Having problems with your Kenmore 25512/ 25513 Progressive Canister Vacuum ?

How to change filters on a Kenmore canister vacuum


Answers :

Depending on age there may be one or two filters. A Hepa filter is an exhaust filter generally at the back end of the vac, sometimes at the back top.
For this style filter there will be a small grill with a release tab on it, simply pull the finger tab and the grill should pop off revealing the filter.
There is normally a bag chamber filter behind the dust bag as well. Open the bag chamber below the tool storage and remove the bag.There will be a soft filter sitting behind the bag on most models. If it is a sponge type it can be washed and reinstalled when dry, but if fabric it is disposable.Make sure you have replacement filters in hand before changing as some filters simply pop into a reusable frame, often a red frame. If the material slides out the frame is generally reusable, if glued in , it is likely disposable.
USE only the specified filter and chose the best quality multi ply filter bags for maximum vac performance and efficiency
Repair Help & Product Troubleshooting for Kenmore 25512/ 25513 Progressive Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Change heap filter 116.25813508 - Kenmore 25512/ 25513 Progressive Canister Vacuum


... Kenmore 25512/ 25513 Progressive Canister Vacuum

How to change filters on a Kenmore canister vacuum


Depending on age there may be one or two filters. A Hepa filter is an exhaust filter generally at the back end of the vac, sometimes at the back top. For this style filter there will be a small grill with a release tab on it, simply pull the fi ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore Progressive canister model 116.27514700 Problem: Vacuum motor won't turn on. The power head operates, but nothing from the vacuum. Have checked all areas of airflow: hose, bag, motor filter and hepa filter. All are fine. Have checked and rechecked all electrical connections, all seem to be in working order. Vacuum hasn't run for a week or so, so it's not the thermal protector, unless it's defective. Vacuum was running fine last week. Didn't stop operating when using. Went to v


Hello! The culprit is the PCB Assembly; Part # KC86WBZR3000...Cost is $6.99. I would remove and inspect for burnt components, or broken wires...Then clean connections both male/female using an eraser, toothbrush and alcohol...Using a bright ... Vacuums

Overheated vacuum After I finished vacuuming the library last night I changed the bag and shook out both filters and vacuum would not restart. The canister unit felt real warm to the touch but I had been using it a least 1/2 hour non stop. The bag was pretty full but not overly so. It's a Simplicity canister with power head. The carpet is long shag from the 70's Did it just over heat? Thanks Shauna


It normally won't over heat unless the bag is too full, the filters are clogged, or you have have a clog in the hose or down by the brush roll, the inlet may be clogged. Some will restart after a while, some others have a reset to push. If it won't ... Simplicity 7850 Premier Bagged Canister Vacuum

We have a Kenmore Grab-N-Go Upright Vacuum with a Hepa filter. We lost the yellow filter canister that goes in the top of the vacuum and need to replace it and the filter that goes in it. Is there somewhere we can purchase a replacement part?


... Kenmore 34722 Grab-N-Go Upright Vacuum

How to change filter in kenmore vacuum - Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue


... Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue

Ive changed the filter and checked the hoses but vacuum doesnt pick up ...when its on the dust is being blown out the bottom of the vacuum....i took the canister off to test the suction its fine...also cleaned the filter ...help!


Have you check the roller brush and drive belt? It may be your belt has broke or is slipping and therefore not turning the brush.\015\012Turn on machine and power head see if brush is turning if it is put a small amount of pressure on the rol ... Kenmore Vacuums

My Kenmore canister vacuum cleaner model 116.27514700 has unacceptably low suction.It is much less than my older GE Walmart canister vacuum. the 2 filters are very clean and there is no blockage in the hose and the dust collection bag is empty. Is poor suction a characteristic of this model or if not is there a way to fix this problem?


... Panasonic Kenmore Canister Vacuum Vacuum

How to replace Kenmore canister vacuum filter.


