Having problems with your Kenmore Quick Clean 30012 Vacuum ?

When vacuuming floor the air release opens on its own

\015 When vacuuming the floor the machine has a ?air release? on the back, it will open and the vacuum stops drawing from the floor the hose is secured tightly....how do I fit this?\015

Answers :

Sounds like you have a clog in the throat of the floor head. The air release assures air continues to feed and cool the motor.

Check the floor head for a restriction.
Repair Help & Product Troubleshooting for Kenmore Quick Clean 30012 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When vacuuming floor the air release opens on its own


Sounds like you have a clog in the throat of the floor head. The air release assures air continues to feed and cool the motor.Check the floor head for a restriction. ... Kenmore Quick Clean 30012 Vacuum

Manual I realize it's probably something simple but how do I release the Cyclonic Chamber on top of the Dust Cup lid? I see the red 'open to clean' release button but how do I get down in there to push the release button? Thank you in advance for your help! Best, Christy


Manual > http://www.sharkclean.com/manual/NV22-NV22C-NV22P-NV22T-NV22Q_REV_1008.pdf ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug


Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

We have the Kenmore progressive direct drive (bagless) and have had it for about 3 years. We have taken good care of it, and paid quite a bit for it hoping that it would last for a good long time. It has started making a noise that seems to be an overflow air type of noise coming out of a bottom air outlet opening for when the air flow is blocked. We have looked into clogs, changed filters, and the whole works, to no avail! Quite Frustrating since I love this purple vacuum! The machine started


There has to be a clog or block somewhere - if the motor works, it should work did you try a wire coat hanger to go up in further where you cannot see?Bets regardsCk ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Dyson, pressure release valve keeps going off and staying open.


There are a couple of things you can do, the blled valve (pressure valve) activates when there is a blockage in the machine. You just need to find the blockage:\015\012\015\0121) To check for blockages from the bottom of the machine. Remo ... Dyson DC07 Bagless Upright Cyclonic Vacuum

On my Air Vac model AV425A Central Vacuum System, I discovered the circuit breaker opened. When I close it, the vacuum motor goes on. It doesn't matter which position the on/off switch is on, it runs until I open the circuit breaker again.


... M&S Systems ZX7000 Bagged Central System Vacuum

The hose works great, but the head of the vaccuum does not pick up anything !!! I checked every opening that may have been clogged, but nothing came up. When I hold my hand under the brush/roller, it seems to be putting out more air than intaking air. Particles "dance" on the carpet, but don't get "sucked up" into the vaccuum ? I have had the vaccuum only 1 year, so the brushes should not be a problem. I changed the bag, and checked the belt. The belt and brushes seem to be OK. ?


Hi there,Uprights are notorious for debris forming clogs when changing direction. The 90 degree turn where the base suction goes up. Have a closer look . You may need to pull the base plate off to access the blockage.Best reg ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

We have a Bissell Proheat 2X (model 8920). The problem we are having is when water/soap is initially released (all settings) it continues to leak out the front water spray nozzles unit the water containers are empty. The vacuum works but can't keep up with the continuous water leaking out. Do you have any idea what is sticking open to allow the continued release of water when the machine is running? Thanks Rick


Return it. It is faulty and should not do that. Mine does not. Does require changing water about evrery 10 minutes but one can see the filth in the water. Also re-clean with plain water over areas that were cleaned to remove all cleaner. Old cleaner ... Bissell 8920 ProHeat 2XTM Upright Vacuum

Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Cannot open bonnet on fiat punto pulled the lever it popped up went to lift bonnet but cannot open it as it seems to be still locked lift the lever but does not release it


... Kirby Shampooer Shampoo Hose G3 Ultimate Diamond Vacuum

I have a 41a5021-18 chamberlain security+ 1/2 hp garage opener that requires constant pressure on the down position of the wall switch in order to close. If I release the switch the door reverses direction and completely opens.


... Vacuums

My central vaccum cleaner has no suction at all outlets even at the canister. The motor is still working and blowing air out the air release tube. What could be the problem


Check the filter in the tank. If this is dirty, the motor will still run, but there will be little to no suction. Rinse thoroughly under warm water, then allow to thoroughly air dry before replacing into vacuum. \015\012I recommend having tw ... Electrolux Central Vacuum

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than


Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

I have a Neotec XJ-2000 ionic air purifier. On the bottom of the device, it says I should open the casing and take out and clean the dust filter every month. I haven't done it in years and no longer have the manual. How do I open it up to get the dust filter out?


... Vacuums

I can not open the dirt cup because the release button is stuck or just won't open. Help!


... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Kenmore blue magic lid is stuck and the lid release latch will not open canister


... Kenmore Magic Blue 24195 Bagged Canister Vacuum

Bin bottom release snapped off. How do i open the bottom?


Take out the three screws on the to near the handle inside you will find the remains of the old part you can either replace the old part from the top and put it back together to open it normally or you can use the old release stick to push down the c ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I HAVE A DYSON DC07 PINK VACCUM -DON'T KNOW HOW TO OPEN BOTTOM TO RELEASE THE DIRT??


... Dyson DC07 upright vacuum - pink

Dyson blowing top of cyclone air release valve.


It sounds like the same problem I was having. I had loss of suction through he hose then all of the air was coming out through the vent/valve on top of canister. If you are looking at your dyson from the back, look at the bottom. You will see a purpl ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Wap 300 aero. Air release cover.


Contact wwwultimategarage.com. They are a stocking dealer for Wap vacuums, and can probably get the part for you. Wap is one of the best vacuums made & is definitely worth fixing. ... Wap Cleaning System: SQ 15 Gallon RDF Vacuum

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.


The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag ... Vacuums

Broken release lever/pedal, I have a new one but can't open up the machine to replace it.


Hi, To remove the lever/pedal, you will need to remove the bottom cover and roller assembly. Look closely for any screws that will be in the area you will be working on as they are difficult to see at times. It would be difficult to walk you through ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have a kirby g4 how do i make it blow air (instead of suction) - I already attached the hose and the little attachment with a little ending to fit the inflating opening? thanks


Hi There,\015\012\015\012Here's a step by step guide explaining what you have to do to change your Kirby from a vacuum into a blower:\015\012\015\012\015\012Step 1. Make Sure That Your Kirby is Unplugged from the wall. ... Kirby G4 Bagged Upright Vacuum

My irobot 550 has an error 9 problem that is not resolved by tapping the front bumper or blowing air into the 4 openings behind the bumper. What is the fix for this error?


... iRobot Roomba 550 Vacuum

I am unable to open the canister to remove the old bag, unclipping the 2 clips on the side does not release the canister. What am I doing wrong?


Overtime the dirt canister can get somewhat stuck. Once you unclip it, you will need to apply some force and pull down. The dirt canister should release. ... Broan-NuTone CV350 Central Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0245 seconds