Having problems with your Kenmore 22812 Bagged Canister Vacuum ?

Need to twist hose to keep power on

\015 When vacuuming, the power doesn't stay on. To keep it on, we need to twist the hose at the point where it enters the handle assembly to keep it turned on. Any suggestions? I took the handle assembly apart as best I could, but I didn't see anything obvious that was frayed or disconnected.\015

Answers :

The loose connection will be internally and in some cases is not detected visually.
\015\012Do you have any connector where they connect together?
You must changed the wire it could be damaged that why the power eventually cut off..
Repair Help & Product Troubleshooting for Kenmore 22812 Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to twist hose to keep power on


The loose connection will be internally and in some cases is not detected visually.\015\012Do you have any connector where they connect together? ... Kenmore 22812 Bagged Canister Vacuum

When I vacuum with the power nozzle, it keeps cutting off. Do I need to replace the hose or the power nozzle?


Not necessarily. It's hard to tell without checking it out. I strongly recommend taking it to an authorized Aerus Electrolux store and letting the service tech check it.\015\012If you have the "Sidekick", you can try using it. If it still cu ... Electrolux Epic 6500 Vacuum

The power head of my DC 21 keeps cutting off as soon as I start moving the hose around. The only way to get it going again is to step on the main switch on the canister, then the whole cycle of off and on starts again. I have replaced the entire power head and tested the continuity of all the wires in the hose and they are good. The repair shop says the PCB is bad but can not get one. What can I do ?


Not much. my only suggestion is to dig through the internet and try and find that pcb it may take awhile but it would be worth a shot. if you dont think you can make the repair take it to repair shop with new pcb and let them do it. ... Dyson Genuine DC-21 "Stowaway" Spare HEPA Filter, Dyson

I need to install part #PHP-236/C45ECUE. This is the connector in the top of the wand that connects the power to the brushes near the thumb switch at the end of the flexible hose. (Hope this makes sen


... Kenmore 22812 Bagged Canister Vacuum

Where do you hook the clear hose that is in the compartment with the motor ? Second where the vacuum hose connects to the bag it keeps cutting in and out of power. I replaced the female cord to motor and still cuts out."no suction "


Would you care to tell us the make and model of the vacuum you're asking about? ... Vacuums

Suction power level drops to zero, need to constantly readjust suction power from zero to normal operating level Appears to be some type of loose connection between hose coupler and base unit


Ok, so where as both of the solutions above are good, they will not solve your problem with the hose cutting off to 0, then having to turn it back on. \015\012\015\012This problem is caused by the static electricity which causes the hose ... Miele s558 Silver Moon Vacuum

HI, I have a Kenmore 25813 and it seems like there is an intermittent short. When I have the extension wand on and the power floor attachment on, when it rotate the wand the light cuts out and so does the power floor attachment, when I twist it back it comes on again. I don't have this problem if I remove the wand and just use the crevice tool with the hose. Any idea where the short might be and can I fix it myself? Thanks. Gary


This is common you may have a short in the contacts from the handle to the wand or a break in the cord that goes into the powerhead ... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Vacuum Problem My dirt devil vacuum is losing suction and keeps clogging. All the dirt keeps sticking to the screen by the filter and then it would stop working. Also the hose does not have a strong suction power either. So what can I do?


The Bissell can have several filters in it, depending on the model. Some have a round hepa filter that is covered with a foam sleeve. This filter is located at the bottom of the dirt cup. Others have a foam filter that is located under the dirt cup i ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

I need to get a owners manual for a Factory Reconditioned Power Boss 20344R 2,500 PSI 2.3 GPM 160cc Honda GCV Gas Powered Pressure Washer With 25-Foot Hose model # FO20296


HiIf this works I am a hero - is not I am sure I am a zero -but I think this is close enough to get the job done for you.http://w ... Vacuums

I need to take apart the electrolux epic 8000 hose power end


... Electrolux Vacuums

I have a very old electrolux, model 90. the power head keeps ging on and off as i vacuum. seems if i twist the wand it causes it to start and stop.


