Having problems with your Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum ?

When on the carpet setting, the dirt sensor stays on red all the time.

Answers :

Two possibilites can be thought of , either there is dirt on the system filter reducing the vacuum or the said vacuum level is low.
\012It will be good to remove and clean up the bag, the pump and reset . Use a good air jet spray but do it out of the house please, use a good face mask as there canbe fine dust within.
Repair Help & Product Troubleshooting for Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When on the carpet setting, the dirt sensor stays on red all the time.

Two possibilites can be thought of , either there is dirt on the system filter reducing the vacuum or the said vacuum level is low.\012It will be good to remove and clean up the bag, the pump and reset . Use a good air jet spray but do it out o ... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Dirt finder I have a Hoover U6439-900.  After the cleaner was used a few times, the dirt finder light cycles between green and red on the regular setting and will not go to green.  On the sensitive setting, the red light stays on most of the time.  I have tried to run the cleaner to remove any dirt but have not solved the problem.

The sensor may be bad, or it may be coated over with dirt. Re,ove the hose at the back of the vacuum, the head of the sensor is down inside that opening, reach in there and clean it off and see it that corrects the problem, if not replace the sensor ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My kenmore vacuum 35922502 sensor dirt lights stay on red all the time. I have changed the bag, filter, little sponge filter, still they stay on. What is wrong? Lynn [email protected]

... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Embedded light sensor stays red all the time

The back cover is called the a micro/dust assembly. See #21 here:\015\012http://w ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?

... Kirby Heritage II Vacuum

Embedded dirt indicator light stays red

... Hoover U5491-900 Bagged Upright Vacuum

Hoover Savvy The red light for the dirt finder is on when pushing forward and the green light is on when pulling it back. This happens all the time. It's like the dirt finder sensor isn't working right. It seems to be picking up good and we keep the filter clean.

Does this happen at both Dirt Finder Sensitivity settings? ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

Dirt sensor on my hoover supreme remains remains on red all the time

I had one i think you need to clean felter on it the one on side ... Hoover Windtunnel Supreme U5280-900 Upright Vacuum

Uh70015 dirt sensor stays on green. Goes on red for about 5 seconds then green. Can clearly see the floor is dirty and it is picking up stuff.

Ahh the good ol electronics on vacuums selling the product again... \015\012\015\012not to worry, your feature is working properly, your vacuum is working fine too. \015\012\015\012Imagine if you will making a circle with your ... Hoover UH70015 Bagless Upright Cyclonic Vacuum

Hoover - Red Light Dirt Sensor

Check to make sure the settings didn't get inadvertently switched to the hi position, move the switch back and forth from high to reg a few times, then leave it on reg.remove and hand wash the primary filter and secondary filter, dry thro ... Vacuums

I have an eye vac professional that will not stay on to **** up the dirt. There is power to the outlet and the blue on/off light does stay on, but in Auto mode if I stick my hand near the dirt sensor it just pulses on and off. I can feel the suction, but it won't stay on. I've unplugged it, removed the dirt bin and filters and nothing works. Help!!!! This is brand new and I've only emptied the collection bin once and it hasn't worked since.

... Vacuums

On my hover U6616-900 the self propell work fine on the med setting on med height carpet, but when I go to low height carpet and height set on med the self propell does not pull the vacuum and it is hard to push. Also if I raise the height to the highest setting the self propell works correctly and appears to clen. Any ideas? S/N 090400184555, think this vacuum is maybe 5 years old and my wife uses it lots. Should I think of maybe a complete overhaul or a replacement at this time?

This is a typical problem you are describing. I would recommend you change the belts, this will resolve the "hard to push" and most likely resove your issues. based on the s/n given you maching was made on sept 2004. ... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

Dirt sensor The dirt sensor on windtunnel supreme doesn't work anymore. It is a bagged windtunnel. The sensor remains red.

The sensor remains red. ... Hoover Windtunnel Supreme U5280-900 Upright Vacuum

Embedded Dirt Finder green light won't come back on - stays red

... Hoover U6634-900 WindTunnel Bagless Upright Vacuum

Dirt finder sensor stopped working

I had the same problem with a hoover windtunnel 6200 - u5477-900. I removed the flexible hose from top of the plastic tube running vertically along the right side of the back of the vacuum. When I used a flashlight to look into the plastic tube, I ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Model num. 052-8808-8 There are not enough instructions. Where is the manual override? I set the time at 2pm over the arrow and the T , want the timer to come on at 6o'clockpm., set the off time for 10 o'clock pm. Plugged the light in and it came on shouldn't it stay off until 6 o'clock. Need help!

... Vacuums

I recently purchased this vacuum after reading consumer reports article on it and from recommendations from family. However, since I've had this vacuum it's been nothing but problems! I have a frieze carpet and I have the vacuum set on the highest setting. Each time I use it, the vacuum clogs with carpet fibers before I even finish a room! Any suggestions?

Is that a shag carpet? the power head is raised up all the way can you lower the suction on it is the carpet old the vacuum may not be able to handle the carpet,go to a vacuum store and see if you can try somthing else out some stores well let you re ... Hoover Tempo Widepath Upright Vacuum - Blue

The Dirt Sensor lights will not go out. It doesn't matter if I am vacuuming carpet or tile floor, the dirt sensors are all lite up. I can't locate my owners manual.

Your machine could be clogged, check the tools for suction. If its a bag less model you might need to clean or replace your filters. ... Kenmore Vacuums

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet

Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

The suction stays the same in floor and carpet setting

... Kenmore 25512/ 25513 Progressive Canister Vacuum

My Bissell Pro Heat Select 2X does not pull up the dirt from the carpet into the water. The water just slowly disappears. The first time I used it the water got really dirty. The very next time I used it it worked differently and the water just disappeared until it was all gone. I've only used it a couple times and I don't see where it is working. Has anyone else had this problem?

Inside the plastic suction lid is a little red plastic filter that has to be cleaned out every time you use it because it sounds like your vaccum is not picking up all the hair and debri before you clean the carpet causing the water to be injected in ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell Bag Powerforce vacumn is not picking up properly. Dirt stay on carpet or blows back out. I have removed the hose and got a lot of clogged dirt but can not get all the dirt out cause I can't reach it.

... Bissell 3522 PowerForce Bagged Upright Vacuum

My Hoover Dirt Finder red light stays on. All

Inspection of the circuit board found that the 470uF capacitor looked damaged. I replaced it and I now have the Green and Red lights are working correctly. ... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Model U5491-900 Red Dirt Finder Stays On?

... Hoover Vacuums

I have a Dirt Devil M088400 - Vision Turbo Vacuum. A spring fell from the bottom and the carpet height adjust isn't working. The rollers under the unit won't stay in place either. Can you tell me how to put the carpet height adjust back together?

The roller attaches to wheels. There is a spring that attaches from roller to hight adjustment selector which is a plastic peice with a little hook on bottom that spring attaches to. Both peices should have a hook that the spring ttaches to. ... Dirt Devil Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0538 seconds