Having problems with your Kenmore 26823 Bagless Canister Vacuum ?

Kenmore canister #721 26823 keeps shutting off by itself every 3-5 minutes..

\015 We cleaned every part, no clogs but still shuts off\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 26823 Bagless Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore canister #721 26823 keeps shutting off by itself every 3-5 minutes..

... Kenmore 26823 Bagless Canister Vacuum

Kenmore 26082 Canister Vacuum Shuts off constantly. When Im vaccuuming maybe about 5 minutes later it shuts off. Then give it a few minutes later it turns back on. Whats the problem with this vaccuum

You could have a clog in the hose. Also check your filters, if you haven't changed them in a while, that could be what's suffocating your motor ... Vacuums

It keeps shutting off every two minutes or so. Its only 7 months old and seldom used.

If this is a bagless vacuum then you might have some filters that need cleaning or you have a clogged airduct in the machine that will not allow it to breath cooler. The motor is overheating and shutting down because it can't breath. ... Kenmore Vacuums

I have an Electrolux LE canister. It runs for about 2minutes then shuts off for about a minute , then turns on again and it keeps repeating this routine!!! It is driving me nuts. What part do I need to replace? Apparently it is over heating. Please help. Thank you.

The LE has a thermal cutoff. If the bag is overfilled or a bag breaks and clogs the bag chamber the vac will over heat. This also happens if the hose, wand or neck of the power head is obstructed. Try dropping a coin through the hose, look thro ... Vacuums

My electrolux canister model keeps shutting off after a few minutes use. can reset by unplugging and replugging, or by opening and closing access door

... Electrolux Lux 5500 Canister Vacuum

Why does my dyson slim dc18 keep shutting down, even though i keep it clean. Filters area is clean and all others have been properly blown out with air from a air compressor. It will work for about 5-10 minutes and then shuts down. Smells like ****, check the belt and a bit later it restarts again. It's seems to be almost over heating.

Maybe your motor is going. Here's a link to a site that talks about motor failure and replacement in a DC07 (not DC18). I don't know exactly what the odor smells like but maybe you can see if you have any of the other symptoms. Good luck! ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Electrolux Canister - Stops working after 1-2 minutes.

Electrolux Canister - Stops working after 1-2...\015\012Our vac works for a short time, then shuts off and makes clicking noise as if trying to restart again. Works after cooling for a while but for another very short ... Electrolux Guardian Bagged Canister Vacuum

What part causes kenmore canister powermate beaterbar to shut off

... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

Shark euro-pro x upright vacuum that shuts down every 15 minutes

These are prone to overheating. The manufacturer put a foam 'filter' wrap around the electric motor. This filter wrap insulates the motor, trapping heat inside, which causes overheating. The motor is very similar in form and function to the one in th ... Euro-Pro UV209 Upright Vacuum

Kenmore Progressive Canister w/Hepa Filter

May have a problem with the motor protector or the motor itself. The motor thermo protector will shut the motor off if it senses it getting hot. So it could be bad. ... Kenmore 22313 Bagged Canister Vacuum

The motor running the beater bar on ny Electrolux canister vacuum cleaner runs intermittently. It runs about 2 minutes and then cuts off and automatically starts again after a 1 to 2 minute interval. I have tried taking it apart and removing the dust and grit in the beater bar attachment but with no change in operation. What would you suggest?

Check all the wiring connections to make sure they're tight. \015\0121/2. Wiring to power nozzle motor or reset switch is loose.\015\0121. Cord from power nozzle to upper wand. If the plastic portion of the wand is cracked near the co ... Electrolux UltraLux 2000 Bagged Canister Vacuum

It keeps shutting off like it does when the battery is dead however it just charged. I have to keep pressing the trigger and it runs for a while the it dies after a few minutes. It has only been used about 20 times?

... Dyson DC25 Animal Bagless Upright Vacuum

Need a repair Manual for Sears Kenmore Canister Vacuum with Powermate that was purchased in March of 1999. Only numbers we have are as follows: 20-29712-990; 116.29712990; and 116.59712990. The canister is making a clicking noise when shutting down and we don't see how to get to the inside of the unit as it doesn't have any visible screws. Thank you for any information.

... Vacuums

Fully charged, filters cleaned, vacuum keeps shutting down in and then starts again only to shut off again. the 6 minute time limit is not used up.

