Having problems with your iRobot Vacuums ?

How long are the batteries for virtual wall supposed to be working for? Even though I try to remove them after each cleaning , or use fresh batteries, the wall does not respond straight away. I can n

\015 If you could provide the estimate battery life would be very helpful. I'd try to remove and put the battery in more than a few times, but the green light starts to flicker then fizzle out. If I give up and leave it there, sometimes after quite a while light all of a sudden switches on and the wall starts working.\015

Answers :

Repair Help & Product Troubleshooting for iRobot Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How long are the batteries for virtual wall supposed to be working for? Even though I try to remove them after each cleaning , or use fresh batteries, the wall does not respond straight away. I can n

... iRobot Vacuums

I bought a roomba pro elite robotic floorvac at a tag sale from an elderly couple who apparently used this vac very little as it was very clean and she had never even used it enough to use the extra filters that came with it, she said it was just too much for her to bend down to work it or move it. i suspect she stored it but kept the battery in it. after charging it, it powers up and sings a little tune, but then shuts off. i cleaned everything, including the sensors. it still shuts off, do you

... Roomba Pro Elite Bagless Robotic Vacuum

I have a Hoover Elite Rewind vacuum. Actually,this is my second one. However, after about 4 months of use, it emits a "sour" smell when I'm using it. I empty the cannister before each use and clean out the filter monthly. My house has mainly hardwood floors, so I typically only use it on area rugs and 2 small carpeted rooms. Is there any way that I can get rid of the smell? I've tried putting a dryer sheet in the cannister, but this gets stuck in the filter mechanism. Also, carpet fresh clogs th

Does it smell like an electrical burning odor? could very possibly be the motor going bad already. ive seen it happen. but if not try freshwave odor absorbing pearls. i carry it in my store and we do have shipping. Truly the only thing you should use ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.

How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

My roomba is about two years old. I have not used it very much. It has been on the battery charger all of the time. It had been awhile since I had used it and I pressed the clean button and it left the dock, but will only go in a circle and after awhile, t turns itself off and the on/off button lights up. Any suggestions?

I had this happen to my Roomba and it turned out to be a fried main circuit board. I called iRobot tech support to help get the diagnosis and they insisted on sending me a wheel module for me to swap in but that didn't work and when I called back in ... iRobot Roomba 560 Robotic Vacuum

Our Bissell Cleanview II 3576M does a great job except that the filter cup below the dirt cup gets full very fast and the dirt cup barely has anything in it. To clean the whole house, I have to empty the dirt cup and clean the filter several times. It didn't use to work this way. It seems like something is missing, a gasket or seal maybe? I don't think dirt, hair and debris should be going straight to the lower cup and bypassing the upper. I looked at the user guide but can't see why it's happen

Contact Bissell Direct for a parts diagram and support at \015\012\015\012http://uk.bissell.com/EmailUs.aspx\015\012 ... Bissell 3576 CleanView II Bagless Upright Vacuum

Hi, my roomba560 goes one foot straight ahead, then turns right for halv a foot. stops, beeps four times, and the light goes red. I charged it up, measured the voltage to 16.6 on the battery.. same thing every time. Is it battery? i have cleaned it, gearbox, everything..

... iRobot Roomba 560 Robotic Vacuum

My dyson dc16 shuts off after 10 seconds its charged overnight but no good filters are clean but nothing I used it about 25 times a year .the batteries cost to much to replace for this expensive vac

Hi there,I'm sorry to hear you're having difficulties with your DC16. It's probably best if you get in touch with us directly, as we'll be able to run through some troubleshooting steps over the phone with you to establish the cause of this i ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

How do you clean the inner mechanisms of the steamer. I tried the instructions in the manual which basically said to put fresh water in a few different times to remove the scales. Can I use a vinegar

... Rowenta IS9100 Steam Cleaner

Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?

Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum

I have a ge light switch receiver rf1023, with incandescent bulbs, and when I try to switch it on it just blinks once and goes out. if I hold the switch on the battery-operated wall remote, the lights keep blinking until I let go. It used to work fine, and now it doesn't. I've lost the intallation instructions, so I don't know if there was a trouble-shooting section that covered the problem.

