Having problems with your Kenmore 85920 PowerSpin Upright Wet/Dry Vacuum ?

The steps on setting up the kenmore 85920 power spin upright wet/dry vaccuum

\015 Where do I place the clean water in the top tank or bottom tank.\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 85920 PowerSpin Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The steps on setting up the kenmore 85920 power spin upright wet/dry vaccuum

... Kenmore 85920 PowerSpin Upright Wet/Dry Vacuum

My kenmore beltless upright canister vaccuum doesn't spin anymore

Ensure the agitator is not bound up and can be moved manually by hand in both directions. Clean any string or binding material if you find it. Press the reset button on the top of the chassis. If it clicks, then you should try turning it on and see i ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Kenmore vaccuum upright moded#721.33289030 vaccuum worked just fine turned it off for a minute turned it back on the light comes on but theres no power from the motor Please Help thanks Valerie

... Vacuums

Bissell Power Track Cyclonic Upright Bagless Vacuum.. ..The spin brush works laying down....when upright it won't spin! I cleaned any and all hair from the roller....belt is not broken....but do I need a new belt though? The vac is a few years old bever replaced the belt yet.

You need a new belt. ... Vacuums

Kenmore upright vacuum power failure

... Vacuums

Kenmore Upright vaccuum self-propel won't work/engage

No, I can't solve it. However, if you go to SearsPartsDirect.com you can find diagrams for this vacuum. There are three. You can click on "View full size", highlight the image, and print it by saying "Print selection" in the Print dialog box. ... Kenmore Vacuums

Proteam Pro force 1500xp Upright vacuum... When I switch to the carpet setting I have no suction power but the beater bar is turning. If I switch back to the floors setting, the suction is excellent. Wondering if the problem is in the on/off switch?

Just undo the screws on the front part of the switch assembly, carefully check all the leads to the switch. Mine slide off all the time as the switch is poorly designed and subject to damage when the darn thing tips over (easily!!!) new switches are ... Proteam ProForce® 1500XP Bagged Vacuum

The brush on my Kenmore Pet Power Mate no longer spins. I opened it up and found the problem may be with the rubber band connecting the spinning parts. Where might I purchase a new rubber band for it?

Try this link > http://www.vacuums24x7.com/kenmoreparts.html ... Vacuums

I have a Kenmore central vacuum cleaner model number c107 34601. We have emptied the bucket and shaken the filter out to clean it. There is a filter that is filthy so we shook it out into a bag but the cleaner still seems to not have great suction. I notice there is a similar cap to the outlets I plug the central vac hose into on the unit itself that doesn't power the nozzle when used. 1 - what is this for? 2 - Should I somehow remove the entire filter and if so - can you tell me step by step ho

... Electrolux Vacuums

My kenmore power spin shampooer's brushes do not spin and how do I clean those brushes . Can they be removed?

... Kenmore 85930 PowerSpin Deluxe Upright Wet/Dry Vacuum

Replacing Power Cord Kenmore Progressive Upright

That actually sounds correct, if it's the model I'm thinking of. As long as you're talking about connecting to the wires that are held in by the wire nuts you should be good to go. \015\012\015\012-R ... Kenmore 23613 Progressive PowerMate Bagged Canister Vacuum

I have a kenmore beltless upright the beater brush dosetn spin

If it is direct drive then the motor or the wireing to the motor are bad. If it is gear driven then the gears are probally stripped. ... Windsor SR12 Sensor Bagged Upright Vacuum

I have a Kenmore Upright Model # 11630412001 with a broken power cord

What about the cord ,that he cannot figure out.... ... Kenmore 35912 / 35913 Progressive Upright Vacuum

I have the bissell power force bagged upright vacuum and the brush is not turning, I have replaced the belt but the brush will not move but the metal piece that is hooked to the motor that spins the belt and brush is turning but the brush won't, and the belt starts to burn

Sounds like your brush roll is seized. Remove the brush roll (see picture) and make both of the end caps spin freely. If not, replace it and you should be set. *An example of a brush roll* ... Bissell 3522 PowerForce Bagged Upright Vacuum

Wiring diagram for Model #11635922500 - KENMORE Upright vac I took the cover off of the vacuum to repair the power cord and must have pulled a wire out of its wire nut by the sweeper bar. If I had a diagram it would be no problem to replace. The bad has four short gray wires coming out of it. It is one of the gray wires that has come loose.

... Kenmore Vacuums

My vaccuum lost suction - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum



I have had my Kenmore 166 open a few times. There are several screws which need to be removed and a tab on each side next to the brush and a tab near the handle release lever. Use a flat head screwdriver to carefully open the tabs after the screws ha ... Kenmore Vacuums

My Dyson DC14 all surface vaccuum does not have suction except when it is upright. The brush is spinning but very little to no suction.

... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I'm trying to find the brushes for my Kenmore Power Spin, but I don't see this option nowhere.

Find the model number, then go to sears.com, click on parts and put in your complete model number, you should get a parts list and image, you can also order on-line thru Sears.com. Or pull out the brush block and go to a service shop that does Hoove ... Kenmore 85920 PowerSpin Upright Wet/Dry Vacuum

A piece of string / cord has wrapped around my Kenmore spinning brush end on the 12 Amp Power - Mate. How is the best way to get the cord off?

Cut the string with a knife or scissors and pull it off. You can turn the brush manually to ensure you get it all. ... Kenmore 22313 Bagged Canister Vacuum

Power but not sucking up.. - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

You have to check two thins\0121 that none of the hoses or filters are clogged on the unit. This is not always so easy but the entire run of the hose till the bottom must be clear.\0122 You have to have the door th the bag closed properly. If there a ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Have Kenmore Progressive Direct Drive upright. Roller not spinning. Have cleaned all debree with no luck. Took apart and discovered white plug disconnected from motor. No visible place to reinsert. Need assistance or skamatic

... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Hi there, I have a progressive upright vaccuum and the brushes are not spinning. Any suggestions?

Push in the red reset button. It's on the bottom side where the rollerbrush is. ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

I have a Kenmore Progressive upright model 216-37100800. It is only around 1.5 years old. My wife said that one day after she plugged it and turned it on, it whirred up but then shut off. Since then it will not start. I have noticed that right after I plug it in, if I try to turn it on, the first yellow light in the series of dirt sensor lights turns on then shuts off. After that the light will not light up on pressing the power button, unless I unplug it and plug it back in again. I have seen o

... Kenmore 25512/ 25513 Progressive Canister Vacuum

My Oreck XL upright is blowing out instead of sucking in. I changed the bag and cleaned the brushes; I also cleaned out the main "pipe." I looked for a place to change settings and couldn't find any, so I know I didn't inadvertently switch something. The brushes seem to be spinning at the correct speed. Thank you, Julia Byrem

... Oreck XL2200 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0773 seconds