Having problems with your Karcher Vacuums ?

Karcher K6.80 It pulsates on high pressure. What is the problem. Low pressure is OK.


Answers :

Karcher K6.80 how 2 repair
Repair Help & Product Troubleshooting for Karcher Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Karcher K6.80 It pulsates on high pressure. What is the problem. Low pressure is OK.


Karcher K6.80 how 2 repair ... Karcher Vacuums

Need instructions for 8qt pressure cooker, model 65999. All it has on lid is a dial which says 'open', 'low', & 'high'. If it had a pressure guage it wouldn't be a problem, but I have never worked with a pressure cooker with a low - high dial. Please advise.


Hello. Here is a complete set of generic pressure cooker instructioins http://missvickie.com/workshop/stepbystep.html\015\012\015\012J. ... Vacuums

I have a karcher 350 water blaster that has suddenly lost water pressure. the motor still works but no pressure. If i give it 10 or more seconds it builds up a bit of pressure but when i pull the trigger the high pressure only lasts for a 1/2 second blast then just normal tap pressure. Can anyone offer advice . thanks


... Vacuums

Karcher steamer has low pressure - Karcher DE4002 Steam Vacuum


... Karcher DE4002 Steam Vacuum

The Rainbow vacuum doesn't work on high speed, though it will work for low, what could be the problem?


... Rainbow E series Canister Wet/Dry Vacuum

Low steam pressure - Karcher DE4002 Steam Vacuum


... Karcher DE4002 Steam Vacuum

Karcher 4.91 m leaking a lot of water as soon as hose is turned on, also rsulting in low pressure. It's approx 15 months old and used approx 12 times. Stored in spare bedroom during the cold winter. Was fine beforehand and now not working having not used it for 3 months.


I could be that the rubber washer that is on the piece that the hose screws on to is dried out. Try replacing it. Any outdoor products store would have it. ... Vacuums

The e series rainbow 2 speed works only on low speed. High speed will not run. What is srong?


It is either the switch or the controller. Call us and we can see if it is still covered under your warranty.RainVacwww.rainvac.com800-523-0510 ... Rainbow E series Canister Wet/Dry Vacuum

Oreck trouble I replaced the plug and switch. black from motor to pole 1, black from plug to pole 2, white tied to white with a wire nut. When I plug it in it is powered in the off position. I have high speed at the high speed position, low speed at the low and off positions. Any ideas?


... Oreck XL Ultra Bagged Upright Vacuum

Low suction Replacing filters....need help replacing the belt - anyone know how? But before doing these things, have had a problem with suction....I'll let you know if the problem clears up.


Hi, You can take care of both things at once. Here's how:\015\012Unplug and flip your vacuum over, beater bar side up. Remove the cover base plate that surrounds your beater bar. It's held on with either clips or screws, and usually "hinges ... Eureka 2961AVZ Bagless Upright Vacuum

I have a power groom dual cyclonic vacuum. It is less than a year old. The belt is fine, It is not clogged. The brush rotates and it has suction. The problem is that it has the most awful high pitched noise now. Truthfully, the noise is so awful it makes you nauseus. What is the problem?


... Bissell 3920 Bagless Upright Vacuum

My Karcher B302 pressure washer runs as soon as it's plugged in, regardless of the switch position and there is no pressure save the increase due to the narrower outlet. Allen keys are too short to reach screws so I can't even look inside.


... Karcher Vacuums

The t racer on my karcher pressure washer is not spinning round, the water pressure is fine and the other attachments are working.


... Vacuums

I am trying to install a train air horn. i bought a viair compressor for it. the horns themselves have a 12 volt hookup going to what i believe is acting like a solenoid. when charged, you complete the circuit and walah, the horn blasts. the problem im having is when the compressor is building pressure, the air horn is automatically putting out a dull sound, getting louder as the pressure gets more and more. it sounds like its out of one horn however. it is doing that without the 12 v hookup. is


Hi! just a tip regarding the sound that comes up when building pressure. Is there a gasket or rubber seal on the horn? You may need to replace this for it may be worn. The air may be coming out of the worn seals resulting to sound even when not trigg ... Vacuums

Vacuum height won't go on low carpet setting. Dial will go on medium and high, but not low.


Make sure you're not trying to adjust w/ handle in upright locked position because thewre is a cam which raises the vacuum head a little bit when handle is locked in upright position. If this is not the problem, turn vacuum upside down with handle in ... Hoover Vacuums

Is there an adjustment on Dyson for high-low pile. Nothing cleans better but I'm handicap & can't push or pull Animal Dyson vacume over high pile carpet.


Yes there is an adjustment called a power cam. I am enclosing a link to show you exactly where it is\015\012\015\012http://www.dyson.com/homepage.asp ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!


The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

Henry vacuum high low switch does not work on low


... Vacuums

Low suction Have a Powr-Flite PF 18, suction is good at motor, but low at where hose comes out of top of vacuum. Could new lid seals help the problem? Where can I get new seals for this model. Also my zip is 98801 and my shop is not listed, could you add it please? Sew Creative 1139 N. Princeton Wenatchee, Wa 98801 509-663-5516 Thanks, Lauren-Sew Creative


Replacing the motor cover solved the problem, it must have been warped and was letting suction out thru it. ... Vacuums

My Shark S3501 Steam Mop generates a low volume of steam and low pressure steam. What must I do?


... Vacuums

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

Tristar zeus magnum shotgun change over from high brass to low brass shell


... Tristar Vacuums

Vacum works on low but not on high??????


Ur rainbow cumpiter has 8 years warranty call Rexair and give them ur seriel # u should be covered under warranty ... Rainbow E series Canister Wet/Dry Vacuum

Vax grimemaster..loss of pressure just low steam


... Vacuums

Clogged filter my problem is with the filter it is always blocked with hair and debris, it makes a high pitched sound when it is clogged up and i don't why but it is not going into the canister. i have an animal dyson. any suggestions?


I found that the rubber seal on the bottom of my cyclone is not properly seated to the bottom of canister, I guessed when I removed the clear canister bin completely from cyclone unit for cleaning, I put the cyclone down on the floor and rubber seal ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0462 seconds