Having problems with your Kenmore Magic Blue 24195 Bagged Canister Vacuum ?

Retractable cord is stuck and will not retract


Answers :

Repair Help & Product Troubleshooting for Kenmore Magic Blue 24195 Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Retractable cord stuck


... Oreck BB2000 XL Little Hero Canister Vacuum

Retractable cord is stuck and will not retract


... Kenmore Magic Blue 24195 Bagged Canister Vacuum

The retractable cord is stuck all the way out and will not go back in. Is there a simple way to fix this "disaster"??? without taking vacuum apart that is. And this is not my exact vacuum but I figure the cord problem would go for all of them. Ours is a ORANGE HEPA 360 Kenmore Whisper Belt 12 amp with PowerMate Model # 116.29219800


... Kenmore 27915 Bagged Canister Vacuum

S3765 My Hoover canister also has the retracting cord stuck.  It will neither retract into the housing or pull out for use.  What can be done about this 09/08/2008


The hardest part of fixing this is locating and removing the 5 Phillips-head screws without stripping the heads. There are 2 of them at the bottom front, 2 at the top back (above the wheels), and 1 at the back under the dust canister. After they ar ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Electrolux twin clean cyclonic has the cord stuck halfway and won't retract. Can anyon ehelp?


... Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

The power cord is stuck part way out - it seems to have slipped over the edge of the reel inside the machine, so it won't pull out and it won't retract. Pulling hard does no good.


Hello,Yes, pulling hard is not a good idea. You need to use techniques to get it out.Get a flat Phillips screw driver, use it to bring it out. Or use a screw drive to disassemble the part that that went inside the machine. If ... Vacuums

Hoover UH70210 retractable cord stuck, how can I get it unstuck


... Hoover Vacuums

RETRACTABLE CORD STUCK CANNOT OPEN CASE FOR ACCESS TO PROBLEM AREA


... Hoover S1361 Bagged Canister Vacuum

The Hoover freemotion pureair vacuum cleaner cord is stuck and won't retract.


... Vacuums

Black and Decker ICR505, cord stuck


... Vacuums

Cord getting stuck, won't come fully out.


Hi Karen. Chances are your cord has a kink in it which is preventing it from coming all the way out. Pull the cord out almost as far as it will come and then twist the cord one way or the other and pull to get the kink out of it. Once you have it ... Dyson DC08 Hepa Allergy Bagless Canister Cyclonic Vacuum

Replaced plug on retractable cord...but forgot about size difference, cord retracted inside and can't get it out...is there a way to get at it?


You have to split casing . Small screws underside could be hidden by feet ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Kenmore vacuum 27612690 power cord stuck


... Kenmore 22612 Bagged Canister Vacuum

Miele Red Star model S314. Cord reel is stuck. About three feet of cord is out. The rest of cord is jammed inside machine? How do I get to where the cord reel is?


It is actually simple when I tell you, Here we go... \012\012First, open the lid and take the bag, and hepa filter out of the machine. \012\012With a slot screwdriver, pry the hinges of the bag door out a little and take the b ... Miele Red Star Bagged Canister Vacuum

How to wind cord onto spring loaded retractable cord reel for a Kenmore canister vacuum. There is a metal 'U' shaped, spring loaded, piece that fits over the outer aspect of the wheel. If cord needs to get wound on under this metal band I can't figure it out and the band is like factory sealed onto the wheel. Also. I don't know which direction to feed the cord onto the wheel


What is the exact model # please?Thanks!! ... Kenmore Vacuums

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!


Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

My Kenmore 7520 canister vacuum has a problem with the retractable cord. It has jammed and does not come out or retract. It jammed half way through the retracting action. Cannot pull it out or retract. Would like to know how to open the canister to take a look for the problem. Thank you


... Vacuums

Retractable cord does not retract


Hi\015\012\015\012To open the back cover of the Electrolux vacuum you’ll need to follow these instructions. Check for the two bumpers on either side, that say ELECTROLUX, hold the egg shell together. \015\012After this remove ... Electrolux Lux 5500 Canister Vacuum

I just purchased a Sebo Airbelt D canister vacuum. I plugged it in and used it for ten seconds then turned it off, retracted the power cord and now cannot get the power cord out of the machine. Did I not spend enough money to get a quality product? Does anyone have any idea how to get the power cord out without breaking the machine?


... Vacuums

I have an aerus electrolux guardian canister vacuum. The cord was damaged but the retraction winder is still fine. I have ordered a replacement cord but I have no idea how to remove the old cord and install the new one. Am I over my head?


The winder is activated by a coil spring located in a drum. The drum transmits the power from the wire with 2 circular contacts. To replace the cable you must dismantle the case to access the drum, take the spring pressure out carefully as to not let ... Vacuums

Problem with cord rewinding mechanism on my Nilfisk King!Whilst repairing broken cord(successfully)the metal coil thats part of that mechanism sprang out!Can someone out there tell me how to put it back together again PLEASE.I would so like my cord to be able to retract again


... Vacuums

Hoover UH70120 WindTunnel TSeries problems with the cord. im a tech savy guy and have been trying to fix a cord after it was pulled to far out and now wont auto retract, but just cant find a way to pull the cord rewind mechanism out to work on it. Any advice


You will probably have to replace the cord winding mechanism. I have never had any luck trying to repair one. Cord retracters are great when they work but it seems like they always go bad before too long. On many units you can't even replace the cord ... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

Hi , I have replaced the electric cord on Electrolux Lux Royal vacuum , but the rewind that retracts the cord does not pull it in . The coil spring looks ok but it will not pull the cord back in , any suggestions please . Thanks Dave Ryder


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=564353\015\012Generic problem for all Vacuums\015\012Hi, I have replaced\015\012Posted by dryder on May 02, 2008 ... Vacuums

Retractable power cord


JUST LIFT OFF THE TOP HALF. CAREFULLY REACH IN FROM THE LEFT SIDE AND DISCONNECT THE CLEAR PLASTIC HOSE THAT IS ATTACHED TO THE "DIAL" ON TOP OF THE MACHINE. THEN LAY THE TOP HALF OF THE MACHINE TO THE RIGHT. DON'T DISCONNECT ANY WIRES. YOU'LL HAVE T ... Electrolux Lux 7000 Bagged Canister Vacuum

Barrel Dyson DC08 Origin cord rewind button is stuck.


... Dyson Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0215 seconds