Your battery is losing voltage too quick. It has probably developed a \012'memory'. Dyson claims that their handheld has the best suction out of \012all the handhelds out there. In order to maintain that claim the circuit\012 board will shut off powe ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My Dyson DC16 usually shuts down after about 5 to 10 seconds. However, occasionally it will run for 45 seconds to 1 minute before shutting down. It is left on charge permanently. I have checked the voltage from the charger, and it is 27.8 volts.

Your battery is losing voltage too quick. It has probably developed a \012'memory'. Dyson claims that their handheld has the best suction out of \012all the handhelds out there. In order to maintain that claim the circuit\012 board will shut off powe ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My iRobot Roomba runs for about ten minutes, then shuts off. I can keep pushing the clean button and it will run for another ten minutes and stop again. Nothing seems to get clean.

Take the brush rolls out and you should see a copper disc. It is the dirt sensor. Clean it with Windex or some other cleaner. This works sometimes. ... iRobot Roomba 550 Vacuum

The power brush floor rug attachment on my Eureka 6997 A Oxygen Canister Vacuum goes on an off as I use it. I replaced the The power cord from the handle has 2 plug in connections: 1 at the handle / upper wand 1 at the lower wand top of the power brush attachment I replaced the entire wand assembly and it worked great for a year or so and now it's doing the same thing again. I was told to keep the power switch on the handle set to off when connecting the power brush attachment or it will bu

This is from the prongs not making a good connection causing an arch inside the plugg causing what looks like rust on the plugg. I would try snugging up the connection by squeezing the female section to get a better connection on the prongs when it i ... Vacuums

Kenmore Canister Vac, Progressive, 25512 255513 model. Brush won't turn. One end of the brush roller, end closest to belt, is off center which is keeping it from turning freely. The end cap is like a square. Other ends turns fine. Do these end caps come off? If so how? Can't get it to budge. This is exactly what is keep brush roller from turning.

Take a flat head screw driver and pry the end cap off. It will come off. You might have some string or hair around it causing it to not turn. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Bosch BSA2222UC canister vacuum shuts off after 5 minutes

I took apart the vacuum, removed the circuit board and cleaned the tiny bits of dust off it carefully, removed the cord winder (without letting it unwind) and carefully replaced both parts, blew dust out of the 2 armature brushes (lifted out the moto ... Bosch BSA2222UC Compact Plus Bagged Canister Vacuum

VX3000c Keeps shutting down after a few minutes of use

It has a thermal fuse in the motor compartment. it is indicating a over heated motor. check the exhaust for clogs or feel the motor it should be warm but not hot to the touch\015\012if its just warm, the thermal is lying to you and needs to be ... Broan-NuTone VX475 Bagged Central System Vacuum

My kenmore premalite vac shuts itself off

... LG Electronics Premalite Vacuum Bagless Cyclonic Vacuum

My Hoover Windtunnel cuts off after using it for a few minutes. After an hour or so, I can turn it back on again. This keeps happening every time I use it. This is my third one. I have taken the other two back to Target for the same problem and they have exchanged them.

Yes this machine has a thermal protector in it to shut off the machine if it gets to hot, this is normal. if there is no clogs in the hoses or in the machine then you will need to wash the filter at the top of the machine. you will have to remove the ... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum

I have a Miele Capricorn canister vac. I have replaced all the filters (hepa as well) and the vac keeps shutting off while in use.

Have the cord reel checked. There could be a short in the cord ... Vacuums

Kenmore 39522 vacuum beater bar keeps rotating after unit is shut off. Even unplugged it to move to another room and when I plugged it back in, the bar rotated a few more times! Has a definite clicking sound when this happens. Purchased in January 2008.

The berings or something inside might be going bad. ... Vacuums

I have a kenmore canister model number 116.2645083 I need a replacement motor. I was given 2 different numbers: 1. 4147248 2. AC92FAUX200 I can find the 2nd motor, but it doesnt have the 4 wires like the original one. Can you tell me if this is the right motor? Thanks Becky

Greetings from GoVcauum.com,\015\012\015\012Ok, so good news, I have looked up your model number for your Kenmore vacuum and found that your Kenhmore canister takes the motor ... Kenmore 25512/ 25513 Progressive Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0474 seconds