Having problems with your Kenmore 25512/ 25513 Progressive Canister Vacuum ?

Kenmore progressive canister hose cleaning

\015 Contractor used household vacuum during construction.\015\012How do I clean the hoses and tubes? They are filled with spackle-dust, white and very powdery...blows everywhere.\015\012Thanks.\015

Answers :

Remove hose take it outside and flush with TSP solution then rinse with water (garden hose) let dry. spackle dust and drywall dust are water soluble and will not hurt your grass.
Repair Help & Product Troubleshooting for Kenmore 25512/ 25513 Progressive Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore 21875 One day it's working fine. Next day, it won't turn on. When I attach the hose to another vacuum cleaner, it runs. Is there a reset button on the canister? Could it be the receptacle is bad? My Kenmore Progressive won't turn on today either -but was fine last week. I cleaned the filters checked for blocked air, tried a different outlet and no luck. I'll check the pins on the connections and see if one of them is not matching up or appears worn.


Give the prongs a wiggle and see if there is any play in them.Might just be a plug end. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore progressive canister hose cleaning


Remove hose take it outside and flush with TSP solution then rinse with water (garden hose) let dry. spackle dust and drywall dust are water soluble and will not hurt your grass. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Bought a Kenmore Progressive canister vacuum at a garage sale that looked in better than average condition, filters clean, new bag, all accessories intact, some debris in roller brush. problem is no suction when turned on. There does not appear to be any obstruction in hose. did not have manual


Hello,Carnister vacuum cleaners are all built with the same principle in mind. A motor \015\012generates power which powers a vacuum which, in turn, creates suction to\015\012 lift debris. The most common areas of suction loss are within ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore progressive canister bad connection from hose to canister


It could be, the female part of the connector is stretched open. You can usually insert something, like a dart, between the sleeve and the holder, to tighten it. If you paid with Pay Pal, see about getting your money back. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Replace hose on kenmore 3.9 canister vacuum - Kenmore 25512/ 25513 Progressive Canister Vacuum


... Kenmore 25512/ 25513 Progressive Canister Vacuum

Hello, I have a Kenmore Progressive Canister Vacuum 116.20912006. It won't turn on. On the hose assembly, the end where the hose swivel is, there are 4 metal pins that plug into the canister. One of the pins looks like it broke off. There are only three pins remaining. I assume there should be four pins as there are four holes. Is this the problem and is it fixable? The vacuum is from 2002 so I am not sure a replacement part is even available and at what price. Thank you. Susan susan.eng@


Hi Susan, if the pin has broken off you can do one of two things, first, would be to find a local vacuum repair shop and take it there for them to look at. they may be able to look at the hose and fix it for you pretty cheaply. what ... Kenmore Progressive 20912 Bagged Canister Vacuum

I have a Kenmore 116.36932 (upright-bagless vacuum) that the motor protector by-pass valve has opened. I've clean out the area between the agitator brush where the flexible extension hose starts. There was some blockage there. I checked the rest of the system (extenstion hose, back filter area, pipe area to canister and area to side filter. I took the 2 filters out and the by-pass valve is still open. Where else could there be a blockage that I can take apart to clean and put back together


... Vacuums

For Kenmore 116.27514700 Progressive powermate vaccuum, how do I take apart the hose from the connection into the canister? I have a short in the hose and want to replace just the hose.


... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

My kenmore progressive canister vacuum turns on only if the hose is attached to the floorwand. It seems that the canister motor is not working because I can't hear anything coming from the caniste


If the floor wand is powered, there may be an electrical connection that is broken when the wand is disconnected. This is part of the design, not necessarily a fault ... Vacuums

My Kenmore Progressive Direct Drive Beltless System Vaccum cleaner is making a loud noise by the filter and hose in the back of the vaccum and is not picking up. I have cleaned the hoses and the bottom of the vaccum where the agitator is located. Still it is not picking up dirt. What can i do?


... Vacuums

Kenmore powermate 4.1 vacumm hose - Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I bought a Kenmore canister vacuum, model 116, in April 2007. This morning, the sound of the motor suddenly began to deepen, and I began to lose suction. Normally, if something is clogging the hose, the motor will wind up to a higher pitch, not a lower one. The filters are clean, the bag is empty, and I can't detect anything lodged in the hose. If this were a car's engine, I would say it's "lugging down". Any pointers?


Okay, bear with me. Is it possible you have a suction adjustment, dial somewhere on vac. Check and see and if it does, be sure it's all the way up. Also, try removing hose and run a broom handle fr. one end to the other...BUT be careful not to stretc ... Vacuums

My Kenmore canister vacuum cleaner model 116.27514700 has unacceptably low suction.It is much less than my older GE Walmart canister vacuum. the 2 filters are very clean and there is no blockage in the hose and the dust collection bag is empty. Is poor suction a characteristic of this model or if not is there a way to fix this problem?


... Panasonic Kenmore Canister Vacuum Vacuum

I have the upright kenmore progressive with direct drive and the filter canister stops bringing in air and picking up when hose is put into vaccum, when you remove hose and use as an attachment it starts again


Check the hose after the brushes. With this problem there is normally a clog in between where you disconnect the hose (to use attachment) and the brushes that clean the carpet. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Have dirt sensor light on continuously on Kenmore Progressive canister vacuum cleaner...lost manual, do not know where sensors are so can clean them. Could not find answer on the site or from Kenmore. Thanks.


... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Progressive Kenmore hose canister connection broken 116,2341130


A regular person with patience can however it is tricky. Kenmore hoses have an arrow at the cuff where the corrugated hose meets the swivel elbow at the machine, and at the cuff where the handle meets the hose. If your parts fit in the handle, the c ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore 25614/25615 Progressive bagged canister vac won't start


Sounds like there was a loose connection or loose wire that came in contact with another wire. check your cord for small burn holes, also could have shorted out in the hose or the wand. If you are comfortable to disassemble the vacuum i can walk you ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Hi.My model 116 36933502 only works as suction hose. When I use the bottom, a loud "flapping" noise and no suction. Everything is clean. Seems like a broken diphragm or filter? Sears Kenmore Progressive Bagless Intelliclean 5 years. Thanks Kate


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Kenmore Progressive 21514 canister vac motor is weak and shorting due to debris. Can motor be opened to clean out?


... Vacuums

How do I disassemble the swivel assembly from the hose on a kenmore progressive canister vaccuum? thanks.


... Kenmore 22812 Bagged Canister Vacuum

My miele vacuum cleaner hose has no suction - Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum


Have you tried changing your filters.? Also using genuine filters gives you much better suction ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

My kenmore progressive canister vacuum's power head has stopped working. When I check for suction from the hose, it seems strong. Could it be a belt has broken? Is this a repair that I could do myself? Thank you!


... Kenmore Vacuums

I have a Kenmore Progressive Inteleclean Upright vacuum cleaner (with Bag) . It has good suction only through the hose now and none through the bottom for cleaning carpets. and, there is a noise like it has a suction leak. the brush is rotating.


Theres a little bendable neck that hose with suction plugs into. Thats the one thats clogged. You will have to fish it out by taking off the roller and clearing the clog. ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

THe vacuum won't divert from hose to carpet - Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum


Turn the vacuum off, return the handle to upright locked position.Then securely fit hose into the hose holder.Then depress lever and engage handle into non-locked position, and turn on vacuum on "carpet" There wil ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

My Kenmore Elegance Canister Vacuum powers up but has no suction. Tried changing the bag and cleaning the hose. Still the performance indicator light comes on. Now what?


... Kenmore Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0547 seconds