Having problems with your Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum ?

Vaccum has no suction

\015 My vaccum sucked up a ribbon while vaccuming. i stopped the vaccum and pulled the ribbon out. when i restarted the vaccum it smelled like it was burning and the brush on the bottom was not spinning. also, there was no suction so it was not cleaning.\015

Answers :

Hey guys: just hit the little red reset button,but only after you cleaned out the brushes.
Yes the burning smell is caused by the belt,so change it. also check each side of the brushes. there are bearings on either side. you may be able to pull them off and clean them out. next check the filters. if they are clogged then you will have poor suction,so change them. the other clog might be in the hose. you will have to snake it out. if you can't do it with ease then the hose will have to be taken apart. both ends of the hose can be taken off. if you are going to try this,first start with the end which goes into the canister. the other side of the hose is harder and care has to be taken or it will break off--------------BY GETERDUN
Repair Help & Product Troubleshooting for Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello, I have a Hoover 3200 Turbo Power vaccum. while the motor appears to be working fine the vaccum no longer picks up the dirt. I turned the vaccum upside down and the belt appears to be broken. would a broken belt stop the pick up, there appears to be no suction. This vaccum is approximately 10 years old. is it worth fixing? I live in Virginia Beach Va, where would I take the vaccum for repair? my zip code is 23456- Thanks Cleta Goode

... Hoover Vacuums

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s

I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

S7000 my miele upright vaccum cleaner looses it suction when on carpet mode, suction is perfect when upright (hose). The suction lasts for appox 5 mins when on the carpet and it stops.

... Miele Vacuums

No suction my riccar 8850 has no suction. I cant find any clogs and there is some suction on the hose when using cleaning tools but when hooked up to the vaccum bag it wont clean

Replace your belt. Remove the baseplate, remove the brushroll, place a new belt around the motor pulley, then around the pulley on the brushroll, and pull the brushroll back into place in the nozzle. Spin it by hand to make sure it spins, (otherwise ... Riccar 8850 Vacuum

Vaccum has no suction

Here is what we did to fix the problem of our vacuum having no suction.\015\012\015\012We unscrewed the three screws on the back and took the hose off of the vacuum.  Then we took the hose outside and put the water hose through the vacuum ... Kenmore 34923 / 34925 Progressive Bagged Upright Vacuum

Vaccum has no suction

Hey guys: just hit the little red reset button,but only after you cleaned out the brushes. ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

I have Infinity NV30 for 3 yrs. Now it has very low suction and spreades dust around while vaccuming. While vaccuming the dibries doesn't come in the container a lot. Pl advise how to fix the problems.

... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

I have a Kirby G series diamond edition. There seems to be no suction when I turn on the vaccum. The bag inflates, but the roller does not turn. It has a new belt and the roller brush is clean. Any suggestion on what I might do to increase the suction and get the roller bar moving?


Help hi there. i have a hoover savvy u8172-900 vaccum. the hose has great suction, but there is limited suction on the main unit and the brush does not spin when i try to use the product. we have cleared the brush of any debris and have also installed a new bag. a few days ago, we disconnected the hose to make sure there was not any foreign bodies stuck in the unit...nothing seems to help. any advise?

As the hose fits into the base (if i am correct) the power at the base should be fine, make sure the base is clean and free from blockage,\015\012you say the brush doesn't spin, has the belt broken, if so replace it, (very cheap) and only a couple of ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

I bought a Dyson Vaccum for pets. Spent around 700 for it, and thought it was the cats meow. They promise that there is no lose of suction, and oh boy is that a joke. I clean the filter that they say they don't have, which they do. I have cleaned it up thinking I just have a dirty vaccum. Now the hose sucks together so hard that it is pretty flat. And the plug in is EXTREMELY HOT!!! It seems like the littlest things fall off of it, and it is all plastic and it cracks and pieces break off.f I don

Sure, we have Miele machines that are German made and excellent with 10 year warranties we are also a dyson repair center for warranty.\015\012Dyson Repair Form ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson all floor vaccum no suction when hand held wand is turned on... doubled checked for cracks in hose -- none took house off unit to check for blockage --- none.. suction works fine when using as normal on floors.

You need to replace the belt that drives the brush on the underneath side of the vacuum. To do this, you need to flip the vacuum over and remove cover plate. There you will find the broken, or stretched out belt. Remove the brush and place the new be ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have Infinity NV29 for 3 yrs. Now it has very low suction and spreades dust around while vaccuming. While vaccuming the dibries doesn't come in the container a lot. Pl advise how to fix the problems.

... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

My nearly new Miele S710 vaccum cleaner just revs like mad when you switch it in but you get no suction. Could there be a drive belt between the electric motor and the vaccum pump that has come off or broken? How can I get at it, if this is the case?

Hi,\015\012\015\012Yes this could be a case due to which there is no suction. I am posting an article which gives you a detailed description of how to open it and repair the internal parts.\015\012\015\012 ... Miele Vacuums

Bissell powerforce My lower pickup tube became clogged so I removed it and cleaned it out and reinstalled it.Now everything runs good but the vaccum want pick up any dirt .I replaced the bag andf when I turn it on it just exhaust air but does not have any suction,I tired tp pull the bag door of while it was running whick I could not do so it has plenty of suction inside just not getting any outside can you help?

... Bissell Vacuums

We have a Wertheim 3180 vaccum that the suction is no longer working. The air is blowing out but no suction coming in.

... Vacuums

Suction problem My vaccum does not have the same suction power. What can I do?

Change the filters if they are blockedof just old they wont work right but 1 of then is washable it says it ou the filter  ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I got a Dirt Devil Versatile 3 in 1 design hand vaccum for a birthday present This has a suction type of cleaning. I would like a hand held lightweight vaccum cleaner with a roller type brush and cervice tool. I would like to clean carpeted steps. I want to return the above cleaner and get a voucher for another cleaner.

... Dirt Devil Vacuums

No suction the vaccum sounds like its working and it picks up a little but it does not suction like it did 2 days ago. It is a hoover windtunnel bagless. the model number is U6600-9RM.

Have u checked all of the filters. I know that when not all the filters r clean the machine will turn on but then it will sound louder and still have no suction. Most times there is a filter under dirt container thats sits above motor and if this ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Dyson Vaccum suction not strong enough

Look for an obstruction in the air passages at the bottom and where the air enters the canister. Make sure the HEPA filter is not plugged (take it out for a test). Hope this helps! ... Vacuums

Extreme vaccum has no suction.

Make sure you put the dirt cone back in the bucket to create the tight seal. You will have no suction without the dirt cone. \015\012\015\012Bob\015\012http://eva ... Electrolux Centralux Vacuum

No suction when vaccuming floor

There could be a few things that would cause your Dyson to have no suction. I will give you detailed step by step instructions along with pictures on how you can diagnose this.Possible Problem #1. The first problem is extremely common. In ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction on wind tunnel vaccum cleaner

Your brush might be clogged with hair. while uplugged, flip over the vacum and check to see if there is any hair or string wrapped around the brush... ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have no suction with my Eureka Boss Vaccume and all hoses are clear

... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Suction when I vaccum the floor but not in the hose

Remove the filter from the dirt cup and try again,if you have suction the the filter is clogged.the other is the intake hose that goes into the top of the base where the clear tube is.disconnect the hose from the base tube and take a coat hanger and ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

My vaccume has little suction

Hello :1: Check that the Dyson's brushbar knob is turned to the "Carpets" setting for vacuuming non-delicate and raised pile carpet. Vacuuming carpet on the "Bare floor" setting usually leaves a telltale single wh ... Bissell 3576 CleanView II Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0308 seconds