It sounds like you have a broken wire in your hose or in the wire going to your power nozzel (carpet sweeper).If not that, it could be in the insulator ( the part you plug the hose in the machine). Either way, you'll have to take it to your repair sh ... Electrolux Guardian Bagged Canister Vacuum

How can determine when it's time to replace the drive belt on my Bissel Power Steamer? Is there a certain number of hours of usage that I need to keep track of or does the belt replacement depend on the type of carpet I'm cleaning? Thanks, Jim


Usually, replacement is needed when the brush no longer runs or is intermittent. Check the brush bearings and for debris build-up whenever the belt is changed. Good luck! ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My dirt devil quick lite has lost it's suction power. I have checked all the hoses etc for clogs or debris.I bought it in Dec 2010. I think maybe it needs a new filter. Where can I find an F44 filter or do you have any other solutions?


... Dirt Devil Easy Lite Quick Vacuum

I am cleaning the hose to the underneath of the vacum. It is clogged. I need a picture from the manual to show how it all goes back in after i am done. I have a dirt devil quick power compact.. UD... something I have been looking for the manula online. unable to find it.


Go to the website below. Search for your product; either by model number of by type. When you find your model the parts page will also include a link to the manual.\015\012\015\012 ... Dirt Devil Vacuums

S catch thank you for the pic, i'am pulling like crazy, and this thing is not budging. i will keep trying, but i'am afraid i will break it. i really need to get inside there, it probably is clogged in the heater. it sprays water out of the hose attachment, just not out the bottom. thanks, randy


Look between the 2 fingers there at the top, If I remember there is a catch in between them that you push down to release. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Electrolux twin clean vacuum cleaner. After 5 minutes it keeps of thinking the filters need cleaning (and they don't). I re charge the power, and all seems fine and then it goes back to wanting the filters cleaned. The suction is also not working to full capacity.


Because the suction is not working fully it feels that the bags must be full and the air cannot be pulled through the bags. It could be due to 1) bags not being of correct quality. The air has to pass through them to allow all the dust to reach there ... Vacuums

The built in power lead in my vacuum hose has a short in it. I need to fix it


Hello peter639,\015\012Since you failed to include brand and/or model number.. I suggest you simply add -on another cord to your existing flex hose. If your existing hose has molded connectors on them that you cannot easily find to match, then ... Vacuums

We bought our Kirby less than 5 years ago and lately are not happy with it....it keeps breaking. The warranty has expired and our biggest complaint is that it has lost it's suction power. All the contents stay in the hose when I vacuum out the car or upholstery and it does vacuum well at all. The Kirby store quoted us over $200 to fix/ service it. Apparently this is not covered in the free yearly maintenance which we just had done. Any suggestions?


\012 Hi there,\012Well I do have a suggestion though you may not like it use it as a boat anchor.....no no I am just kidding. I have sold vacuums for 20 years and Kirby has b ... Kirby Ultimate G Bagged Upright Vacuum

My FIL purchased an Electrolux bagless canister vacuum model EL5 76501 last year. When I tried to use it today, the hose keeps pulling out of the power brush whenever I pull it towards me. it doesn't seem like anything has broken off. The only thing I noticed was that the rubber ring washer seems to be flattened. Could it be something that simple or do you think some part has fallen off and gone missing? Regards, Craig Somersett


I believe I've just had the same problem and after searching for a small gray horsehoe clip that needs to first be found and then inserted into the slot for it on the tube section that comes out of the beater bar. Insert this clip from the outside af ... Electrolux Vacuums

The hose keeps pulling out of machine and now power head is not working.


What kind of machine, make sure you lock it into place ... Vacuums

My electrolux 2100 vacuum hose broke. I replaced the hose but now I dop not have power at the hose end. is there a curcuit breaker in the canister tha supplies power to the hose??


... Electrolux Guardian Bagged Canister Vacuum

Need parts for Bissell Power Steamer Model 1695


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Beam solaire hose only works to suction The power head isn't working. Have another hose and the power head does work on that one so I know it is the hose


... Vacuums

Power head keeps shutting off on my dyson dc21


... Dyson DC21 Stowaway Telescopic Wand and Vacuum Hose

I just need the part number for my Guardian Electrolux model C134A i ran over the Hose and that was the part that broke. i need to compare prices so i can determine if it is cost effictive to change the switch or get a new hose


The part number for the hose is 47086.\015\012The best thing to do is contact the nearest Aerus Electrolux dealer. \015\012If it's just the switch or handle that broke, it will be more cost effective to have that replaced. If I remember ... Electrolux Guardian Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0890 seconds