Having problems with your Kenmore 25512/ 25513 Progressive Canister Vacuum ?

Lid won't close

\015 I opened the machine to change the bag. Now it won't close. I'm afraid to push too hard in case I would break the plastic hinges.\015

Answers :

You have probably closed it by now :-) but when this happened to us we \012found that if we opened the tool compartment on the lid, the main lid \012then closed on the bag with a tiny bit of jiggling around. I don't know\012 why, but this worked.
You might have the vacuum bag in incorrectly. Pull your vacuum bag all the way out, and check the cardboard for arrows (as some bags are cut to go in one way, and one way only). If your vacuum has a cartridge that the vacuum bag goes into, make sure that this is seated completely, securely, and correctly. After you have checked all of this, seat your lid meaning make sure it is going to sit correctly on the housing, then as you are closing the lid, check the latch as it begins to close - making sure that the male and female portions are going to match up. You may have to give it a little pressure, but should not have to put enough pressure to break anything. Good luck.
Repair Help & Product Troubleshooting for Kenmore 25512/ 25513 Progressive Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Green canister lid wont close

Http://smallappliances.electroluxusa.com/en-US/Customer-Support/download free your instr manual and see your problem lid why not close, ... Electrolux Ultrasilencer Green Canister Vacuum

Lid won't close. I started to put in a new bag but accidentally took out the plastic insert section the bag should attach to--so when I closed the lid over that, I must have pushed a little too hard. Now it won't com[pletely close! The plastic clasp is intact. Is there anything I can do before having to haul or send it for repair?

Your supposed to take out the plastic part that holds the bag but the way this unit is designed the lid will not close unless everything is inthere correctly so just make sure evverything in inserted correctly and keep trying! DO you still have your ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum

I have a george wet and dry (A26A), it wont pick up any water. the tube which goes from th lid into the water wont pick up water?

... Vacuums

The float to my shop vac is shaped like a cup has an open end and a closed end. I would like to know if the float goes into the lid cage with the open end facing up or the closed end facing up

It goes in with the open end facing up. ... Shop Vac ShopVac 3 HP 2 Stage 10 Gallon--Automotive Wet/Dry Vacuum Vacuum

Hinge on lid broken, unable to close lid Type VBB5700V00 1800 W

... Bosch BSG71310UC Bagged Canister Vacuum

I have a new Kenmore magic bued and I am about to change bags for the first time. Trying to do this the clip that is supposed to hod the bag close to the whole keeps coming off when I replace it and close the lid, turn on the vac the sucction is very low and it keeps showing the bag is full which is not true / what is going wrong here ? Thanks so much for supporting, Beba

Sorry to hear that you are having problems with you Kenmore Magic Blue.There is a so-called "bag full indicator", which will only turn red if it got some major blockage. This is the reason why there is no power suction.The "fu ... Kenmore Magic Blue 24195 Bagged Canister Vacuum

Cannot close lid

... Miele Carina Vacuum Vacuum

Lid will not close on my meila red star

... Vacuums

Dust compartment lid won't close

I have the same problem!! Did you get yours to close yet? ... Miele S4580 Luna Bagged Canister Vacuum

I can't close the lid to my electrolux vacuum

... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Lid won't close

... Miele Carina Vacuum Vacuum

The lid on my sc-306 steam cleaner wont come off, is it pressurized

Press down and turn antyclockwise ... Vacuums

Magic blue canister lid won't close, no suction

... Kenmore Magic Blue 24195 Bagged Canister Vacuum

Lid won't close

You have probably closed it by now :-) but when this happened to us we \012found that if we opened the tool compartment on the lid, the main lid \012then closed on the bag with a tiny bit of jiggling around. I don't know\012 why, but this worked. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Electrolux airmax turbo vacuum cleaner no suction but we cannot close lid properly why

... Electrolux Vacuums

Shark Steam Blaster lid wont open

... Euro-Pro Shark Steam Blaster Vacuum


... Nilfisk Vacuums

Was using my Miele Champagne vacuum, powered down, changed the bag, and now I have no power. I checked to make sure all lids were securely closed, still no power. Checked to make sure outlet was working, still no power...help.

Most likely the cord went bad, one side of it opened up, you will have to replace the cord reel asm. if this is the problem, Could also be a switch, electronic control or the motor. ... Miele Vacuums

When I set my sunbeam 3331-33 coffee machine to just brew, I can hear a click but it doesn't **** up the water to brew. I have not tried the grind and brew position to see if it will brew... any suggestions on what I can do? Everything is in properly (the lid is closed properly, the carafe is on properly)... Thanks.

... Sunbeam Vacuums

How do u close dyson bin base flap as mine wont shut

... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My craftsman 1/2 hp garage door opener opened but wont close and clinks and lights flash

... Craftsman Vacuums

I have a DC 15 Dyson Ball Vacuum. I've removed and cleaned the filter. I can't get the lid to close properly. I don't want to force it and break something. There is some kind of a red spring loaded tab that seems to be in the way. How do I reseal the top of the vacuum?

The red tab doesn't let the lid close if the filter is not fitted correctly or the wrong filter is fitted. Many after-market filters cause this problem. \015\012\015\012Have you recently fitted a new after-market filter? ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

It leaves dirt and fluff in the rollers not in the filter. So is not cleaning properly. There is never anf fluff at all in the filter. Also the lid does not close properly and we constantly get the 'check tank' light coming on. It leaves streaky marks across the floor and seems to leave the floor too wet (hence the streaks). Look forward to hearing from you.

Is there something stuck in the air passage between the tank and inlet ... iRobot 5800 Scooba Vacuum

Hello- my motor filter is becoming clogged every time i use it. i have removed and washed it--I thought maybe i didn't have the lid closed tight enough but for some reason dirt is pouring into the filter, it seems that some of the dirt suctioned is actually being pulled into the filter intead of the canister

One way or another, dirty air is by-passing the cyclone. My best guess is that when you emptied the clear bin, a seal has dropped out (or become displaced) and the base of the clear bin is no longer sealing properly against the bottom of the cy ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0364 seconds