Having problems with your Kenmore Quick Clean 30012 Vacuum ?

Kenmore Quick Clean - how to remove dirt from cannister

\015 I have a Kenmore Quick Clean, which I bought at Sears on sale. \302\240When I got it home, I realized that there was NO Owner's Manual with it. \302\240When I called the store, they told me that it was probably an 'open box' purchase - meaning that the product had been sold, then returned. \302\240The returned products often no longer have the Owners' Manual with them. \302\240The sales lady told me that all sales were final and that I could find a copy of the Owners' Manual on the Kenmore web page. \302\240However, when I tried that - I had NO luck. \302\240\015\012\015\012Basically, all I want to do at this point is to figure out how to remove the canister which holds the dirt so that I can empty that and begin the operation all over again. \302\240I have looked in every conceivable nook and cranny but just can NOT find any kind of latch or button which would release the canister so it can be removed and emptied. \302\240Does anyone know how to do this. \302\240Also, if someone has a ink for the CORRECT Kenmore web page which WOULD have a copy of the Owners' Manual for this product, I would greatly appreciate it! \302\240Thanks in advance - Deborah\015

Answers :

This is the web site for Kenmore owners manuals


Please take the time to give this solution a fix ya rating

If you look at the top front of the canister, there is a groove that may say release above it. Pull up; it is a handle, and then pull forward. The canister will then release, and you can twist off top, and empty canister. I hope this has been helpful.
Repair Help & Product Troubleshooting for Kenmore Quick Clean 30012 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Quick Clean - how to remove dirt from cannister

This is the web site for Kenmore owners manuals--->http://www.managemyhome.com/mmh/<---Please take the time to give this solution a fix ya ra ... Kenmore Quick Clean 30012 Vacuum

My Kenmore Quick Clean vac clogs at the top of cannister and does not let dirt to go to canister. After vacuum for few minutes have to stop empty before continuing to get rug clean. Is there anything that I can do to solve problem.

You need to own an air compressor,and blow out all vacuums ,after each use. ... Kenmore Vacuums

My kenmore quick clean vacuum cleaner has no suction. Just seems to blow the dirt out and away from the cleaner. The canister is empty and the filter is clean, so what's going on?

Hi,\015\012The hose or hoses are plugged...take all the hoses apart and stretch them out... run a stiff wire through them or something like a broom handle...you will find that they are full of dust and dirt inside...\015\012\015\012 ... Kenmore Quick Clean 30012 Vacuum

Hello, my names Travis. I was contacting you in concern of my Kenmore Quick Clean 12AMP Vacum Cleaner. My girlfriend took the bottom off the vacum and removed the belt because the vacum wasnt picking up. I know have a new belt i just dont know where to put it on the vacum to reinstall it

Look for grooves on the motor shaft and on the brush shaft. ... Kenmore Quick Clean 30012 Vacuum

Kenmore bagless 116.36932502 the interior filter port fills up very quickly-withih minutes of initial startup-- and has to be removed and cleaned constantly. Debris backs up into the interior of the main filter as well, the main canister never gets full. New problem with old machine!

... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Hi, There is a high pitched whirring sound coming from lower part of the vacuum. When I tilt it toward me (while standing in the normal vacuuming stance) the sound sometimes lessens for a minute or so. I have tried the following things: -cleaned the two sponge filters -emptied the dirt receptacle -removed the roller and cleaned it -cleaned the brushes -the belt is not ragged and does not seem floppy -checked all of the airways for clogs (including removing the wheel base) Can you help?

Your looking for some dirt stuck in some thing you didn't check yet. with the roller out and the belt out of the way run it to see if it still makes the noise. if it does then you looking at the impeller or the motor bearing themselfs those bearin ... Bissell 3750 Lift Off Bagless Upright Vacuum

Cannister removal Can't find out how to remove the cannister for cleaning

... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

The dirt is clogged inside the bissel little green 1400-7 hand held cleaning head. How can I unclog? Can the plastic piece be removed asw for the dirt is stuck on the sides of the cleaning handle?

... Bissell 1400 Little Green Pro Canister Steam Vacuum

Which Kenmore vacuum cleaners are made by Panasonic? Are all of their direct drive machines made by Panasonic? We have a blue Hoover Windtunnel with the dirt sensor. It cleans well, but it is unbelievably noisy. I wondered if something was out of place and the brushes were hitting, but everything looks normal. We bought Kenmore models 36722 and 36724 and love them. I believe they were made by Panasonic. Our Kirby sits in the basement. Much heavier. These are quiet and clean well. I would like an

Some Kenmore vacuums are made by Panasonic, some are made by Hoover or Eureka or even Sebo. I would go to a Panasonic dealer for that kind of machine instead of trying to go by the Kenmore brand. Sears has a hard time with service. A good Vacuum C ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a cannister Dirt Devil Easy Lite, I have misplaced the booklet that came with it. My ? is how do I release the cannister to clean out dirt?

