Having problems with your Kenmore Magic Blue 24195 Bagged Canister Vacuum ?
I need a new floor attachment for my magic blue.
I need new floor head for my kenmore magic blue, where i can buy?
Repair Help & Product Troubleshooting for Kenmore Magic Blue 24195 Bagged Canister Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I need a new floor attachment for my magic blue.
I need new floor head for my kenmore magic blue, where i can buy? ... Kenmore Magic Blue 24195 Bagged Canister Vacuum
I have a Durbrand Canister Vac, Model #C2006 and need a replacement hose for it. Also could use a new floor attachment.
I have a Harmony vacuum and need it only for bare floors. The attachment I have seems to be too rough on the floors. I just need a simple attachment with soft bristles for a bare floor that will fit this vacuum.
Take the lower portion of your wand to a vac shop and ask for a universal fit wide floor brush with NATURAL bristle. The soft bristle is much better quality and will clean deeper into grooves in your wood floor or and tiled area. ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum
Need to replace power head for blue magic Need
... Kenmore Magic Blue 24195 Bagged Canister Vacuum
I think I need to replace the main battery in my small floor vac - the one that can be hand held like a dust buster or work like a small floor vac. I need to know how to remove the battery and replace it with what kind of new battery..
I see my sense of humor is not appreciated...it was only a joke. Anyway, here is what you do: First, slide the battery cover off the bottom of the hand held unit. Remove the battery from the motor housing by pressing the tab on connector “A&rdq ... Vacuums
Attachment problem used a new unit w/attachment for 5 minutes...dispensed solution in a powerful triangular fashion. Then the fluid quit dispensing out of the attachment nozle amost like the pump quit working. Primed the unit several times w/ no success. checked for clogs. can't tell if the floor portion is "pumping' or just dribbling solution onto the floor with the trigger. can see no leaks at this point. unit worked for about 5 minutes on apholstery
Make sure everything is filled and secured tightly, if this a new unit it should be something simple ok, also check where machine folds down that the solution hose is not being pinched its right behind the dirty water tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
My new Kenmoore Powermate 116 canister has poor suction. I have no pets and light dust. Its not picking up small particles on the wood floor with the floor attachment. When I put my hand to the suction it feels weak. Cleared hose and changed bag. Using again, same issues. This should not be happening with a new vacuum. Is it a bad design in the elbow joint of the hose? I want to return this!!!!
First of all disassemble the handle and hose as much as possible and examine the inside. Make sure there is not any significant debris lodged in the hose somewhere like a plastic bag or something.\015\012\015\012Also check at the top of t ... Kenmore 23912 Progressive PowerMate Bagged Canister Vacuum
I have a Kirby Micron Magic with Hepa filtration, the ultimate G series and I have a carpet shampoo attachment that attaches to the front but I need help assembling it.
Hello,\015\012Here is my free online guide for the shampoo system...\015\012\015\012h ... Kirby G6 Bagged Upright Vacuum
I have the DC28 Animal model. When I attach the articulating floor tool, the hose suctions itself closed and the attachment doesn't work. Is there an adapter I need??
... Dyson DC28 Animal Bagless Upright Vacuum
I need the floor attachment with the hose to attach to the hand wand for the shark model ep754.
Get your parts off link belowhttp://www.sharkclean.com/cgi-bin/ ... Shark Professional/ Hepa Pro Canister Vacuum Model Ep754
I have a beam adjustable wand with an attachment on it meant for hardwood, or linolium floors. The wand is broken so I would like to take the attachment off and put it on a new wand. How do I get t
... Beam Vacuums
SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?
