Having problems with your Kenmore 23313 Whispertone Bagged Canister Vacuum ?

Kenmore Whispertone 100 connection issues

\015 We have a Kenmore Whispertone where the connection between the handle and shaft is constantly loose causing the unit to go on and off with each pass of the sweeper. I tried adding some tin foil to lessen the gap and that worked for a few months now I'm back to the same problem. Any ideas? \015

Answers :

Find a used one at a vac repair shop, its just worn out
Repair Help & Product Troubleshooting for Kenmore 23313 Whispertone Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Whispertone 100 connection issues


Find a used one at a vac repair shop, its just worn out ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Belt for kenmore whispertone 116.26512690 - Kenmore 23313 Whispertone Bagged Canister Vacuum


... Kenmore 23313 Whispertone Bagged Canister Vacuum

What is the bag for Kenmore whispertone 300 - Kenmore 23313 Whispertone Bagged Canister Vacuum


... Kenmore 23313 Whispertone Bagged Canister Vacuum

I have an old Friedland door chime (approx 30 years old). It has 5 terminal screws to connect wires. They are labeled 0-4. I removed the chime during remodeling and would really like to reuse it. I did not label the wires and where they connect when I removed it. I can't figure out how to wire it. I contacted Friedman and they were of no help... didn't have information on chimes that old. Can you help with how to wire the chime given it has five connections screws with no labels other t


... Vacuums

Kenmore central Vac - where to connect low voltage wires?


Mosy central vacs have 2 spades close together that stick out on the side, usually where the circuit breaker and auto/manual switch is. This is where you plug the low voltage wires into. ... Vacuums

Kenmore whispertone 12.0 bags - Kenmore Vacuums


... Kenmore Vacuums

Kenmore whispertone 12 amp canister vacuum - Kenmore Vacuums


... Kenmore Vacuums

Replace connection pipe kenmore vacuum - Kenmore Vacuums


... Kenmore Vacuums

Owner's manaul for sear's whispertone vacuum - Kenmore Whispertone 23312 Bagged Canister Vacuum


... Kenmore Whispertone 23312 Bagged Canister Vacuum

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

Manual Kenmore Looking for a manual for the Kenmore Whispertone 12.0 Amos Vacuum


... Vacuums

Kenmore whispertone 12.0 amp - Kenmore Vacuums


... Kenmore Vacuums

Kenmore 21875 One day it's working fine. Next day, it won't turn on. When I attach the hose to another vacuum cleaner, it runs. Is there a reset button on the canister? Could it be the receptacle is bad? My Kenmore Progressive won't turn on today either -but was fine last week. I cleaned the filters checked for blocked air, tried a different outlet and no luck. I'll check the pins on the connections and see if one of them is not matching up or appears worn.


Give the prongs a wiggle and see if there is any play in them.Might just be a plug end. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore power cord will not retract - Kenmore 23313 Whispertone Bagged Canister Vacuum


... Kenmore 23313 Whispertone Bagged Canister Vacuum

Describe how to open a whispertone vacuum - Kenmore 23313 Whispertone Bagged Canister Vacuum


... Kenmore 23313 Whispertone Bagged Canister Vacuum

Remove cover on kenmore vacum model 116 - Kenmore whispertone 100 model 116


... Kenmore whispertone 100 model 116

Disassemble 840 kenmore vacuum cleaner - Kenmore 23313 Whispertone Bagged Canister Vacuum


... Kenmore 23313 Whispertone Bagged Canister Vacuum

I have a Kenmore DuraPower Dual Cyclone Action 12 Amp that just randomly stopped right in the middle of vacuuming. I assumed the plug had come out of the wall so I went to check and this wasn't the issue. I tried multiple outlets and that wasn't the issue. I made sure nothing was stuck and there is nothing stuck. Nothing happens when I press the red "ON" button. What could this be? Thanks!


... Kenmore Vacuums

How to replace kenmore 116 power cord - Kenmore whispertone 100 model 116


... Kenmore whispertone 100 model 116

Kenmore progressive canister bad connection from hose to canister


It could be, the female part of the connector is stretched open. You can usually insert something, like a dart, between the sleeve and the holder, to tighten it. If you paid with Pay Pal, see about getting your money back. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

No suctionn on my Kenmore 360 Whispertone


... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore Whispertone Model 116 won't turn off, how to fix?


... Kenmore 23313 Whispertone Bagged Canister Vacuum

Kenmore canister switch issue


I have the same problem and took it apart. There are two switches: one on the hose and one that activates the motor - on the right side just inside next to the motor. Took the switch apart (V-`0G-3C25-L) and found it was fried - slightly melted. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Sears Kenmore Whispertone Vacuum Problem:


If you push inwards on each side of the light cover on top you can remove it. With the light cover removed remove the (2) access screws. Now you will be able lift of the entire top cover from the base. You will then see the belt and roller brush, rem ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Kenmore whispertone 100 model 116. powerhead no


\015\012The motor / cord compartment cover must be removed to access the cord reel. There are four screws that hold the cover to the chassis. Two of the screws are found under the cord-retractor-foot-pedal on the top ... Panasonic Kenmore Canister Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0264 seconds