?

Clean tank indicator keeps going off after tank has already been cleaned

Answers :

The Roomba is noted to cut out operating correctly. Remove the housing and blow out dust from all circuist and any dirt and dust inside the entire unit. It should work correctly afterwards
Repair Help & Product Troubleshooting for iRobot Scooba 380 Robotic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Clean tank indicator keeps going off after tank has already been cleaned

The Roomba is noted to cut out operating correctly. Remove the housing and blow out dust from all circuist and any dirt and dust inside the entire unit. It should work correctly afterwards ... iRobot Scooba 380 Robotic Vacuum

Cleaned all of the lines, shampoo solutions will go through but the water from the tank is not going through. the floww indicator will start to turn then after a second it completely stops. What is wrong with this thing?

... Bissell Vacuums

Asking again. Better wording? My lightweight Bissell carpet shampooer is continually spraying cleaning solution. The sucking action works well but can't keep up. This unit does NOT HAVE A HEATER. This is a simple unit. Is there a cable going down the handle from the trigger? ( it feels like that's the way it works. Could the drain be plugged. Also it will only use 1/2 a tank of solution at a time. Then must be filled again

Hi Sue. I understand how frustrating this must be. I'd like to help you with troubleshooting steps, but need more information.\015\012Here's a quick link to contact us: ... Vacuums

I have the Hoover max Extract 77 and when I'm cleaning the carpet, the clean water tank leaks on the floor, even if I'm not squeezing the trigger. The clean tank doesn't leak when I fill it, but once I place it where it fits and start using the vacuum, the clean water drains out on the floor. The dirty tank fills up, so the suction works, but, I don't know what is going on?

... Hoover Vacuums

Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan

Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Roomba Discovery Roomba is fully charged and cleaned with sensor wiped clean. When turned on it it sounds normal and commences to go, but it then acts like it is putting on the breaks, spins, tries to go and manages a short distance and breaks again, just not making any progress because it keeps breaking after a foot or so and turns and tries again. Sometimes is gets so stuck from moving forward at all, like it is stuck in one spot just trying to go while seemingly surrounded by barriers. Somet

I had the same back-up, turn, move forward a couple inches, backup-up, etc. problem. Try cleaning/cutting the hair, etc. out from around the brushes, as well as around the ends of the brushes. Also, try a Q-tip to clean out the four pair of sensors ... Roomba Robotic Floor Bagless Vacuum

My roomba won't go forward it just spins in a circle and will go backwards. I have already tried cleaning it out and cleaning the front bumper sensors.

This is the Circle-Dance Error. I had the same problem. I just ordered a repair kit from EESolutions.ca and did the fix myself. Works like new to this day. ... iRobot Roomba 530 Robotic Vacuum

My Irobot Roomba keeps saying that I need to clean Roombas brushes. I have cleaned the brushes...they are spotless. Still the Roomba will go for 2 minutes and shut itself off stating once again to clean the brushes. What up?

Perform the troubleshooting found at the iRobot website: http://tinyurl.com/nh5c8a (I promise that really does go to the right site.) That troubleshooting will enable you to determine exac ... iRobot Roomba 510 Bagless Vacuum

Runs but doesn't vacuum/****. Sidebrush works fine. Cleaned the roller brushes, and that seemed to confuse the robot and now it keeps going backward a few inches, turning, and then starts going backward again.

Sounds like a sensor problem. pull and clean the front black/white caster assembly and the revealed movement sensor and the 4 cliff sensors along the bottom of the front. Make sure the front caster wheel turns freely. You may have to remove the rolle ... iRobot Roomba 560 Robotic Vacuum

After cleaning the filter the self clean just keeps on flashing and will not go back to working mode

Check if it does reset when you unplug power, and by emptying completely the bag. ... Electrolux Vacuums

The roomba 560 keeps going in circles after it hits an object. Or it will keep hitting the object repeatly until you pick it up and move it. I have cleaned the sensors and wheels and it still does not work properly. Thank you.

... iRobot Roomba 560 Robotic Vacuum

My irobot scooba check tank light will not go off, I have tried cleaning everything, priming and the light still won't go off, someone please help me! hollie

... iRobot Scooba 380 Robotic Vacuum

UH70115 Model Red keeps going on, cleaned all filters , not dirt going into canister

... Hoover Vacuums

The water in my vax rapide powerjet pro v-028 keeps emptying when I let the trigger go until the tank is empty

... Vacuums

Roomba keeps saying clean brushes yet are clean!

Make sure you take off the little cap at the end (the one that spins -- just grab it and pull it straight off) and clean under it too. The rest of the brush may look perfectly clean but what happens is that hair gets stuck under spinning cap and, li ... iRobot Roomba 530 Robotic Vacuum

Bissell 1698-1 Solution applicator indicator (red spinner) does not rotate and no solution is being applied even though both the water and cleaning sol'n tanks are full and properly nested.

The heater is blocked wih lime scale ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

The soap is NOT dispensing. I'm cleaning with hot water only (pretty good in fact!) but the dispenser that used to go thru soap like there's no tomorrow has stayed at the same level for 3 tanks (at least.) Where do I check for a clog?

On the bottom and underneath the main water tank (depending on\015\012the unit) is where the lines are located. You can take and remove these\015\012rather easily. On newer models this is just opening clips others\015\012require screws. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

How do I reconnect tanks parts and adapter to return to floor cleaning mode? Just used it as upholstery cleaner, but can't get all the parts (3) to connect to go back to do floors

The front panel duct is tappered to go in only one way. The lettering embossed goes on the outside, and inserted until flush with the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks

This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Leaking problem I have a leak in my water tank. It only leaks when it is upright. And sometimes it doesn't let the water out when I go to clean. What do you think could be the problem

I had the same problem and it was a crack in the plastic near the small rubber valves that let the water out. After having two tanks crack like this I complained to Hoover about the poor design and they sent me a new tank with a new design fee of cha ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

The performance indicator light keeps going on. I've changed the bad and filter...any other suggestions?

It is probably clogged somewhere, if i was to guess check the hose. ... Kenmore Vacuums

I have used my Steam Vac for carpeting, but until today, had never tried cleaning upholstery with the spin-scrub brush. I spent a miserable afternoon trying to control the spray, which seemed to go everywhere AROUND the furniture, but not ON the furniture! Additionally, I never did get the water into the recovery tank, despite many attempts to connect and re-connect the hoses and recovery tank/lid.

I can sympathize. My vac came with two handheld attachments. I have better luck with the handheld attachment that doesn't have the spin-scrub pads. To keep the water from going all over the place, you need to keep the part the you hold only about 1 ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.

Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Water leak I just bought this steamer a few days ago, and already I am having problems, when I fill the water tank that your suppost to fill the water runs out before I even turn the machine on. I have tried using plugs to keep it from doing this just so I can shampoo my carpet, this seems to work to a point, considering the fact that there are two holes underneath close to the brushes and one just a little ways back from that location. Do you know if this is something that should have plugs or

If you just pruchased this, then it is under warranty, take it along with proof of purchase to a warranty repair shop and have them fix it. If water just runs out, then there may be a seal missing or a water line off. ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0591 seconds