I have the dyson dc07 all floors and have a new belt- I have removed the black cover but cannot see where to attach the new belt ! Hope you can help-Carole
Hi there Carole, VacuumGuru here. \015\012I have made a video on how to access the ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I can't get the solution to spray or suction from the floor . the hand attachment will spray somewhat and suction, but not from the floor. i have the blue 9200
If it is only a problem with the floor sprayer, this suggests that the nozzles or tubes to the floor unit are clogged. Take off the water storage part, and you'll see two red clips (these are the floor nozzles). Squeeze and pop these out, and see i ... Bissell 9200 Upright Vacuum
My vacuum just stopped working, so I don't know what the problem is. I used it in the kitchen to vacuum the hard wood floor. I turned it off, and a few minutes later, turned it back on to finish vaccuuming the kitchen floor. It just would not turn on. I had not unplugged it or did anything to it. I then tried to see if it would work in another plug, and no luck. I'm trying to figure out if it can be fixed or if I need to look for a new vacuum.
When I get most Vacuums that have dies on people most of them the wire has been worn and cut one or more wires on the plug cord. Sometimes the cut can be over looked. Please unplug and check the wire carefully.Also please post the make model a ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum
Attachments The hose attachment doesn't spray out water. it seems like the trigger doesn't pull back enough. Is there something I can do to fix this or do I need to get a new part?
Most likely will have to replace either the nozzle valve or the hose comes complete, so if the nozzle pieces are available, then replace the complete hose asm. ... Hoover V1 SteamVac SpinScrub Vacuum
The hose is disconnected, new bag in unit, new filter, unit runs when hose is detached but immediately turns off when hose is attached but hose has no obstruction, etc.. i was told i need some sort of valve. HELP! I have birds, a cat and 2 large dogs and no vacuum :)
There is a vacuum hose that attaches inside the unit to a round clear plactic piece. In most cases you can simply cut the small vacuum hose and it will fix the problem. ... Electrolux Epic 3500 Vacuum
Kirby G7, hose ripped out of the base attachment. Can this be fixed or do I need a whole new hose assembly??
You mite be able to get the part you want from the link belowhttp://www.vacpartswarehouse.com/Kirby-Ultimate-G-Diamond-G7-Upri ... Kirby G5 Bagged Upright Vacuum
My daughter has lost the part/fitting that holds the dust bag to her blue ultra silencer electolux vacuum cleaner purchased late 2007.She needs a new one. Thanks Anne Roberts Can be contacted at [email protected]
Find a local vacuum shop that deals with elexlux they can order you the part ... Electrolux Vacuums
Dirt devil vacuum cleaner--trouble vacuuming dirt and pet hair on carpeting --is the problem with the spinning brush which contacts the floor, not contacting the carpeting?? I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting. Sometimes, it seems like nothing is being vacuumed up --unless I have just put a new bag on the vacuum... Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
Try replacing the belt. Rubber belts stretch out after about a year. ... Dirt Devil CE6100 Featherlite Upright Vacuum
Very end of hose on kenmore 116.35923 upright has broken and attachments won't stay on. need new hose or a way to fix the end of this one.
... Kenmore Vacuums
Require parts diagram to Electrolux ZT17667 - need to the entire floor cleaner attachment that fit on the end of the tube.
... Electrolux Vacuums
Need main floor head, where to purchase?
Www.euro-pro.comorwww.euro-pro.com/europroorhttp://www.google.com/search?q=europro&ie=utf-8&oe=utf-8&aq=t&rls=org.mozilla:en-US:official&client=firefox-a ... Euro-Pro EP055 Bagged Canister Vacuum
Little suction and pours water underneath machine on the floor. This all happens while i am using the hand attachment tool, but also occurs when i tried just the machine is running..what am i doing wrong. it is new..only used once about 6 months ago
Press the handle release kick-button with your foot, extend the handle all of the way back, and take a look at the gap between the base of the unit and the handle/reseviour assembly. You should see several black hoses attached to the base and running ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum
I have a dyson dc all floors and I need a new bottom brush, will I be able to replace it myself without breaking any plastic parts,if I order the brush online?
I would say to take it into a shop. Don't try it yourself Dysons arent any vacuum you can just go into target and buy for 50 bucks. there not made to just be taken apart. ... Dyson Vacuums