Having problems with your Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue ?

I acquired an older Kenmore upright vacuum (Model 116.38612790) - Cannot figure how on earth you open to check the belt. Help!


Answers :

Repair Help & Product Troubleshooting for Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I acquired an older Kenmore upright vacuum (Model 116.38612790) - Cannot figure how on earth you open to check the belt. Help!


... Kenmore Progressive Upright Vacuum with InteliClean System Slate Blue

I have a Kenmore 116.36932 (upright-bagless vacuum) that the motor protector by-pass valve has opened. I've clean out the area between the agitator brush where the flexible extension hose starts. There was some blockage there. I checked the rest of the system (extenstion hose, back filter area, pipe area to canister and area to side filter. I took the 2 filters out and the by-pass valve is still open. Where else could there be a blockage that I can take apart to clean and put back together


... Vacuums

Hover F7452-900 My brushes are not turning. I have taken the tanks off to check the switch that changes from carpet to hard terrain to Ceramic tile.I noticed that there is a spring that has came off. I tried to disassemble the top half (nose) of the cleaner but I have came to a stand still. I cannot figure out how to remove the cover so I can figure out where the spring should be attached. I have removed all the screws that are visible and it still won't budge. It is loose but on the back side o


Regarding the brushes not turning:\015\012\015\012Your filter may need to be cleaned. It is located behind your brushes. With your tanks removed and the cleaner unplugged; tilt your cleaner back. The filter screen located behind your b ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Dear Sir or Madam, I own a black 23 x 47 x 7 mm Rowenta lighter. It has a screw on bottom that I cannot remove. What is it hiding ? Is this lighter refillable ? Is there a flint to replace ?. I've found on your site the following : "By jbbiii on Apr 06, 2009 Father died and left me a Rowenta lighter purchased in Stutgart in 1952. It has a screw on bottom with spring to replace the flint, but I cannot figure out how to open the bottom to replace the cotton wadding which I can see through the hole


Hello \015\012The flint should be near the striker.Or the thumb roller,usually below it.\015\012As old as it is you may not see it beacause its worn down.\015\012\015\012Maybe taking it to an antique store or a smoke shop woul ... Vacuums

I cannot get the Kenmore power-mate open to change the belt? How does it come apart?


... Kenmore Vacuums

Mine is a much older Kenmore 840 which for years has only retracted the cord part-way. I expect there is dirt in the retrieval mechanism but can't get at it. HOW do you open this type of vacuum when it seems sealed all around and there are no nuts, bolts or screws visible?


... Kenmore Vacuums

I have an older Kenmore vacuum cleaner - Model #3285590C, Serial #DG4117817. I can't seem to figure out how to get the motor cover off. 2 bolts in the front have been removed but the back has no visible bindings. It seems to be held from inside the compartment! Whats the catch here!


... Kenmore Vacuums

I've misplaced the manual and cannot figure out to how to open it so I can change the bag.


... Dirt Devil CE6100 Featherlite Upright Vacuum

I have a kenmore 116.25615506 vac and I want to replace the connector on the power sweeper. I cannot figure out how to disassemble the "electric folding wand" to get the connector out


... Kenmore Vacuums

I have an old Hoky Omni carpet sweeper. I took it apart to clean the inside. Now I cannot figure out how to get it reassembled.(specifically the two buttons that open the bottom to discard the dirt, and two small wires that go somewhere)


... Hoky Vacuums

My Kenmore 7520 canister vacuum has a problem with the retractable cord. It has jammed and does not come out or retract. It jammed half way through the retracting action. Cannot pull it out or retract. Would like to know how to open the canister to take a look for the problem. Thank you


... Vacuums

I was given this Kenmore Model# 385. 17324990, sewing machine, no manual came with it. I cannot figure out how to remove the bobbin to re-wind it, and how to thread it to re-wind.


... Vacuums

I have a Kenmore 360. I cannot open it to change the bag Please help111 Thanks


... Kenmore 25512/ 25513 Progressive Canister Vacuum

Sounds dumb but have my grand-daughters laptop and cannot figure how to put dvd in it to watch,. do not know how to open and close tray. please help. laptop is a dell studio


Hi, Switch on Laptop. \012On the side of the laptop is a compartment. Place on table, look both sides, on one of the sides there will be a small push button, slight pressure, remove finger, and drive will "POP" out. ... Vacuums

My Kenmore elegance small beater bar stopped rotating. there is a small metal wire that we cannot figure out where is goes back please help.model #116.22950400c


... Kenmore Vacuums

I have a kenmore vacccum model number 26512690 and I need to service the bearings inside but I can't figure out how to open the exterior case.


Open the lid, push it all of the way back until it comes off. There 2 screws on the back cover, remove them, then using a pry, slip it under the cord return pedal and pry open to remove it, then there are 2 screws to remove, then the top cover will ... Vacuums

I have a Morphy Richards Grime Buster 2200 and the cap on the tank turns but will not open. I cannot find the manual to check out any possible trouble shooting advice. Any ideas would be most gratefully received, thank you.


DId you find a solution? I cant open mine!!! ... Vacuums

Dyson DC04 i have a loose wire where the cable enters the cleaner how do i open the part where the on/off button is. A wire is loose probably but I cannot get to the interior to check its status. How can I take it apart? the plug is sealed but could it be a loose wire in there?


You have to remove the yellow switch but to do this there is a small hole at the side of the switch nearest to the machine you have to push something in this which will push the clip that is holding the switch if you can do this there is a screw behi ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

Changeing belt how do you install a new belt? I have an Eureka, The Boss, bagless, upright. The brush is hardly rotating. I think it could be the belt but i cannot open the vacumm to check it. How can I fix this?


... Vacuums

How to open motor compartment to check motor on Kenmore canister vacume cleaner model 8120


... Kenmore Vacuums

My husband vacuumed up a pound of feta cheese into the upright vacuum. Cheese is inside, on wheels, etc. I cannot figure out how to open so that I can clean the brush and the isides. Help! Linda


Yes - an independant vacuum repair shop is unlikely to repair (disassemble) - as this vac is no longer supported (in case something is broken during servicing).\015\012You will (probably) find the repair to be more than the cost of a new vac. ... Vacuums

My kenmore intuition vacuum seems to have lost suction and the check bag light comes on. the bag has just been changed (2x). cannot see if there is any type of blockage. any ideas? thanks. ps. only had this vacuum for 3 months.


If you bought it new then do not screw w it take it back to sears and demand a replacement or your money back Sears is very reasonable re this ... Vacuums

I have an older hoover vacuum and cannot figure out how to put the belt on?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=542813\015\012Generic problem for all Vacuums\015\012I have an older Hoover\015\012Posted by rrunne ... Vacuums

Houver Cleaner My self propelled windtunell baged Vacumn has a broken belt. The small visible one that is visible is intact. This is the thick belt. I cannot for the life of me figure out what to open and how to replace it. The model # is U6 401-9RM I keep asking for a manual online but it doesn't recognize this number. I am 67 yrs old broke and fix it challenged..lol can you help me?


Take off the bottom plate, The flat belt ges around the motor shaft and then around the bigger pulley by the V belt. It will stretch to o on.\015\012\015\012 ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I cannot open and replace belt on Kenmore Model 116 (594299900) BELT ( 20-5285


The manual is here and there are diagrams on page 17 and 18 showing how to access and replace the belt.http://www.hammerwall.com/Manuals/Kenmore/Description/116.20612003/Kenmore%20Canister%20Vacuum%20Cleaner%20Manual/L0705059/I hope ... Kenmore 25512/ 25513 Progressive Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0524 seconds