Go here > http://dirtdevil.com/file/317/ ... Dirt Devil Easy Lite Quick Vacuum

Kenmore Model 116 Cannister Vacuum.Trying to get into motor area. Think belt is worn out. I have removed the front two screws under the hinged cover, but can not remove cover over motor.. Still attached at rear. No evidence of any more screws to remove.

Under the cordwinder actuator button, are your other two screws. To remove this cover, take a flat tipped screwdriver and , very carefully, find the "tabs" (there are two) both on the front section under the button. Then, Carefully, press them in a ... Vacuums

Kenmore cannister style. Cannot remove the

It depends on the model you have. Do you know the model number? If you need a replacement belt you can get one here:http://www.vacbelts.com/kenmore.htm ... Kenmore Vacuums

Kenmore Quick Clean loud whistling noise from air exchange

... Kenmore 34720 Upright Vacuum

Kenmore quick clean burning smell

Is the belt tight enough? does the brushroll turn easy? ... Kenmore Quick Clean 30012 Vacuum

Dirt doesn't make it to cannister ...it used to have the spin around affect now it just sits there but some dirt is leaving floor....it is in the hose..I have cleaned ALL filters ...YUCK......help

You have a broken belt. Turn the vacuum over and remove cover plate. You will probably find a broken rubber belt. Buy a new belt for your vacuum. Remove the brush , install the new belt with the brush. Put cover plate back on. You are ready to go! ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have a roomba 551. Have cleaned and removed every bit of dirt and hair off it bu the brush cage won't close when the larger bush is put in. The cage will only click locked on one side, and the other side keeps hitting the brush and won't close. It's almost as if the bursh itself is not even, but this doesn't seem to be the case either. I've even tried removing the yellow rings, but makes no difference. Occasionally it runs fine, but most of the time the roomba just hobbles and clacks as i

Hi, had the same problem, it was like the main brush no longer fit into it's slot, so the brush cage would not latch. I discovered that the yellow bearing tip on the main brush twists off, and inside I found a lot of hair twisted around the pin. Th ... Vacuums

It seems to be blowing dirt around not suking but when removing the attachment to clean stairs etc the pipe works fine have washed filteR ? SLIM UPRIGHT DC ALLERGY 18. Have cleaned out filter emptied cylinder taken any bits of cotton or hairs from brushes..........

... Dyson DC07 Bagless Upright Cyclonic Vacuum

Have dirt sensor light on continuously on Kenmore Progressive canister vacuum cleaner...lost manual, do not know where sensors are so can clean them. Could not find answer on the site or from Kenmore. Thanks.

... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

My kenmore vacuum is sucking up the dirt but continously but its not dispersing into the cannister. could it be the filter need to be changed. the dirt is collecting in the hose lines.

Make sure your airway is not plugged and then it maybe the filter sometime just a tooth pick would give you a problem ... Kenmore Cyclonic Action 39259 Vacuum

Dirt is coming out the bottom of my Kenmore Progressive Upright Vacuum. My husband found a large dust bunny in the drive belt and removed it. He also changed the bag. Why is dirt coming out the bottom? Thanks.

Its still clogged, you gotta dig deeper ... Vacuums

No suction I have the central vac type. It has no suction at the can. I pulled the hose going to the walls and tested there...and nothing. I removed the dirt can and checked the motor ...it is spinning but does not feel like any suction. I checked the exhaust and it is pushing strong air out. I also cleaned the filter and still nothing. Is there a relay or something that would cause only exhaust air. I emptied the can of dirt and put it back together and have absolutely no air.....hear the motor

On some units there is a screen that protects the impeller of the motor. If this gets sealed off with debris then it is like putting a potato in the tail pipe of a car. Taking the top off the unit reveals the motor. DO UN-PLUG the unit first from th ... Electrolux Central Vacuum

Model UH60010, Series X12.0, Mfg code K09A. While attempting to use the hose and the extensions to clean shelves, my wife reported no suction. I removed the brush roller and the plastic piece just below where the hose opening is located and saw a "flapper" door that was closed and had some debris sort of jamming it. I removed the debris, but the door requires extreme pressure to open to permit the dirt, etc to moved up thru the opening , through the hose, etc. I thught maybe that somehow tg

Hello,Check to make sure\015\012the dirt canister is empty. If dirt canister is full, then you will \015\012experience\015\012reduced suction. Empty dirt receptacle.\015\012 Could\015\012 be a clogged hose - ... Vacuums

Dirt devil rampage is only working on full cycle and will not change to quick clean

... Dirt Devil Rampage Robotic Pool Cleaner Vacuum

I need a manual on Kenmore Model 116 33720200. I am unable to get the container off that is full of the dirt. How do I remove the container?

... Kenmore Vacuums

Dirt Devil Featherlite - how to remove the beater bar to clean

If you lay it down and look under the base- by the brush roll- there are three screws you have to remove w/ a philips head screwdriver to get the base plate off. From there you can take out the brush roll, etc. ... Dirt Devil Featherlight Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0567 seconds