... GE Vacuums

I have a Kenmore 385.19110 model machine, and the straight and zig zag stitches work just fine, but when I follow the directions in the manual to do a satin stitch (which is use the lowest stitch length) it creates a line that isn't perfect, or uniform, and after an inch or two stops catching the bobbin underneath. Have already tried reinserting the bobbin, rethreading the machine, refilling the bobbin, changing the bobbin, cleaning the needle, changing the tension. Wondering if I just got a mac

... Vacuums

Electrolux 2-in-1 Pronto is losing suction. We've had it about 1.5 years, but lately it seems to be losing power. Not part of recent recall. Filters are clean. Need new battery already? We use it about every other day

Yes try new battery it sound like a power problem.thanks ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

After installing a new battery after not using Roomba for over 1 year it will not drive straight

Ok. What I would do is to disassemble the Roomba, clean both its wheels, Cleaning Head Module (including the gears) and the front bumper sensors. If after cleaning the front bumper sensors and same problem...you will need to replace the sensors. It's ... iRobot Roomba 4210 Bagless Robotic Vacuum

The electricity in the apt attached to my house lost power in two of the walls. It happened when the cleaning ladies I think were using a vacuum, they don't speak english very well so I'm not sure. I have looked at the circuit breaker a # of times and nothing seems to have been tripped. I have also inspected the outlets and they seem to be fine. Can you help me?

Even know the breaker doesn't look tripped it might be. You have to flip it all the way off and then back on again. That is most likely what has happened. If that doesn't work check to make sure a GFI hasn't tripped. They are usually loc ... Vacuums

Vacuum is completely dead. fresh bag, left it sit for over an hour. don't know where "reset" button is or how to check if a fuse on the device is blown. I did check house breakers and I also used several wall outlets. stumped.

... Eureka Oxygen 3 Ultra Canister Vacuum EL7020B

The clean water is leaking straight out through the bottom of the machine. This just started out of the blue. I cannot use the machine because of this. Any ideas?

It sounds as if the reservoir is stuck open. If you look behind the upper tank, you will see a rod that opens the reservoir when the handle release is squeezed. This part may need replacement. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover Jet and Wash 1500w S6254 001. Used once with great difficulty as assembly and use instructions are hard to follow.Now will not work as carpet shampooer at all, although assembly is correct as far as I can see and both motor and pump appear to be working and I am using the recommended cleaning fluid.Hoover website is no use at all in solving the problem.No cleaning fluid is being drawn up from the tank in to the cleaning fluid hose.There is suction from the suction hose so the problem appe

I am having the same prob my uncle got me one i cant find the manual anywhere to set it up the prob i have is where does the handle to make the water go out connect tooo ??? on the main pipe that sucks it back up i have tried every which way but not ... Vacuums

When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it

My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Evac Where can I get a battery pack? Haven't used it for a long while because the batteries wouldn't charge anymore and just forgot about it until I stumbled over it the other day. Can I still get a battery pack for this item or should I toss it? Money wasted because I hardly used it in the first place. Thanks for your help.

... Sharper Image Vacuums

Will over heat and shut self off. while using attachments to clean furniture, or if used for more than 20 minutes to vacumm floor have had since 2000. it is cleaned and check on a regular basis. any suggestions? hepa filter is also washed and cleaned on a regular basis

This sounds like an air flow restriction. Something is plugged somewhere, likely not the areas that you have already mentioned. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My bissell proheat 2x carpet cleaner is not spraying from the bottom or sucking up when turned on. The hand tool works just fine. I have made sure it was on floor cleaning when I used it to try and clean my carpet. the busshes are working but nothing else is happening this cleaner is about 21/2 years old and has only been used maybe 5 times so it has not had alot of use.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Sunbeam Model Number 4065-000 and there is white particles comming out of the holes in the bottom. I think it is because we used tap water and there is a lot of deposits in the water. I read on the box that it was ok to use tap water and not distilled water. Is ther any way to clean the inside out to get the deposits cleaned out without affecting the possibility of doing something to the cloths that I will iron after cleaning the iron?

If the deposits are recent and still fairly soft, running a tank of vinegar through the machine should remove the deposits (obviously not using on any clothes, hold it over a sink). if the deposits are more stubborn, you can use a cleaning agent like ... Sunbeam Vacuums

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr

Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Cleaning! To clean the cyclonic cone Dyson say to use can-air? that may be ok for computers but not to blow out the dirt and dust from the cone in question. Someone else here suggested to use a real compressor! Well dahhh I knew that! Should I do the blowing in the living room? or may be in the bathroom? Seriously what I need is an assy. drawing to take it apart and washing it Any ideas where I can get one? Thank you John

Hi, we realy love our Dyson, but get frustrated when it gets clogged with pet fur (2 cats and 2 dogs). This takes a little effort but what we ended up doing was taking the vacuum apart into its major components and alternately blowing it out, filter ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0706 seconds