Having problems with your Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum ?

Noise vacuum making a very loud noise but suction seems to be ok


Answers :

You might have something stuck in the motor fan like a paper clip or a bobby pin.might have picked up a coin or a nail.regardless it sounds like its in the motor fan.you need to disconnect the base from the upper half of the vacuum to get to the motor.on the top of the base on each side of the motor you will see a small plate with 2 screws on them take them out and you should be able to seperate the base from the top half of the vacuum.you will see the motor housing and on one side you will see the fan.look and see if something is stuck in the fan.if so try to get it out and put everything back together start from the last thing i explaind all the way up to the first thig i explained
I have the same problem with the same age Kenmore. I checked for clogs but there were none. The loud noise sounded like a vibration. The noise was so loud you almost couldn't be in the house when using the vacuum. What I found was, the outer rubber housing of the motor/fan was held together by electrical tape and split at the electrical tape (wow, that's a surprise!!). I taped the housing together with fresh tape but the motor housing continued to split when the filters got slightly clogged and higher pressure was generated inside the motor. I suspect that the split was causing some amount of air from the motor to be exhausted into the inside of the vacuum causing internal parts to vibrate and resonate.

I haven't been able to fix this problem. Unfortunately, the excessive vibration caused a control board to fail which controls the agitator. At this point the vacuum is useless. Poor design by Kenmore so I don't know if it can be fixed.

If you know of a solution, let me know
Repair Help & Product Troubleshooting for Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Noise vacuum making a very loud noise but suction seems to be ok


You might have something stuck in the motor fan like a paper clip or a bobby pin.might have picked up a coin or a nail.regardless it sounds like its in the motor fan.you need to disconnect the base from the upper half of the vacuum to get to the moto ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

When I vacuum w/ the brush control in the on position it make a really loud noise, almost like a grinding sound. I have looked at it and nothing seems to be wrong, but I notice that the pin that engages the belt seems to vibrate a bit, possibly creating the noise. It started when I accidentally got part of a plastic grocery bag caught in the brush. Could it have stretched a belt? Nothing is caught any other place and it only makes the noise when the brush in in the on position.


Yes, the belt could have been stretched and is now vibrating and hitting other parts and creating a noise if much of the bag got caught under the belt. If you have another belt for this vacuum, please put it on and see if the noise stops. If it does ... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum

The vacuum seems to be making a high pitched noise when it is being used to vacuum the carpet. It does not seem to have the suction that it had before we noticed the noise.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My upright kenmore progressive vacuum will not suction up when using the sweeper. It will suction things when I use one of the tools. I have put in a new bag and have tried to see if anything is blocking the bottom. It sometimes makes a very loud noise when I try to vacuum. If I press the intell clean on and off yellow button the noise may go away but it still does not work.


Double check hose placement, making sure you have the hose inserted into the correct slot. The long attachment nozzle stores in the front hole on the right, and the sucking hose inserts into the rear hole on the right. I know this is too simple of a ... Vacuums

My Kenmore progressive vacuum is extremely loud. The airflow and suction seem to be uninhibited, but the noise is loud and frustrating. Should the filters just be cleaned or is this a sign of a different problem? It's a Kenmore Progressive Bagless Upright Vacuum 35912 and we've had it for about four years.


... Kenmore Vacuums

My Miele capricorn has started making an odd noise. It seems like something is blocking the engine. I've turned if off and on, and reset it and it still have the odd, almost loud barking noise. The power nozzle also does not seem to be working. I've checked the connections. Right before this happened I was using the vacuum. I didn't notice anything out of the ordinary until this.


Greetings,\015\012\015\012This is a major problem. The Miele vacuums motor should never make a loud noise, period. The way the motor is designed, it's quiet and should be quiet for the life of the motor. There are two motors on your ... Vacuums

Hi my vacuum (Russell Hobss 2200 bagless HEPA) seems to have just enough ( not loads) of suction til it reaches the cleaning head. the head does not appear to be blocked - but there is then almost no suction at all. It also makes loads of noise when on- and an even louder noise when turning off. is it fixable or is it dead? Thanks


Generic problem for all Vacuums\015\012Hi my vacuum (Russell Hobss 2200 Bagless HEPA)\015\012Hi my vacuum (Russell Hobss 2200 Bagless HEPA) seems to have just enough (not loads) of suction til ... Vacuums

I have a Model U57809RM Hoover Cyclonic which started making a very loud noise. Changed both belts on it but the noise persists. It seems to happen when I put the handle in the 'engage to vacuum' mode. The minute I start to lower it the noise begins. Help!


Hello,You could have a broken fan in the motor and need to replace the fan. If the noise is coming from the brush area of the vacuum, you probably have a broken bearing in your brush roller and would need to replace the brush itself. ... Hoover Vacuums

Kenmore upright vac model 33922 - good suction but developed loud whining noise after accidentally vacuuming room without bag. Added bag and changed both filters. Still makes noise. How can I stop noise?


The bag is the first stage in your filtration. Most times what you did will draw fine dust right through the filters and into the motor itself, affecting the bearings and clogging the motor fans, throwing them off balance. The fact that there i ... Kenmore 33922 Direct Drive Bagged Upright Vacuum

Hi folks, my beam vacuum makes a very loud roaring noise quite often. the problem started when i was vacuuming up a quantity of vermiculite from my chimney. i think i overloaded the vacuum i think and it made this loud roaring noise. the vacuum tends to make thos noise when i am hoovering after 5 minutes or so. any ideas?. thanks in advance Tom....