I believe it faces toward the housing ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore canister vacuum will not turn on


Check the electrical component ... Kenmore 23513 Progressive Bagged Canister Vacuum

Lid to kenmore canister 360 hepa vacuum cleaner, lid to change vacuum bag stuck in open position


GoVaacuum2,\012\012I have the same problem and that didn't work.. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have a Kenmore 116.36932 (upright-bagless vacuum) that the motor protector by-pass valve has opened. I've clean out the area between the agitator brush where the flexible extension hose starts. There was some blockage there. I checked the rest of the system (extenstion hose, back filter area, pipe area to canister and area to side filter. I took the 2 filters out and the by-pass valve is still open. Where else could there be a blockage that I can take apart to clean and put back together


... Vacuums

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It's at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?


I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.\012You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessa ... Kenmore 34612 Bagged Upright Vacuum

I was given a Kenmore progressive hepa filter 22313 Bagged Canister Vacuum recently, but don't have the manual. We used it once to vacuum the house and it worked beautifully. Then we used it 5-6 days later and it started whining and getting hot. What year was this vacuum manufactured? Where can I download an owners manual?? Help!


Http://www.managemylife.com/mmh/owner_manuals/5461/KENMORE-Vacuum-Canister-L0809572 ... Kenmore 22313 Bagged Canister Vacuum

Smoke coming out of my Kenmore Canister Vacuum Model 22550300C


Sounds like a motor err. Could be repaired by a professional but it never be as good as a new one. Also they you might not find anyone to repair it because the replacement motor might cost more than a new vacuum /considering it's age the motor will b ... Kenmore Vacuums

Kenmore progressive upright filter is being bypassed, clogging screen at outlet. Tried new filter, no change. 7 or 8 passes with the vacuum and the screen at outlet gets clogged.


Take the filter out and hold your hand over the filter connection. Turn it on and see where the air is being bypassed. What you see should suggest the fix. ... Kenmore 35622 Upright Vacuum

How to change mini shop vac filter - Shop Vac Shop-Vac Hang Up Mini Canister Vacuum Cleaner Vacuum


... Shop Vac Shop-Vac Hang Up Mini Canister Vacuum Cleaner Vacuum

Kenmore 21875 One day it's working fine. Next day, it won't turn on. When I attach the hose to another vacuum cleaner, it runs. Is there a reset button on the canister? Could it be the receptacle is bad? My Kenmore Progressive won't turn on today either -but was fine last week. I cleaned the filters checked for blocked air, tried a different outlet and no luck. I'll check the pins on the connections and see if one of them is not matching up or appears worn.


Give the prongs a wiggle and see if there is any play in them.Might just be a plug end. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

My kenmore vacuum 35922502 sensor dirt lights stay on red all the time. I have changed the bag, filter, little sponge filter, still they stay on. What is wrong? Lynn [email protected]


... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

I want to know easy way to change my filter - Filter Queen Majestic Canister Vacuum


There are only two. One on top and the paper cone filter that covers the entire base of the top. There are three paper tabs on the large paper cone filter. You can either put the filter directly on the bucket and then bend the tabs over the outer edg ... Filter Queen Majestic Canister Vacuum

How to change filters - Filter Queen Majestic Canister Vacuum


... Filter Queen Majestic Canister Vacuum

How do I change the belt on my Sears vacuum? - Kenmore 25512/ 25513 Progressive Canister Vacuum


Hello,Here's what you'll need to replace a belt on a Kenmore ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Change bag in magic blue vacuum - Kenmore Magic Blue 24195 Bagged Canister Vacuum


... Kenmore Magic Blue 24195 Bagged Canister Vacuum

My vacuum is making a whistling sound and when I turn it off it momentarily gets louder and makes a honking sound. The vacuum is a Kenmore canister vac model # 116.27814. It has a new bag and filters.


... Kenmore 27814 Bagged Canister Vacuum

25512/ 25513 Progressive Canister Vacuum: HI, we have a kenmore progressive canister vacuum ...


Cord bad at male prongs, or fuse near motor blown. ... Kenmore 25512/ 25513 Progressive Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1164 seconds