Having problems with your Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum ?

HOW TO CHANGE A BELT - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Answers :

Hi there...You will need a Phillips screwdriver to get the bottom cover off.Remove the screws and then remove the bottom cover.Clean out any excess dirt in the general area of the roller bar and motor assembly area.Place one end of the belt over the steel shaft of the motor and then roll the other end of the belt on to the end of the roller bar.placing the belt on the top of the roller bar and roll the bar slowly and feed the belt onto the roller bar until it is completely in place.Replace the bottom cover and put all the screw back in.
Plug your vacuum in and turn it on with the roller bar off the floor, in other words let it run for 10 seconds until you put it on the carpet allowing the belt to position itself properly on the roller bar.
Repair Help & Product Troubleshooting for Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

HOW TO CHANGE A BELT - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Hi there...You will need a Phillips screwdriver to get the bottom cover off.Remove the screws and then remove the bottom cover.Clean out any excess dirt in the general area of the roller bar and motor assembly area.Place one end of the belt over the ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My question earlier today referred to a Kenmore Progressive upright vacuum. Your answer suggested that I change a belt, if the reset button did not work. Does a direct drive really have a belt? Regards, Jim Buckley


Direct drive does not have a belt. It is a shaft with gears. What is wrong with your vaccum? Maby i can help. ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Dirt is coming out the bottom of my Kenmore Progressive Upright Vacuum. My husband found a large dust bunny in the drive belt and removed it. He also changed the bag. Why is dirt coming out the bottom? Thanks.


Its still clogged, you gotta dig deeper ... Vacuums

Kenmore upright vacuums Model 11635922502 - Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum


What is the issue or problem? ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Model #11636923502 Kenmore Upright vac - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Kenmore elegance bag replacement - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

116 36932502 kenmore model - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I need an owners manual for this vacuum - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


The manual in pdf format can be downloaded at the below link.\015\012\015\012http://www.hammerwall.com/Download_Manual/11413/ ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Brushes don't move. vacuum motor works - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


The brushes on the roller are driven by a wide, short rubber belt. These belts get old, worn, overheated, and break periodically.It should be a fairly simple matter to unscrew & remove the plate, revealing the belt and roller assembly. Yo ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

The machine is blowing instead of sucking - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


NOT MY PROBLEM:) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My vaccuum lost suction - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


CHECK THE HOSE TO SEE IF THERE ANY OBJECTS BLOCKING AIR FLOW,ALSO CHECK THE BELT TO MAKE SURE IT ISN"T SLIPPING OR BROKEN. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

How do I replace brush - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Hi,Replacing the brush roller of a Kenmore Progressive upright vacuum is a job that can be accomplished in just a few minutes. The Kenmore Progressive vacuum uses a motor-driven brush roller and does not have a belt, which reduces the mai ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

The sweeper wont move - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I just inherited a Kenmore Progressive vacuum cleaner with direct drive and HEPA filter. Can't figure out how to change the belt - don't have a manual. Thanks. Jo-Anne


Http://www.managemylife.com/mmh/owner_manuals/6826/KENMORE-Vacuum-Upright-L0403208 ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Kenmore progressive upright (direct drive) with bag has low suction and the beater bar does not rotate. Also, it is not obvious how to get inside the vacuum


Hi there,\012First of all you look for a reset button on the motor and press it in with cleaner plugged in and turned on, push the little reset button on the side of the lower base of vacuum. Remember that the brush will not turn in the u ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

High pitched noise - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Power but not sucking up.. - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


You have to check two thins\0121 that none of the hoses or filters are clogged on the unit. This is not always so easy but the entire run of the hose till the bottom must be clear.\0122 You have to have the door th the bag closed properly. If there a ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

The suction doesn't work. what can i do - Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum


I changed the two filters on mine and pressed the reset button and that worked. ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

The brush is not rotating - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Try pushing the reset button with a pen or paper clip. If that doesn't work, the motor may need to replaced. If the reset button is stuck, I don't know how to fix it - mine has the same problem. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Does the gentle sweep work at all times? - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Agitator wont turn - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


Some of these have a resetable circuit breaker, if it has one, push it. There is a motor on the brush roll which could be bad. There also is an on/off switch, it may have a problem.Also may have a switch where the hose goes into, some models have a ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

How to reset - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It's at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?


I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.\012You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessa ... Kenmore 34612 Bagged Upright Vacuum

I have a kenmore progressive direct drive handi mate jr. upright vacuum. My daughter used it last night to vacuum up some cat litter that had spilled on the floor. I went to use it today and it turned on for a second and then stopped working. I have hit the reset button but it will not turn on. Help this vacuum is only 2 years old Is there anything that I need to reset or do so that the vacuum will work again?


Its probably clogged up with cat litter.might have gotten into the motor.your motor has a motor guard inside if it. when it overheats it will shut down till it cools off.you need to clean all th cat liter out of it.and clean the filters.with a direct ... Kenmore Vacuums

We understand that your problem is: I currently own and use on a regular basis the Kenmore Progressive upright bagged vacuum. Model number 116.35923500. The headlight flickers and the intelliclean light stays red. Ive tried cleaning the intelliclean sensors, changed the bag, and cleaned off the agitator. Is this a power issue? Should I take it to the store? Any suggestions would be greatly appreciated


Welcome to fixya\012\012Hello\012\012 \012\012I have a solution for this ... Kenmore Progressive 35922 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1263 seconds