If the filter bag is bad and didn't trap all of the dust, then it got into your motor, so you may have a problem with your motor now. ... Vacuums

My Kenmore bagless intelliclean vacuum is making a loud noise mainly when it is vacuuming on the highest setting (when the light is red). We have taken it apart and cannot find a clog. It has also lost suction.


This might help, it was posted on a previous problem but is the same issue you are having it seems: "Here is a possible solution. If the v ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Rainbow Vacuum, about 5 yrs old (bought new, no issues prior) - my 6yr old tipped it on it's side while water was in basin. Now when I turn the power on, it makes a very loud sound in the motor and you can feel the vibration on the floor. The suction still works and basin still catches dirt - the noise is just so loud and I'm not sure if I should continue use or how to fix -?


Although a wet/dry vacuum, it cannot tolerate water in the motor. Water will cause the motor to short out, which will cause the motor to act/sound like yours does now, if it continues working at all.\015\012To prevent additional problems, the ... Rainbow E series Canister Wet/Dry Vacuum

My Hoover Wind Tunnel Bagless Pro Pet is making a very loud thudding noise when the belt rotates, belt seems to be intact and in place, what am I missing? Vacuum is less than 6 months old, belt is not worn and motor seems to be fine.


... Vacuums

Attachment has lost suction and vacuum makes a loud air noise when put in the upright position


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My DC15 All floors makes a very loud noise now when I clean with it. The suction seems ok but not as strong as when it was new in 2008. This machine gets very heavy use.


... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

My Model number 11635923502 kenmore vacuum is making a deep suctioning noise as if something is stuck in it. We have cleaned out the filters and all the vacuum lines thinking it was clogged. It is still making this noise and we are frustrated as to what could be causing this problem. The unit does not have much suction.


... Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue

Vacuum makes louder than usual loud noise and seems to run at a super high speed. I wonder if a belt needs to be replaced.


... Eureka 421A EZ Kleen Bagless Stick Vacuum

Loud noise I have a brand new Dyson and it is great on all my floors except one of my area rugs when it starts making this really loud vibrating noise. I am not sure why - nothing is stuck in the roller or vacuum and it doesn't make it on any of my other rugs. Also it is really hard to push whereas all the other floors it just glides. I don't want to return it but I also don't want to hear this sound every time I vacuum.


This is the clutch as it jams up in the brush. Usually happens with rugs that are not secured to the floor. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I replaced the belt on my Dirt Devil Featherlite Bagless Vacuum and the brush roller rubs and makes a very loud noise when turned on. I have gone exactly by the manual instructions and made sure the belt and end caps were on correctly, but the bristles still rub the back and it makes a very loud noise. Without the brush roller in the vacuum, it sounds and runs normal. What could the problem be?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=561283\015\012Generic problem for all Vacuums\015\012I replaced the belt on\015\012Posted by piggyt ... Vacuums

Hello. My dyson dc04 keeps making a loud screeching noise when im vacuuming. It seems as though the plastic from the brush is catching on the plastic on its holder either side of the belt. Is there any way of fixing this problem?


Remove base cover by 3 'screws' 1/2 turn anti clockwise and clean well remove fibres replace cover and re try. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Makes a extremely loud alarm sounding noise while vacuuming and the cord in the back doesn't have good suction at all.


When you hear the whistling noise, means there is a clog either in the hose itself, or in the elbow where it goes in or from where the bottom tube bends and goes up. To clean hose, remove it, stick on top of broom/mop handle and push all the way down ... Bissell 6591 Power Trak Revolution Bagless Upright Vacuum

Motor makes loud growling noise, no suction on model 270 i Miele canister style vacuum


Hi there SmartAlec from NelsonVacuums.com.au here. Unfortunately that normally means the motor has shot its bearings and/or its carbon brushes. I think it is time to purchase a new one. On the bright side there are some rreally great vacuums out ther ... Vacuums

I HAD MY DC17 VAC FOR 3 YRS NOW NO PROBLEMS AT ALL, I REGULARLY CLEAN THE FILTER LIKE IT SAYS BUT LATELY I'VE NOTICE THAT THERE SEEMS TO BE A LOT MORE COLLECTION ON THE TOP OF THE FILTER WHEN I'M DONE VACUUMING. IT HAS ALSO STARTED THIS WEEK TO MAKE A VERY LOUD HUMMING TYPE NOISE WHILE RUNNING, I HAVE CHECKED FOR ALL POINTS FOR ANY BLOCK AND NOTHING AND NOW TODAY IT RUN A FEW MINUTES AND STOPS AUTOMATICALLY,IT WILL RESTART AFTER I LET IT SIT UNPLUGGED.WHATS UP WITH THIS THING, IT HAS BEEN GR


The vac is over heating. First, you should try a new filter. Also, keep in mind that after cleaning the filter, make sure that it fully dries. Using a wet or damp filter clogs it quickly. Second, turn the vac upside down and make sure that the roller ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson is making a loud screeching noise. I is hard to vacuum. Seems weighted down. Still sucking up.


... Dyson Vacuums

My dyson DC24 makes a loud noise when turned on. The air flow seems to be going out another another end on the vaccum kind of by the on switch.


Hi there,I'm sorry to hear you're having difficulty with your DC24. If the relief valve is activating, you may have a blockage somewhere in the machine, and the filters may also need a wash.To locate and remove any blockages, please f ... Dyson Ball DC24 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0936 seconds